- 您现在的位置：买卖IC网 > PDF目录85413 > TDA8960HB (NXP SEMICONDUCTORS) SPECIALTY CONSUMER CIRCUIT, PQFP64 PDF资料下载
参数资料
| 型号： | TDA8960HB |
| 厂商： | NXP SEMICONDUCTORS |
| 元件分类： | 消费家电 |
| 英文描述： | SPECIALTY CONSUMER CIRCUIT, PQFP64 |
| 封装： | PLASTIC, SOT-319, QFP-64 |
| 文件页数： | 6/36页 |
| 文件大小： | 203K |
| 代理商： | TDA8960HB |
第1页第2页第3页第4页第5页当前第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页
1999 Jun 14
14
Philips Semiconductors
Preliminary specication
ATSC 8-VSB demodulator and decoder
TDA8960
The DATACLK signal is the 5.38 MHz demodulator output
clock. It is derived from the system clock of 21.52 MHz.
A few remarks can be made about the DATACLK signal:
If a reset is applied, DATACLK becomes LOW; it
remains LOW until reset is released and the symbol
timing recovery block has detected the synchronization
signals
After a channel change the DATACLK signal stops; it
starts again after the system has been locked on to a
valid signal
If the Reed Solomon decoder produces an invalid
transport packet and the ERROR signal is asserted the
DATACLK signal continues to change state
If the sync recovery block is not able to detect the field
sync or data segment sync, DATACLK will not change.
The DATAVALID signal indicates valid demodulator output
data or one valid MPEG-2 transport packet. It is active
HIGH for 188 bytes, or 34.9
s. The zero bytes to be sent
after the 188 valid bytes of the transport packet can be
considered to be zeroed parity bytes.
SOP or start of packet signal is HIGH during the first byte
of the packet.
The ERROR signal indicates that the transport packet
contains uncorrectable output. The ERROR signal
becomes HIGH in the following situations:
If the Reed Solomon decoder is unable to correct all
errors in a transport packet
After a reset has been applied, the ERROR signal is
asserted; it remains HIGH until a valid transport packet
is produced by the demodulator
If the demodulator is out of sync, thus can not detect the
field sync and segment sync in the incoming data
stream.
The ERROR signal can be asserted in the middle of a
transport packet.
Sync byte and transport error indicator
The structure of a transport packet header is shown in
Fig.6. For the VSB demodulator only the first two bytes of
the so called transport packet header are important.
The first byte in each header of a transport packet is the so
called MPEG-2 packet synchronization byte (sync byte).
As specified in the MPEG-2 standard, this sync byte must
have the same value for all packets. The VSB demodulator
IC sets this byte for each outgoing transport packet to 47H.
The MSB of the second byte in the transport packet is the
transport_error_indicator bit. It indicates that the Reed
Solomon decoder was not able to correct all errors and the
transport packet has invalid data.
Fig.6 The structure of a transport packet header.
handbook, full pagewidth
MGR605
payload
(if present)
adaptation field
(if present)
0
MSB
sync byte
transport_error_indicator
transport packet header
1st byte
4th byte
1
0
1
LSB
188 bytes
相关PDF资料 |
PDF描述 |
|---|---|
| TDA8315T/N3 | COLOR SIGNAL DECODER, PDSO24 |
| TDA8315TD-G | COLOR SIGNAL DECODER, PDSO24 |
| TA8601BN | SPECIALTY CONSUMER CIRCUIT, PDIP36 |
| TA8631N | SPECIALTY CONSUMER CIRCUIT, PDIP30 |
| TDA6405ATS/C1 | VIDEO TUNER, PDSO28 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TDA8961 | 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:ATSC/NTSC digital TV front-end chipset |
| TDA8980 | 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:ATSC/NTSC digital TV front-end chipset |
| TDA9032 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:tda9032 |
| TDA9045 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:VIDEO PROCESSOR AND INPUT SELECTOR |
| TDA9102 | 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:H/V PROCESSOR FOR TTL V.D.U |
发布紧急采购，3分钟左右您将得到回复。