4
REQUIREMENTS
4.1
GENERAL
The complete requirements for procurement of the integrated circuits specified herein are
stated in this specification and ESA / SCC Generic Specification N° 9000 for Integrated
Circuits. Deviations from the generic specification applicable to this specification
only, are
listed in Par.4 . 2.
Deviations from applicable Generic Specifications and this
Detail Specification, formally agreed
with specific manufacturers on the basis that the alternative requirements are equivalent to
ESA / SCC requirements and do not affect the components reliability, are listed in the
appendices attached to this specification.
4.1.1
Deviation from Applicable Specifications other than ESA/SCC N°9000
None
4.2
DEVIATIONS FROM ESA / SCC GENERIC SPECIFICATION N° 9000
4.2.1
Deviations from Special In-Process Controls
None
4.2.2
Deviation from Final Production Tests (Chart II)
None
4.2.3
Deviations from Burn-in Tests(Chart III)
High Temperature Reverse Bias (HTRB) shall not be performed.
4.2.4
Deviations from Qualification, Environmental and Endurance Test
(Chart IV)
None.
4.2.5
Deviations from Lot Acceptance Tests(Chart V)
None
4.3
MECHANICAL REQUIREMENTS
4.3.1
Dimension Check
The dimension of the integrated circuit specified herein shall be checked . They shall conform
to those shown in Figure 2.
4.3.2
Weight
The maximum weight of the integrated circuits specified herein shall be 3.0
grams.
4.4
MATERIAL AND FINISHES
The materials and finishes shall be as specified herein. Where a definite material is not
specified, a material which will enable the integrated circuits specified herein to meet the
performance requirements of this specification shall be used. Acceptance or approval of any
constituent material does not guarantee acceptance of the finished product.
Document number
MHS/SCC 021
Date
Issue
Page
23/12/1999
Rev C
20
Rev C
20 /42
TEMI C
Semiconductors