- 您现在的位置：买卖IC网 > PDF目录296796 > PCM9211PT (TEXAS INSTRUMENTS INC) DATACOM, TOKEN RING TRANSCEIVER, PQFP48 PDF资料下载
参数资料
| 型号： | PCM9211PT |
| 厂商： | TEXAS INSTRUMENTS INC |
| 元件分类： | 网络接口 |
| 英文描述： | DATACOM, TOKEN RING TRANSCEIVER, PQFP48 |
| 封装： | GREEN, PLASTIC, LQFP-48 |
| 文件页数： | 30/121页 |
| 文件大小： | 1219K |
| 代理商： | PCM9211PT |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页当前第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页第99页第100页第101页第102页第103页第104页第105页第106页第107页第108页第109页第110页第111页第112页第113页第114页第115页第116页第117页第118页第119页第120页第121页
RST
MODE
V
DD
Tied to V
or DGND
DD
V
= 2.2 V typ
DD
V
= 3.3 V typ
DD
0 V
t
RSTL
SBAS495 – JUNE 2010
www.ti.com
PCM9211 MODULE DESCRIPTIONS
Power Supply
The PCM9211 has four power-supply pins and four ground pins. All ground pins (AGND, AGNDAD, DGND, and
GNDRX) must be connected as closely as possible to the PCM9211. The PCM9211 DVDD and DGND pins are
power-supply pins that support all the onboard digital circuitry for the PCM9211. DVDD should be connected to a
3.3-V supply. DVDD drives the internal power-on reset circuit, making it a startup requirement.
VCC and AGND are analog power-supply power pins that support the DIR analog supply rails.
VDDAD and AGNDAD are dedicated power-supply pins for the onboard ADC. VDDAD should be connected to a
5.0-V power rail.
VDDRX is a dedicated power supply for the coaxial input amplifiers on pins RXIN0 and RXIN1. It should be
connected to a 3.3-V pin. The relative GND pin for this supply is GNDRX. If the coaxial amplifiers are not used
(for example, the application only uses optical inputs), then no power supply is required for the VDDRX.
If the onboard ADC is not used (such as when the application uses an external ADC) then no power supply is
required for the VCCAD pin. This option means that a 5-V rail is not required when the internal ADC is not used.
In such situations, VCCAD should be connected to AGND OR AGNDAD.
Because VCC (3.3 V) is an analog supply (used as part of the power supply for the DIR PLL), care should be
taken to ensure minimum noise and ripple are present. 0.1-mF ceramic capacitors and 10-mF electrolytic
capacitors should be used to decouple each supply pin to the respective relative GND (for example, to decouple
VCCAD and AGNDAD).
Power-Down Function
The PCM9211 has a power-down function that is controlled by the external RST pin or a power control register.
When the RST pin is held at GND, the PCM9211 powers down.
When the device is powered down (that is, RST = GND), all register values are cleared and reset to the
respective default values. By default, all modules are powered on except for the coaxial amplifier.
The other option for powering down the device is to use the Power Control Register (Register 40h). The Power
Control Register allows selective power down of the DIR, ADC, DIT, Coax Amp, and Oscillator circuit without
resetting other registers to the respective default modes.
The advantage of using the registers to power down individual modules of the PCM9211 is that the registers
retain the respective settings rather than resetting to default.
System Reset
The PCM9211 has two sources for reset: the internal power-on reset circuit (hereafter called POR) and the
external reset circuit. See Figure 14 for an illustration of the timing sequence during an internal power-on reset
event. Initialization (reset) is done automatically when VDD exceeds 2.2 V (typ).
When only the onboard POR is to be used, the RST pin should be connected to VDD directly. An external pull-up
resistor should not be used, because the RST pin has an internal pull-down resistor (typ 50 k
Ω). If an external
resistor is used, then the reset is not released. The reset sequence is shown in Figure 11.
Figure 11. Required System Reset Timing
16
Copyright 2010, Texas Instruments Incorporated
Product Folder Link(s): PCM9211
相关PDF资料 |
PDF描述 |
|---|---|
| PCN11MF | STRIP TERMINAL BLOCK, 1 DECK |
| PCN12E-32S-2.54DSA | 32 CONTACT(S), FEMALE, STRAIGHT TWO PART EURO CONNECTOR, SOLDER, SOCKET |
| PCN12E-44S-2.54DSA | 44 CONTACT(S), FEMALE, STRAIGHT TWO PART EURO CONNECTOR, SOLDER, SOCKET |
| PCN12E-50S-2.54DSA | 50 CONTACT(S), FEMALE, STRAIGHT TWO PART EURO CONNECTOR, SOLDER, SOCKET |
| PCR-E68LMD | 68 CONTACT(S), MALE, RIGHT ANGLE TELECOM AND DATACOM CONNECTOR, SOLDER |
相关代理商/技术参数 |
参数描述 |
|---|---|
| PCM9211PTR | 功能描述:音频发送器、接收器、收发器 216kHz Dig Aud Inter face Transceiver RoHS:否 制造商:Cirrus Logic 工作电源电压:3.3 V, 5 V 电源电流:11.8 mA 通道数量:1 最大工作温度:+ 70 C 接口类型:I2C, SPI 安装风格:SMD/SMT 封装 / 箱体:TSSOP-28 封装: |
| PCM-93 | 功能描述:电线鉴定 Pre-Printed WM Card, Vinyl Cloth, .22" W RoHS:否 制造商:TE Connectivity / Q-Cees 产品:Labels and Signs 类型: 材料:Vinyl 颜色:Blue 宽度:0.625 in 长度:1 in |
| PCM-9342 | 制造商:ADVANTECH 制造商全称:Advantech Co., Ltd. 功能描述:X86 SoC 3.5" SBC with VGA, LCD, LAN, USB, SATA, CF, PC/104 |
| PCM-9342F-64A1E | 制造商:ADVANTECH 制造商全称:Advantech Co., Ltd. 功能描述:X86 SoC 3.5" SBC with VGA, LCD, LAN, USB, SATA, CF, PC/104 |
| PCM-9342FZ2-64A1E | 制造商:ADVANTECH 制造商全称:Advantech Co., Ltd. 功能描述:X86 SoC 3.5" SBC with VGA, LCD, LAN, USB, SATA, CF, PC/104 |
发布紧急采购，3分钟左右您将得到回复。