参数资料
型号: SFCF2048H4BK1SA-I-QT-553-SMA
厂商: Swissbit NA Inc
文件页数: 57/99页
文件大小: 0K
描述: FLASH SLC UDMA/MDMA/PIO 2G
视频文件: Swissbit Manufacturing Overview
RoHS指令信息: Environment Protection Declaration
标准包装: 20
系列: C-300
存储容量: 2GB
存储器类型: CompactFlash?
其它名称: 1052-1010
9.9.5 Bit 3 (DRQ)
The Data Request is set when the Card requires information be transferred either to or from the host through the
Data register. The bit is cleared by the next command.
9.9.6 Bit 2 (CORR)
This bit is set when a Correctable data error has been encountered and the data has been corrected. This
condition does not terminate a multi-sector read operation.
9.9.7 Bit 1 (IDX)
This bit is always set to ‘0’.
9.9.8 Bit 0 (ERR)
This bit is set when the previous command has ended in some type of error. The bits in the Error register contain
additional information describing the error. In case of read or write access commands that end with an error, the
address of the first sector with an error is in the command block registers. This bit is cleared by the next
command.
Table 52: Status & Alternate Status Register
D7
BUSY
D6
RDY
D5
DWF
D4
DSC
D3
DRQ
D2
CORR
D1
0
D0
ERR
9.10 Device Control Register
The Device Control register is located at address 3F6h [376h], offset Eh.
This Write-only register is used to control the CompactFlash Memory Card interrupt request and to issue an ATA
soft reset to the Card. This register can be written even if the device is BUSY. The bits are defined as follows:
9.10.1 Bit 7 to 3
Don’t care. The host should reset this bit to ‘0’.
9.10.2 Bit 2 (SW Rst)
This bit is set to 1 in order to force the CompactFlash Storage Card to perform an AT Disk controller Soft Reset
operation. This clears Status Register and writes Diagnostic Code in Error register after a Write or Read Sector error.
The Card remains in Reset until this bit is re set to ‘0.’
9.10.3 Bit 1 (-Ien)
When the Interrupt Enable bit is set to ‘0’, - IREQ interrupts are enabled. When the bit is set to ‘1’, interrupts from
the Card are disabled. This bit also controls the Int bit in the Card Configuration and Status Register. It is s et to ‘0’
at Power On.
9.10.4 Bit 0
This bit is set to ‘0’.
Table 53: Device Control Register
D7
X(0)
D6
X(0)
D5
X(0)
D4
X(0)
D3
X(0)
D2
SW Rst
D1
-Ien
D0
0
9.11 Card (Drive) Address Register
The Card (Drive) Address register is located at address 3F7h [377h], offset Fh.
This read-only register is provided for compatibility with the AT disk drive interface and can be used for
confirming the drive status. It is recommended that this register is not mapped into the host’s I/O space because
of potential conflicts on Bit 7. The bits are defined as follows:
9.11.1 Bit 7
This bit is don’t care.
Swissbit AG
Industriestrasse 4
Swissbit reserves the right to change products or specifications without notice.
Revision: 1.51
CH-9552 Bronschhofen
Switzerland
www.swissbit.com
industrial@swissbit.com
C-300_data_sheet_CF-HxBK_Rev151.doc
Page 57 of 99
相关PDF资料
PDF描述
DK511 LCD DPM +9V 200MV 3.5 DIGIT -RED
SFSD1024N1BN1TO-E-DF-151-STD FLASH MICRO SD 1G EXT TEMP
SFCF1024H4BK1SA-I-DS-553-SMA FLASH SLC UDMA/MDMA/PIO 1G
DK412 LCD DPM +9V 2V 3.5 DIGIT -GREEN
Q2-F-QK4-11-6IN-141 HEATSHRINK KIT Q2F 141 PCCOLOR
相关代理商/技术参数
参数描述
SFCF2048H4BK2SA-C-DS-553-SMA 制造商:SWISSBIT NA INC 功能描述:FLASH SLC UDMA/MDMA/PIO 2G
SFCF2048H4BK2SA-I-DS-553-SMA 功能描述:FLASH SLC UDMA/MDMA/PIO 2G RoHS:是 类别:存储卡,模块 >> 存储器,PC 卡 系列:C-300 标准包装:30 系列:- 存储容量:8GB 存储器类型:存储卡 - Extreme III SD?
SFCF32GBH1BO4TOINC523SMA 制造商:Swissbit 功能描述:Flash Card 32G-byte 3.3V/5V CompactFlash 50-Pin
SFCF32GBH1BO4TO-I-NC-523-SMA 功能描述:FLASH SLC UDMA/MDMA/PIO 32G RoHS:是 类别:存储卡,模块 >> 存储器,PC 卡 系列:C-320 标准包装:30 系列:- 存储容量:8GB 存储器类型:存储卡 - Extreme III SD?
SFCF32GBH2BU4TO-C-QT-527-STD 制造商:SWISSBIT 功能描述:CFC C-440 DENSITY COMMERCIAL - Trays 制造商:SWISSBIT NA INC 功能描述:FLASH