参数资料
型号: MSC7119VM1200
厂商: Freescale Semiconductor
文件页数: 52/60页
文件大小: 0K
描述: DSP 16BIT W/DDR CTRLR 400-MAPBGA
标准包装: 90
系列: StarCore
类型: 定点
接口: 主机接口,I²C,UART
时钟速率: 300MHz
非易失内存: ROM(8 kB)
芯片上RAM: 464kB
电压 - 输入/输出: 3.30V
电压 - 核心: 1.20V
工作温度: -40°C ~ 105°C
安装类型: 表面贴装
封装/外壳: 400-LFBGA
供应商设备封装: 400-MAPBGA(17x17)
包装: 托盘
MSC7119 Data Sheet, Rev. 8
Hardware Design Considerations
Freescale Semiconductor
56
3.5.3
General Routing
The general routing considerations for the DDR are as follows:
All DDR signals must be routed next to a solid reference:
— For data, next to solid ground planes.
— For address/command, power planes if necessary.
All DDR signals must be impedance controlled. This is system dependent, but typical values are 50–60 ohm.
Minimize other cross-talk opportunities. As possible, maintain at least a four times the trace width spacing between all
DDR signals to non-DDR signals.
Keep the number of vias to a minimum to eliminate additional stubs and capacitance.
Signal group routing priorities are as follows:
— DDR clocks.
— Route MVTT/MVREF.
— Data group.
— Command/address.
Minimize data bit jitter by trace matching.
3.5.4
Routing Clock Distribution
The DDR clock distribution considerations are as follows:
DDR controller supports six clock pairs:
— 2 DIMM modules.
— Up to 36 discrete chips.
For route traces as for any other differential signals:
— Maintain proper difference pair spacing.
— Match pair traces within 25 mm.
Match all clock traces to within 100 mm.
Keep all clocks equally loaded in the system.
Route clocks on inner critical layers.
3.5.5
Data Routing
The DDR data routing considerations are as follows:
Route each data group (8-bits data + DQS + DM) on the same layer. Avoid switching layers within a byte group.
Take care to match trace lengths, which is extremely important.
To make trace matching easier, let adjacent groups be routed on alternate critical layers.
Pin swap bits within a byte group to facilitate routing (discrete case).
Tight trace matching is recommended within the DDR data group. Keep each 8-bit datum and its DM signal within ±
25 mm of its respective strobe.
Minimize lengths across the entire DDR channel:
— Between all groups maintain a delta of no more than 500 mm.
— Allows greater flexibility in the design for readjustments as needed.
DDR data group separation:
— If stack-up allows, keep DDR data groups away from the address and control nets.
— Route address and control on separate critical layers.
— If resistor networks (RNs) are used, attempt to keep data and command lines in separate packages.
相关PDF资料
PDF描述
MSC8101M1500F DSP 16BIT 300MHZ CPM 332-FCPBGA
MSC8101VT1500F IC DSP 16BIT 250MHZ 332-FCPBGA
MSC8103M1200F DSP 16BIT 300MHZ CPM 332-FCPBGA
MSC8103VT1200F IC DSP 16BIT 300MHZ 332-FCPBGA
MSC8112TVT2400V DSP DUAL CORE 431-FCPBGA
相关代理商/技术参数
参数描述
MSC711XADS 功能描述:开发板和工具包 - 其他处理器 DEV SYS FOR FSL 711X DEV RoHS:否 制造商:Freescale Semiconductor 产品:Development Systems 工具用于评估:P3041 核心:e500mc 接口类型:I2C, SPI, USB 工作电源电压:
MSC711XEVM 功能描述:开发板和工具包 - 其他处理器 EVAL KIT W/FULL LIC CW RoHS:否 制造商:Freescale Semiconductor 产品:Development Systems 工具用于评估:P3041 核心:e500mc 接口类型:I2C, SPI, USB 工作电源电压:
MSC711XEVMT 功能描述:KIT EVAL W/FULL LIC CW RoHS:是 类别:编程器,开发系统 >> 过时/停产零件编号 系列:* 标准包装:1 系列:- 传感器类型:CMOS 成像,彩色(RGB) 传感范围:WVGA 接口:I²C 灵敏度:60 fps 电源电压:5.7 V ~ 6.3 V 嵌入式:否 已供物品:成像器板 已用 IC / 零件:KAC-00401 相关产品:4H2099-ND - SENSOR IMAGE WVGA COLOR 48-PQFP4H2094-ND - SENSOR IMAGE WVGA MONO 48-PQFP
MSC7121VRF 制造商:Freescale Semiconductor 功能描述:GPON UMC 140 MHZ - Trays
MSC7128 制造商:OKI 制造商全称:OKI electronic componets 功能描述:5 x 7-Dot Character x 16-Digit Display Controller/Driver