参数资料
| 型号： | TISP61089BDR |
| 厂商： | Bourns Inc. |
| 文件页数： | 15/20页 |
| 文件大小： | 0K |
| 描述： | SURGE SUPP SLIC PROG HV 8-SOP |
| 标准包装： | 2,500 |
| 电压 - 击穿： | 64V |
| 电压 - 断路： | 170V |
| 电流 - 峰值脉冲(10 x 1000µs)： | 30A |
| 电流 - 保持 (Ih)： | 150mA |
| 元件数： | 2 |
| 电容： | 100pF |
| 封装/外壳： | 8-SOIC（0.154"，3.90mm 宽） |
| 包装： | 带卷 (TR) |
TISP61089B High Voltage Ringing SLIC Protector
‘1089 Section 4.5.11 - Current-Limiting Protector Testing (Continued)
The test generator has a voltage source that can be varied from zero to 600 V rms and an output resistance of 20 ? to each conductor. Table 4
shows the range of currents conducted by the TISP61089B.
Table 4. Wiring Simulator Testing
AC Duration
s
Open-Circuit
RMS Voltage
V
Short-Circuit
RMS Current
A
Test
Connections
Primary
Fitted
Source
Resistance
?
TISP61089B I TM
A (peak)
R s = 25 ? R s = 40 ?
900
0 to 600
0 to 30
Transverse & Longitudinal
No
20
0 to 2x 19
0 to 2x 14
‘1089 Section 4.5.12 - First-Level Power Fault Testing
Table 5 shows the nine tests used for this section. The TISP61089B will survive these peak current values as they are lower than the
TISP61089B current-time ratings.
Table 5. First-Level Power Fault Currents
Test
#
AC Duration
s
Open-circuit
RMS Voltage
V
Short-circuit
RMS Current
A
No
of
Tests
Test
Connections
Primary
Fitted
Source
Resistance
?
TISP61089B I TM
A (peak)
R s = 25 ? R s = 40 ?
1
2
3
4
5
6
7
8
9
900
900
1
1
5
30
2
1
0.5
50
100
200
400
600
1000
600
600
600
600
1000
0.33
0.17
0.33
0.67
1.00
1
0.09
0.5
2.2
3.0
5
1
1
60
60
60
60
60
1
1
1
1
Transverse &
Longitudinal
Transverse &
Longitudinal
Transverse &
Longitudinal
Longitudinal
Differential
Transverse &
Longitudinal
Transverse &
Longitudinal
Transverse &
Longitudinal
Longitudinal
No
No
No
Yes
No
No
No
No
Yes
150
600
600
1000
Capacitive
1200
273
200
200
2x0.40
2x0.23
2x0.45
2x0.90
2x1.36
2x1.38
2x0.12
2x0.69
2x2.85
2x3.77
2x6.28
2x0.37
2x0.22
2x0.44
2x0.89
2x1.33
2x1.30
2x0.12
2x0.68
2x2.71
2x3.54
2x5.89
NOTES: 1. If the equipment contains a voltage-limiting device or a current-limiting device, tests 1, 2 and 3 are repeated at a level just below
the thresholds of the limiting devices.
2. Test 5 uses a special circuit with transformer coupled a.c. and capacitive feed.
3. Tests 1 through 5 are requirements and the equipment shall not be damaged after these tests.
4. Tests 6 through 9 are desirable objectives and the equipment can be damaged after these tests.
‘1089 Section 4.5.13 - Second-Level Power Fault Testing for Central Office Equipment
Table 6 shows the five tests used for this section. Columns 9 and 10 show the prospective currents for these tests using R S values of 25 ? and
40 ? . The two most stressful tests of this section are test 1 and test 2. As shown in Table 6, the peak currents for these tests are 2x17 A and
2x7.7 A respectively. With the exception of test 5, all the other tests require the series overcurrent protection to operate before the TISP61089B
current-time ratings are exceeded. In the case of test 2, with an R S of 25 ? , the overcurrent protection must operate within the initial a.c. half
cycle to prevent damage.
OCTOBER 2000 - REVISED JULY 2008
Specifications are subject to change without notice.
Customers should verify actual device performance in their specific applications.
相关PDF资料 |
PDF描述 |
|---|---|
| TISP61089BSDR-S | PROTECTOR QUAD PROGRAMMABLE |
| TISP61089HDMR-S | SURGE PROT THYRIST 155V SLIC |
| TISP61089QDR-S | PROTECTOR PROGRAMMABLE SLIC |
| TISP61089SDR-S | PROTECTOR OVER VOLTAGE |
| TISP6NTP2ADR | SURGE SUPP QUAD PROG SOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TISP61089BDR-S | 功能描述:SCR Dual P Gate Forward Conducting RoHS:否 制造商:STMicroelectronics 最大转折电流 IBO:480 A 额定重复关闭状态电压 VDRM:600 V 关闭状态漏泄电流（在 VDRM IDRM 下）:5 uA 开启状态 RMS 电流 (It RMS): 正向电压下降:1.6 V 栅触发电压 (Vgt):1.3 V 最大栅极峰值反向电压:5 V 栅触发电流 (Igt):35 mA 保持电流（Ih 最大值）:75 mA 安装风格:Through Hole 封装 / 箱体:TO-220 封装:Tube |
| TISP61089BDR-T | 功能描述:SCR PROTECTOR - PROGRAMMABLE SLIC PROTECT RoHS:否 制造商:STMicroelectronics 最大转折电流 IBO:480 A 额定重复关闭状态电压 VDRM:600 V 关闭状态漏泄电流（在 VDRM IDRM 下）:5 uA 开启状态 RMS 电流 (It RMS): 正向电压下降:1.6 V 栅触发电压 (Vgt):1.3 V 最大栅极峰值反向电压:5 V 栅触发电流 (Igt):35 mA 保持电流（Ih 最大值）:75 mA 安装风格:Through Hole 封装 / 箱体:TO-220 封装:Tube |
| TISP61089BDS | 制造商:Bourns Inc 功能描述: |
| TISP61089BD-S | 功能描述:SCR Dual P Gate Forward Conducting RoHS:否 制造商:STMicroelectronics 最大转折电流 IBO:480 A 额定重复关闭状态电压 VDRM:600 V 关闭状态漏泄电流（在 VDRM IDRM 下）:5 uA 开启状态 RMS 电流 (It RMS): 正向电压下降:1.6 V 栅触发电压 (Vgt):1.3 V 最大栅极峰值反向电压:5 V 栅触发电流 (Igt):35 mA 保持电流（Ih 最大值）:75 mA 安装风格:Through Hole 封装 / 箱体:TO-220 封装:Tube |
| TISP61089BGDR-S | 功能描述:PROTECTOR PROGRAMMABLE SLIC RoHS:是 类别:过电压，电流，温度装置 >> TVS - 晶闸管 系列:- 产品变化通告:Product Discontinuation 19/Jul/2012 标准包装:2,500 系列:- 电压 - 击穿:400V 电压 - 断路:320V 电压 - 导通状态:4V 电流 - 峰值脉冲(8 x 20µs):250A 电流 - 峰值脉冲(10 x 1000µs):80A 电流 - 保持 (Ih):150mA 元件数:1 电容:29pF 封装/外壳:DO-214AA，SMB 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。