- 您现在的位置：买卖IC网 > PDF目录20189 > PCA85132U/2DA/Q1,0 (NXP Semiconductors)IC LCD DRIVER 32 UNCASED PDF资料下载
参数资料
| 型号： | PCA85132U/2DA/Q1,0 |
| 厂商： | NXP Semiconductors |
| 文件页数： | 11/62页 |
| 文件大小： | 0K |
| 描述： | IC LCD DRIVER 32 UNCASED |
| 标准包装： | 600 |
| 显示器类型： | LCD |
| 配置： | 多重 |
| 接口： | I²C |
| 数字或字符： | 任何数字类型 |
| 电流 - 电源： | 60µA |
| 电源电压： | 1.8 V ~ 5.5 V |
| 工作温度： | -40°C ~ 95°C |
| 封装/外壳： | 模具 |
| 供应商设备封装： | 模具 |
| 包装： | 散装 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页当前第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页
NXP Semiconductors
PCA85132
LCD driver for low multiplex rates
Table 13. Blink frequencies
Assuming that f clk = 1.800 kHz.
f blink = ---------
f blink = ------------
f blink = ------------
Blink mode
off
1
2
3
Operating mode ratio
-
f clk
768
f clk
1536
f clk
3072
Blink frequency
blinking off
~2.34 Hz
~1.17 Hz
~0.59 Hz
An additional feature is for an arbitrary selection of LCD elements to blink. This applies to
the static and 1:2 multiplex drive modes and can be implemented without any
communication overheads: With the output bank selector, the displayed RAM banks are
exchanged (see Section 7.5.4 on page 25 ) with alternate RAM banks at the blink
frequency. This mode can also be specified by the blink-select command (see Table 11 on
In the 1:3 and 1:4 multiplex modes, where no alternate RAM bank is available, groups of
LCD elements can blink selectively by changing the display RAM data at fixed time
intervals.
The entire display can blink at a frequency other than the nominal blinking frequency. This
can be effectively performed by resetting and setting the display enable bit E at the
required rate using the mode-set command (see Table 6 ).
7.2 Power-On Reset (POR)
At power-on, the PCA85132 resets to the following starting conditions:
?
?
?
?
?
?
?
?
All backplane and segment outputs are set to V LCD
The selected drive mode is 1:4 multiplex with 1 ? 3 bias
Blinking is switched off
Input and output bank selectors are reset
The I 2 C-bus interface is initialized
The data pointer and the subaddress counter are cleared (set to logic 0)
The display is disabled (bit E = 0, see Table 6 on page 6 )
If internal oscillator is selected (pin OSC connected to V SS ), then there is no clock
signal on pin CLK
Remark: Do not transfer data on the I 2 C-bus for at least 1 ms after a power-on to allow
the reset action to complete.
7.3 Possible display configurations
The display configurations possible with the PCA85132 depend on the required number of
All of the display configurations given in Table 14 can be implemented in a typical system
PCA85132
Product data sheet
All information provided in this document is subject to legal disclaimers.
Rev. 3 — 11 July 2013
? NXP B.V. 2013. All rights reserved.
11 of 62
相关PDF资料 |
PDF描述 |
|---|---|
| EBC19DREH-S13 | CONN EDGECARD 38POS .100 EXTEND |
| RCC12DRYS | CONN EDGECARD 24POS DIP .100 SLD |
| T86C105K050ESAL | CAP TANT 1UF 50V 10% 2312 |
| R2S8-1209 | CONV DC/DC 2W 12VIN 9VOUT SMD |
| IDT71V416L10BEGI8 | IC SRAM 4MBIT 10NS 48FBGA |
相关代理商/技术参数 |
参数描述 |
|---|---|
| PCA85133 | 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:Universal LCD driver for low multiplex rates |
| PCA85133U/2DA/Q1 | 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:Universal LCD driver for low multiplex rates |
| PCA85133U/2DA/Q1,0 | 功能描述:IC LCD DRIVER UNIV UNCASED RoHS:是 类别:未定义的类别 >> 其它 系列:* 标准包装:1 系列:* 其它名称:MS305720A |
| PCA85133U/2DB/Q1 | 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:Universal LCD driver for low multiplex rates |
| PCA85133U/2DB/Q1,0 | 功能描述:IC LCD DRIVER UNIV UNCASED RoHS:是 类别:未定义的类别 >> 其它 系列:* 标准包装:1 系列:* 其它名称:MS305720A |
发布紧急采购，3分钟左右您将得到回复。