- 您现在的位置：买卖IC网 > PDF目录136952 > TPS24713DGSR (TEXAS INSTRUMENTS INC) POWER SUPPLY SUPPORT CKT, PDSO10 PDF资料下载
参数资料
| 型号： | TPS24713DGSR |
| 厂商： | TEXAS INSTRUMENTS INC |
| 元件分类： | 电源管理 |
| 英文描述： | POWER SUPPLY SUPPORT CKT, PDSO10 |
| 封装： | GREEN, PLASTIC, MSOP-10 |
| 文件页数： | 7/34页 |
| 文件大小： | 2148K |
| 代理商： | TPS24713DGSR |
第1页第2页第3页第4页第5页第6页当前第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页
SLVSAL2C
– JANUARY 2011 – REVISED MAY 2011
Figure 26. Inrush Mode at Hot-Swap Circuit Insertion
INRUSH OPERATION
When the TPS24710/11/12/13 activates the pass MOSFET, M1, a current flows into the downstream bulk storage
capacitors. When this current exceeds the limit set by the power limit engine, the gate of the MOSFET is
regulated by a feedback loop to make the MOSFET current rise in a controlled manner. This not only limits the
inrush current charging capacitance but it also limits the power dissipation of the MOSFET to safe levels. A more
complete explanation of the power limiting scheme is given in the section entitled Action of the Constant Power
Engine. At the instant when the current in RSENSE reaches the programmed limit, the TIMER pin begins to charge
the timing capacitor CT with a current of approximately 10 μA. The TIMER pin continues to charge CT until
V(GATE – VCC) reaches the timer activation voltage (6 V for VVCC = 12 V). The TIMER then begins to discharge CT
with a current of approximately 10
μA. This indicates that the inrush mode is finished. If the TIMER exceeds its
upper threshold of 1.35 V before V(GATE – VCC) reaches the timer activation voltage, the GATE pin is pulled to
GND and the hot-swap circuit enters either latch mode (TPS24710/12) or auto-retry mode (TPS24711/13).
The power limit feature is disabled once the inrush operation is finished and the hotswap circuit becomes a
circuit breaker. The TPS24710/11/12/13 will turn off the MOSFET, M1, after a fault timer period once the load
exceeds the current limit threshold.
ACTION OF THE CONSTANT-POWER ENGINE
Figure 27 illustrates the operation of the constant-power engine during start-up. The circuit used to generate the
waveforms of Figure 27 was programmed to a power limit of 29.3 W by means of the resistor connected between
PROG and GND. At the moment current begins to flow through the MOSFET, a voltage of 12 V appears across
it (input voltage VVCC = 12 V), and the constant-power engine therefore allows a current of 2.44 A (equal to 29.3
W divided by 12 V) to flow. This current increases in inverse ratio as the drain-to-source voltage diminishes, so
as to maintain a constant dissipation of 29.3 W. The constant-power engine adjusts the current by altering the
reference signal fed to the current limit amplifier. The lower part of Figure 28 shows the measured power
dissipated within the MOSFET, labeled FET PWR, remaining substantially constant during this period of
operation, which ends when the current through the MOSFET reaches the current limit ILIM. This behavior can be
considered a form of foldback limiting, but unlike the standard linear form of foldback limiting, it allows the power
device to operate near its maximum capability, thus reducing the start-up time and minimizing the size of the
required MOSFET.
Copyright
2011, Texas Instruments Incorporated
15
相关PDF资料 |
PDF描述 |
|---|---|
| TC151A3112EOA713 | 0.25 A SWITCHING REGULATOR, 50 kHz SWITCHING FREQ-MAX, PDSO8 |
| TC151A5431EOA723 | 0.25 A SWITCHING REGULATOR, 50 kHz SWITCHING FREQ-MAX, PDSO8 |
| TC151B5433EOA713 | 0.25 A SWITCHING REGULATOR, 50 kHz SWITCHING FREQ-MAX, PDSO8 |
| TC151A4634EOA723 | 0.25 A SWITCHING REGULATOR, 50 kHz SWITCHING FREQ-MAX, PDSO8 |
| TC151A3537EOA713 | 0.25 A SWITCHING REGULATOR, 50 kHz SWITCHING FREQ-MAX, PDSO8 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TPS24720EVM-001 | 功能描述:电源管理IC开发工具 TPS24720 Eval Mod RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:Battery Management 工具用于评估:MAX17710GB 输入电压: 输出电压:1.8 V |
| TPS24720RGTR | 功能描述:热插拔功率分布 2.5-18V Hi Eff Adj Ltd Hot-Swap Cntrlr RoHS:否 制造商:Texas Instruments 产品:Controllers & Switches 电流限制: 电源电压-最大:7 V 电源电压-最小:- 0.3 V 工作温度范围: 功率耗散: 安装风格:SMD/SMT 封装 / 箱体:MSOP-8 封装:Tube |
| TPS24720RGTT | 功能描述:热插拔功率分布 2.5-18V Hi Eff Adj Ltd Hot-Swap Cntrlr RoHS:否 制造商:Texas Instruments 产品:Controllers & Switches 电流限制: 电源电压-最大:7 V 电源电压-最小:- 0.3 V 工作温度范围: 功率耗散: 安装风格:SMD/SMT 封装 / 箱体:MSOP-8 封装:Tube |
| TPS24740EVM-596 | 功能描述:IC CTRLR HOT SWAP 2.5-18V 16QFN 制造商:texas instruments 系列:- 零件状态:在售 主要用途:电源管理，热交换控制器 嵌入式:- 使用的 IC/零件:TPS24740 主要属性:- 辅助属性:- 所含物品:板 标准包装:1 |
| TPS24740RGET | 功能描述:Hot Swap Controller, OR Controller 1 Channel General Purpose 24-VQFN (4x4) 制造商:texas instruments 系列:- 包装:剪切带（CT） 零件状态:有效 类型:热交换控制器，OR 控制器 通道数:1 内部开关:无 应用:通用 特性:闭锁故障，UVLO 可编程特性:限流，故障超时，OVP，开启电压 电压 - 电源:2.5 V ~ 18 V 电流 - 输出（最大值）:- 工作温度:-40°C ~ 125°C 电流 - 电源:4.2mA 安装类型:表面贴装 封装/外壳:24-VFQFN 裸露焊盘 供应商器件封装:24-VQFN（4x4） 功能引脚:ENHS，ENOR，FLTb，FSTP，IMON，IMONBUF，OV，PGHS，PLIM，RVSNP，RVSNM，SENM，SET，STAT，TFLT，TINR 标准包装:1 |
发布紧急采购，3分钟左右您将得到回复。