- 您现在的位置：买卖IC网 > PDF目录98142 > SST89V516RD-33-C-PI (SILICON STORAGE TECHNOLOGY INC) 8-BIT, FLASH, 33 MHz, MICROCONTROLLER, PDIP40 PDF资料下载
参数资料
| 型号： | SST89V516RD-33-C-PI |
| 厂商： | SILICON STORAGE TECHNOLOGY INC |
| 元件分类： | 微控制器/微处理器 |
| 英文描述： | 8-BIT, FLASH, 33 MHz, MICROCONTROLLER, PDIP40 |
| 封装： | PLASTIC, MS-011AC, DIP-40 |
| 文件页数： | 50/80页 |
| 文件大小： | 934K |
| 代理商： | SST89V516RD-33-C-PI |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页当前第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页
54
Data Sheet
FlashFlex51 MCU
SST89E516RD2 / SST89E516RD
SST89V516RD2 / SST89V516RD
2005 Silicon Storage Technology, Inc.
S71273-01-000
3/05
8.3.5 Watchdog Timer
The Watchdog Timer mode is used to improve reliability in
the system without increasing chip count (See Figure 8-6).
Watchdog Timers are useful for systems that are suscepti-
ble to noise, power glitches, or electrostatic discharge. It
can also be used to prevent a software deadlock. If during
the execution of the user’s code, there is a deadlock, the
Watchdog Timer will time out and an internal reset will
occur. Only module 4 can be programmed as a Watchdog
Timer (but still can be programmed to other modes if the
Watchdog Timer is not used).
To use the Watchdog Timer, the user pre-loads a 16-bit
value in the compare register. Just like the other compare
modes, this 16-bit value is compared to the PCA timer
value. If a match is allowed to occur, an internal reset will be
generated. This will not cause the RST pin to be driven high.
In order to hold off the reset, the user has three options:
1. periodically change the compare value so it will
never match the PCA timer,
2. periodically change the PCA timer value so it will
never match the compare values, or
3. disable the watchdog timer by clearing the WDTE
bit before a match occurs and then re-enable it.
The first two options are more reliable because the Watch-
dog Timer is never disabled as in option #3. If the program
counter ever goes astray, a match will eventually occur and
cause an internal reset. The second option is also not rec-
ommended if other PCA modules are being used. Remem-
ber, the PCA timer is the time base for all modules;
changing the time base for other modules would not be a
good idea. Thus, in most application the first solution is the
best option.
Use the code below to initialize the Watchdog Timer. Mod-
ule 4 can be configured in either compare mode, and the
WDTE bit in CMOD must also be set. The user’s software
then must periodically change (CCAP4H, CCAP4L) to
keep a match from occurring with the PCA timer (CH, CL).
This code is given in the Watchdog routine below.
;==============================================
Init_Watchdog:
MOVCCAPM4, #4CH; Module 4 in compare mode
MOVCCAP4L, #0FFH; Write to low byte first
MOVCCAP4H, #0FFH; Before PCA timer counts up
; to FFFF Hex, these compare
; values must be changed.
ORLCMOD, #40H; Set the WDTE bit to enable the
; watchdog timer without
; changing the other bits in
; CMOD
;==============================================
;Main program goes here, but call WATCHDOG periodically.
;==============================================
WATCHDOG:
CLR EA; Hold off interrupts
MOVCCAP4L, #00; Next compare value is within
MOVCCAP4H, CH; 65,535 counts of the
; current PCA
SETBEA; timer value
RET
;==============================================
This routine should not be part of an interrupt service rou-
tine. If the program counter goes astray and gets stuck in an
infinite loop, interrupts will still be serviced and the watchdog
will keep getting reset. Thus, the purpose of the watchdog
would be defeated. Instead, call this subroutine from the
main program of the PCA timer.
FIGURE
8-6: PCA WATCHDOG TIMER (MODULE 4 ONLY)
1273 F25.0
CIDL
WDTE
CPS1
CPS0
ECF
ECOMn CAPPn CAPNn MATn
TOGn PWMn ECCFn
CMOD
CCAPM4
Reset
CH
CL
CCAP4H
CCAP4L
PCA Timer/Counter
0
X
0
16-bit Comparator
Reset
Write to
CCAP4L
Write to
CCAP4H
1
0
Enable
Match
Module 4
1
X
相关PDF资料 |
PDF描述 |
|---|---|
| SST89V516RD-33-I-PIE | 8-BIT, FLASH, 33 MHz, MICROCONTROLLER, PDIP40 |
| SST89E516RD-40-I-PIE | 8-BIT, FLASH, 40 MHz, MICROCONTROLLER, PDIP40 |
| SST89V554A-33-C-TQJ | 8-BIT, FLASH, 33 MHz, MICROCONTROLLER, PQFP44 |
| SST89E554A-40-C-NJ | 8-BIT, FLASH, 40 MHz, MICROCONTROLLER, PQCC44 |
| SST89E554A-40-I-TQJ | 8-BIT, FLASH, 40 MHz, MICROCONTROLLER, PQFP44 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SST89V516RD-33-C-PIE | 功能描述:8位微控制器 -MCU 8-Bit 64K+8K Flash 33MHz 3/16-Bit Timer RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT |
| SST89V516RD-33-C-QIF | 制造商:SST 制造商全称:Silicon Storage Technology, Inc 功能描述:FlashFlex MCU |
| SST89V516RD-33-I-QIF | 制造商:SST 制造商全称:Silicon Storage Technology, Inc 功能描述:FlashFlex MCU |
| SST89V52RD2 | 制造商:SST 制造商全称:Silicon Storage Technology, Inc 功能描述:FlashFlex51 MCU |
| SST89V52RD2/RD | 制造商:SST 制造商全称:Silicon Storage Technology, Inc 功能描述:FlashFlex51 MCU |
发布紧急采购，3分钟左右您将得到回复。