参数资料
型号: ST52T301P
厂商: 意法半导体
英文描述: 8-Bit OTP/EPROM DuaLogic] MCUs WITH ADC, UART, TIMER, TRIAC & PWM DRIVER
中文描述: 8位检察官办公室/存储器DuaLogic]与艺术发展局和UART,定时器,可控硅控制器
文件页数: 47/100页
文件大小: 497K
代理商: ST52T301P
10.1PWMGENERATOR WORKINGMODE
When REG_CONF10 (3:2) bits, MODE, are ”01”,
the peripheral is programmed to work in PWM
Mode.
Byusing the 16-bitprescaler,the PWMperiod can
be generatedbydividingthe internalmasterclock,
or an external clock signal applied on the pin
MAIN1,or themainvoltagefrequency,byusingthe
circuit shownin Figure 10.6.
NOTE: The external clock signal, applied on
MAIN1pin,musthaveafrequencyatleastthree
timesmaller than the internal master clock.
The clock source can be selected by using
REG_CONF10(5:4)bits,CKSL(seeTable10.4and
Figure10.9).If the clock source selectedis not the
mainvoltagefrequency(CKSL=1x),MAIN2pincan
be configured as input or output, by using
REG_CONF10(7)bit, IOSL (see Table10.4).
If MAIN2 is an output, on this pin it is possible to
get the prescaleroutput signal Tck.
The period of the PWM signal is obtainedbyusing
the following relation:
T=256*Tck
where Tck is the output of the 16-bit prescaler
managedbyREG_CONF8andREG_CONF9(see
Figure10.2).
NOTE. In PWM working mode, the value N,
stored in the 16-bit prescaler, must be in the
range from 2 to 2
16
-1
By using a 20 MHz clock master it is possible to
obtain a PWM frequency in the range 1.2 Hz to
26.04 KHz.
The value Ton is proportional to a value,
INIT_VALUE,thatcan be a fuzzyoutput or a value
Value
Description
01
PWM Driver
10
Burst Mode Control
(1)
11
Phase Angle Control
Note:
(1)
REG_CONF10(5) must be set to ”1”
Table10.1.MODE- Triac/PWMWorkingMode
Settings
MCLK
Frequency
1/
T
min
0.3Hz
max
6.51 kHz
5 MHz
10 MHz
20 MHz
0.6 Hz
1.2 Hz
13.02 kHz
26.04 kHz
Table10.2. PWM Frequencies
T = 256 * Tck
Ton= INIT_VALUE*Tck
Toff
TRIACOUT
Figure10.3.PWM Functionament
coming from Register File, according with the
INPSL and FZSL configuration bits of
REG_CONF12(see Table10.6 and Figure 10.12).
The Ton is equal to:
Ton=INIT_VALUE*Tck.
It means the Ton can be fixed by the control
algorithm that can be either the output of a fuzzy
inferenceor the result of an arithmeticcalculus.In
thesecondcase,thedata,storedinthei-thlocation
of the Register File, can be loaded by using the
instruction:
LDPR 1, reg-i
.
If the INIT_VALUEis 255 the Toffis equalto Tck.
47/99
ST52T301/E301
相关PDF资料
PDF描述
ST5451D ISDN HDLC AND GCI CONTROLLER
ST5481 L.O.U.I.S - LOW COST USB ISDN SOLUTION
ST5481TQF7 L.O.U.I.S - LOW COST USB ISDN SOLUTION
ST5x86 100 and 120 MHz 3.45 Volt 5x86 CPU(微处理器)
ST62 SERIES 8-Bit OTP/EPROM MCUs with A/D Converter, Oscilator Safeguard, Safe Reset and 20 Pins(8位OTP/EPROM微控制器(8M))
相关代理商/技术参数
参数描述
ST52T400 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:8-BIT INTELLIGENT CONTROLLER UNIT ICU Timer/PWM, Analog Comparator, Triac/PWM Timer, WDG
ST52T400F0B6 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:8-BIT INTELLIGENT CONTROLLER UNIT ICU Timer/PWM, Analog Comparator, Triac/PWM Timer, WDG
ST52T400F0M6 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:8-BIT INTELLIGENT CONTROLLER UNIT ICU Timer/PWM, Analog Comparator, Triac/PWM Timer, WDG
ST52T400F1B6 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:8-BIT INTELLIGENT CONTROLLER UNIT ICU Timer/PWM, Analog Comparator, Triac/PWM Timer, WDG
ST52T400F1M6 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:8-BIT INTELLIGENT CONTROLLER UNIT ICU Timer/PWM, Analog Comparator, Triac/PWM Timer, WDG