参数资料
型号: SFCF2048H4BK1SA-I-QT-553-SMA
厂商: Swissbit NA Inc
文件页数: 38/99页
文件大小: 0K
描述: FLASH SLC UDMA/MDMA/PIO 2G
视频文件: Swissbit Manufacturing Overview
RoHS指令信息: Environment Protection Declaration
标准包装: 20
系列: C-300
存储容量: 2GB
存储器类型: CompactFlash?
其它名称: 1052-1010
j)
k)
l)
m)
n)
o)
p)
If the host has not placed the result of its CRC calculation on D[15:00] since first driving D[15:00] during
(9), the host shall place the result of its CRC calculation on D[15:00] (see 6.5.4.5 ).
The host shall negate – DMACK no sooner than t MLI after the device has asserted DSTROBE and negated
DMARQ and the host has asserted STOP and negated – HDMARDY, and no sooner than t DVS after the host
places the result of its CRC calculation on D[15:00].
The device shall latch the host’s CRC data from D[15:00] on the negating edge of – DMACK.
The device shall compare the CRC data received from the host with the results of its own CRC calculation. If
a miscompare error occurs during one or more Ultra DMA burst for any one command, at the end of the
command, the device shall report the first error that occurred (see 6.5.4.5 ).
The device shall release DSTROBE within t IORDYZ after the host negates – DMACK.
The host shall neither negate STOP nor assert – HDMARDY until at least t ACK after the host has negated –
DMACK.
The host shall not assert – IORD, -CS0, -CS1, DA2, DA1, or DA0 until at least t ACK after negating DMACK.
Figure 14: Ultra DMA Data-In Burst Host Termination Timing
Notes: The definitions for the STOP, HDMARDY, and DSTROBE signal lines are no longer in effect after
DMARQ and DMACK are negated.
6.5.4.4.6 Initiating an Ultra DMA Data-Out Burst
An Ultra DMA Data-out burst is initiated by following the steps lettered below. The timing diagram
is shown in Figure 15: Ultra DMA Data-Out Burst Initiation Timing. The timing parameters are
specified in Table 26: Ultra DMA Data Burst Timing Requirements and are described in Table 27: Ultra DMA Data
The following steps shall occur in the order they are listed unless otherwise specifically allowed:
a) The host shall keep – DMACK in the negated state before an Ultra DMA burst is initiated.
b) The device shall assert DMARQ to initiate an Ultra DMA burst.
c)
Steps I, (d), and (e) may occur in any order or at the same time. The host shall assert STOP.
d) The host shall assert HSTROBE.
Swissbit AG
Industriestrasse 4
Swissbit reserves the right to change products or specifications without notice.
Revision: 1.51
CH-9552 Bronschhofen
Switzerland
www.swissbit.com
industrial@swissbit.com
C-300_data_sheet_CF-HxBK_Rev151.doc
Page 38 of 99
相关PDF资料
PDF描述
DK511 LCD DPM +9V 200MV 3.5 DIGIT -RED
SFSD1024N1BN1TO-E-DF-151-STD FLASH MICRO SD 1G EXT TEMP
SFCF1024H4BK1SA-I-DS-553-SMA FLASH SLC UDMA/MDMA/PIO 1G
DK412 LCD DPM +9V 2V 3.5 DIGIT -GREEN
Q2-F-QK4-11-6IN-141 HEATSHRINK KIT Q2F 141 PCCOLOR
相关代理商/技术参数
参数描述
SFCF2048H4BK2SA-C-DS-553-SMA 制造商:SWISSBIT NA INC 功能描述:FLASH SLC UDMA/MDMA/PIO 2G
SFCF2048H4BK2SA-I-DS-553-SMA 功能描述:FLASH SLC UDMA/MDMA/PIO 2G RoHS:是 类别:存储卡,模块 >> 存储器,PC 卡 系列:C-300 标准包装:30 系列:- 存储容量:8GB 存储器类型:存储卡 - Extreme III SD?
SFCF32GBH1BO4TOINC523SMA 制造商:Swissbit 功能描述:Flash Card 32G-byte 3.3V/5V CompactFlash 50-Pin
SFCF32GBH1BO4TO-I-NC-523-SMA 功能描述:FLASH SLC UDMA/MDMA/PIO 32G RoHS:是 类别:存储卡,模块 >> 存储器,PC 卡 系列:C-320 标准包装:30 系列:- 存储容量:8GB 存储器类型:存储卡 - Extreme III SD?
SFCF32GBH2BU4TO-C-QT-527-STD 制造商:SWISSBIT 功能描述:CFC C-440 DENSITY COMMERCIAL - Trays 制造商:SWISSBIT NA INC 功能描述:FLASH