C167CS-4R
C167CS-L
Data Sheet
52
V2.2, 2001-08
Table 10
Current Limits for Port Output Drivers
Port Output Driver
Maximum Output Current
(
IOLmax, -IOHmax)
1)
Nominal Output Current
(
IOLnom, -IOHnom)
P2.7 - P2.0
10 mA
2.5 mA
(PORT0, PORT1,
Port 4, ALE, RD, WR,
BHE, CLKOUT,
RSTOUT, RSTIN2))
-----
2.5 mA
All other outputs
-----
1.6 mA
1) An output current above |I
OXnom| may be drawn from up to three pins (P2.7-P2.0 only) at the same time.
For any group of 16 neighboring port output pins the total output current in each direction (
ΣIOL and/or Σ-IOH)
must remain below 50 mA.
2) Valid for V
OL in bidirectional reset mode only.
Power Consumption C167CS
(Operating Conditions apply)
Parameter
Symbol
Limit Values
Unit Test Condition
min.
max.
Power supply current (active)
with all peripherals active
IDD5
–
20 +
3.2
× fCPU
mA
RSTIN =
VIL
fCPU in [MHz]
1)
1) The supply current is a function of the operating frequency. This dependency is illustrated in Figure 10. These parameters are tested at
VDDmax and maximum CPU clock with all outputs disconnected and all inputs
at
VIL or VIH.
Idle mode supply current
with all peripherals active
IIDX5
2)
2) These values are not 100% tested but verified by means of system characterization.
–
15 +
1.4
× fCPU
mA
RSTIN =
VIH1
Idle mode supply current
with all peripherals deactivated,
PLL off, SDD factor = 32
IIDO
3) This parameter is determined mainly by the current consumed by the oscillator (see Figure 9). This current, however, is influenced by the external oscillator circuitry (crystal, capacitors). The values given refer to a typical
circuitry and may change in case of a not optimized external oscillator circuitry (see also application notes
AP2420: Crystal Oscillator, AP2424: Ceramic Resonator Oscillator).
–
800 +
60
× fOSC
ARSTIN = VIH1
fOSC in [MHz]
Sleep and Power-down mode
supply current with RTC running
–
800 +
30
× fOSC
A
VDD = VDDmax
fOSC in [MHz]
4)
4) This parameter is tested including leakage currents. All inputs (including pins configured as inputs) at 0 V to
0.1 V or at
VDD - 0.1 V to VDD, VREF = 0 V, all outputs (including pins configured as outputs) disconnected.
Sleep and Power-down mode
supply current with RTC disabled
IPDO
–
50
A
VDD = VDDmax