- 您现在的位置：买卖IC网 > PDF目录21886 > SFCF2048H4BK1SA-I-QT-553-SMA (Swissbit NA Inc)FLASH SLC UDMA/MDMA/PIO 2G PDF资料下载
参数资料
| 型号： | SFCF2048H4BK1SA-I-QT-553-SMA |
| 厂商： | Swissbit NA Inc |
| 文件页数： | 15/99页 |
| 文件大小： | 0K |
| 描述： | FLASH SLC UDMA/MDMA/PIO 2G |
| 视频文件： | Swissbit Manufacturing Overview |
| RoHS指令信息： | Environment Protection Declaration |
| 标准包装： | 20 |
| 系列： | C-300 |
| 存储容量： | 2GB |
| 存储器类型： | CompactFlash? |
| 其它名称： | 1052-1010 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页当前第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页第99页
Table 11: Signal Description
Signal Name
Dir.
Pin
Description
These address lines along with the – REG signal are used to
select the following: The I/O port address registers within the
A10 to A0
(PC Card Memory Mode)
I
CompactFlash Storage Card, the memory mapped
port address registers within the CompactFlash Storage Card, a
8,10,11,12, byte in the card ’ s information structure and its
14,15,16,17, configuration control and status registers.
A10 to A0
(PC Card I/O Mode)
A2 to A0
(True IDE Mode)
BVD1
(PC Card Memory Mode)
18,19,20
This signal is the same as the PC Card Memory Mode signal.
In True IDE Mode, only A[2:0] are used to select the one of eight
registers in the Task File, the remaining address lines should be
grounded by the host.
This signal is asserted high, as BVD1 is not supported.
This signal is asserted low to alert the host to changes in the
– STSCHG
(PC Card I/O Mode)
I/O
46
READY and Write Protect states, while the I/O interface is
configured. Its use is controlled by the Card Config and Status
Register.
– PDIAG
(True IDE Mode)
BVD2
(PC Card Memory Mode)
In the True IDE Mode, this input / output is the Pass Diagnostic
signal in the Master / Slave handshake protocol.
This signal is asserted high, as BVD2 is not supported.
– SPKR
(PC Card I/O Mode)
– DASP
(True IDE Mode)
I/O
45
This line is the Binary Audio output from the card. If the Card
does not support the Binary Audio function, this line should be
held negated.
In the True IDE Mode, this input/output is the Disk Active/Slave
Present signal in the Master/Slave handshake protocol.
These lines carry the Data, Commands and Status information
D15-D00 (PC Card Memory Mode)
31, 30, 29, between the host and the controller. D00 is the LSB of the Even
28, 27, 49, Byte of the Word. D08 is the LSB of the Odd Byte of the Word.
D15-D00 (PC Card I/O Mode)
D15-D00 (True IDE Mode)
GND
(PC Card Memory Mode)
I/O
48, 47, 6, This signal is the same as the PC Card Memory Mode signal.
5, 4, 3, 2, In True IDE Mode, all Task File operations occur in byte mode
23, 22, 21 on the low order bus D[7:0] while all data transfers are 16 bit
using D[15:0].
Ground.
GND
(PC Card I/O Mode)
GND
(True IDE Mode)
– INPACK
(PC Card Memory Mode)
1, 50
Same for all modes.
Same for all modes.
This signal is not used in this mode.
The Input Acknowledge signal is asserted by the CompactFlash
– INPACK
(PC Card I/O Mode)
O
43
Storage Card when the card is selected and
responding to an I/O read cycle at the address that is on the
address bus. This signal is used by the host to control the
enable
of any input data buffers between the CompactFlash Storage
Card and the CPU.
Swissbit AG
Industriestrasse 4
Swissbit reserves the right to change products or specifications without notice.
Revision: 1.51
CH-9552 Bronschhofen
Switzerland
www.swissbit.com
industrial@swissbit.com
C-300_data_sheet_CF-HxBK_Rev151.doc
Page 15 of 99
相关PDF资料 |
PDF描述 |
|---|---|
| DK511 | LCD DPM +9V 200MV 3.5 DIGIT -RED |
| SFSD1024N1BN1TO-E-DF-151-STD | FLASH MICRO SD 1G EXT TEMP |
| SFCF1024H4BK1SA-I-DS-553-SMA | FLASH SLC UDMA/MDMA/PIO 1G |
| DK412 | LCD DPM +9V 2V 3.5 DIGIT -GREEN |
| Q2-F-QK4-11-6IN-141 | HEATSHRINK KIT Q2F 141 PCCOLOR |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SFCF2048H4BK2SA-C-DS-553-SMA | 制造商:SWISSBIT NA INC 功能描述:FLASH SLC UDMA/MDMA/PIO 2G |
| SFCF2048H4BK2SA-I-DS-553-SMA | 功能描述:FLASH SLC UDMA/MDMA/PIO 2G RoHS:是 类别:存储卡，模块 >> 存储器，PC 卡 系列:C-300 标准包装:30 系列:- 存储容量:8GB 存储器类型:存储卡 - Extreme III SD? |
| SFCF32GBH1BO4TOINC523SMA | 制造商:Swissbit 功能描述:Flash Card 32G-byte 3.3V/5V CompactFlash 50-Pin |
| SFCF32GBH1BO4TO-I-NC-523-SMA | 功能描述:FLASH SLC UDMA/MDMA/PIO 32G RoHS:是 类别:存储卡，模块 >> 存储器，PC 卡 系列:C-320 标准包装:30 系列:- 存储容量:8GB 存储器类型:存储卡 - Extreme III SD? |
| SFCF32GBH2BU4TO-C-QT-527-STD | 制造商:SWISSBIT 功能描述:CFC C-440 DENSITY COMMERCIAL - Trays 制造商:SWISSBIT NA INC 功能描述:FLASH |
发布紧急采购，3分钟左右您将得到回复。