参数资料
| 型号： | TPS54326RGTT |
| 厂商： | Texas Instruments |
| 文件页数： | 7/29页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK SYNC ADJ 3A 16QFN |
| 标准包装： | 250 |
| 系列： | SWIFT™, D-CAP2™ |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 0.76 V ~ 5.5 V |
| 输入电压： | 2 V ~ 18 V |
| PWM 型： | 混合物 |
| 频率 - 开关： | 700kHz |
| 电流 - 输出： | 3A |
| 同步整流器： | 是 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-VFQFN 裸露焊盘 |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | 16-QFN-EP（3x3） |
第1页第2页第3页第4页第5页第6页当前第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页
SLVSA13E – OCTOBER 2009 – REVISED JUNE 2012
At the beginning of each cycle, the high-side MOSFET is turned on. This MOSFET is turned off after internal one
shot timer expires. This one shot timer is set by the converter input voltage ,V IN , and the output voltage ,V O , to
maintain a pseudo-fixed frequency over the input voltage range, hence it is called adaptive on-time control. The
one-shot timer is reset and the high-side MOSFET is turned on again when the feedback voltage falls below the
reference voltage. An internal ramp is added to the reference voltage to simulate output ripple, eliminating the
need for ESR induced output ripple from D-CAP2? mode control.
PWM Frequency and Adaptive On-Time Control
TPS54326 uses an adaptive on-time control scheme and does not have a dedicated on board oscillator. The
TPS54326 runs with a pseudo-constant frequency of 700 kHz by using the input voltage and output voltage to
set the on-time one-shot timer. The on-time is inversely proportional to the input voltage and proportional to the
output voltage. The actual frequency may vary from 700 kHz depending on the off time, which is ended when the
fed back portion of the output voltage falls to the V FB threshold voltage.
Auto-Skip Eco-Mode? Control
The TPS54326 is designed with Auto-Skip Eco-Mode? to increase light load efficiency. As the output current
decreases from heavy load condition, the inductor current is also reduced and eventually comes to point that its
rippled valley touches zero level, which is the boundary between continuous conduction and discontinuous
conduction modes. The rectifying MOSFET is turned off when its zero inductor current is detected. As the load
current further decreases the converter run into discontinuous conduction mode. The on-time is kept almost the
same as is was in the continuous conduction mode so that it takes longer time to discharge the output capacitor
with smaller load current to the level of the reference voltage. The transition point to the light load operation
I OUT(LL) current can be calculated in Equation 1.
(V IN OUT OUT
2 · L · fws
V IN
1 -V ) · V
I OUT(LL) = - · -
(1)
Soft Start and Pre-Biased Soft Start
The soft start function is adjustable. When the EN pin becomes high, 2- μ A current begins charging the capacitor
which is connected from the SS pin to GND. Smooth control of the output voltage is maintained during start up.
The equation for the slow start time is shown in Equation 2 . VFB voltage is 0.765 V and SS pin source current is
2 μ A.
Iss( μ A)
C6(nF) ? Vref C6(nF) ? 0.765
Tss(ms) = ? = ?
2
(2)
A unique circuit to prevent current from being pulled from the output during startup if the output is pre-biased.
When the soft-start commands a voltage higher than the pre-bias level (internal soft start becomes greater than
feedback voltage V FB ), the controller slowly activates synchronous rectification by starting the first low side FET
gate driver pulses with a narrow on-time. It then increments that on-time on a cycle-by-cycle basis until it
coincides with the time dictated by (1-D), where D is the duty cycle of the converter. This scheme prevents the
initial sinking of the pre-bias output, and ensure that the out voltage (VO) starts and ramps up smoothly into
regulation and the control loop is given time to transition from pre-biased start-up to normal mode operation.
Power Good
The power good function is activated after soft start has finished. The power good function becomes active after
1.7 times soft-start time. When the output voltage is within –10% of the target value, internal comparators detect
power good state and the power good signal becomes high. Rpg resister value, which is connected between PG
and VREG5, is required from 20k Ω to 150k Ω . If the feedback voltage goes under 15% of the target value, the
power good signal becomes low after a 10 ms internal delay.
Output Discharge Control
TPS54326 discharges the output when EN is low, or the controller is turned off by the protection functions (OVP,
UVP, UVLO and thermal shutdown). The output is discharged by an internal 50- ? MOSFET which is connected
from VO to PGND. The internal low-side MOSFET is not turned on during the output discharge operation to
avoid the possibility of causing negative voltage at the output.
Copyright ? 2009–2012, Texas Instruments Incorporated
7
相关PDF资料 |
PDF描述 |
|---|---|
| TPS54478RTER | IC REG BUCK SYNC ADJ 4A 16WQFN |
| TPS54550PWPG4 | IC REG BUCK SYNC ADJ 6A 16HTSSOP |
| TPS54678RTER | IC REG BUCK SYNC ADJ 6A 16WQFN |
| TPS54900PWRG4 | IC REG BUCK ADJ .1A QUAD 16TSSOP |
| TPS60110PWPG4 | IC REG BST SWITCHED CAP 20HTSSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TPS54327 | 制造商:TI 制造商全称:Texas Instruments 功能描述:3-A OUTPUT SINGLE SYNCHRONOUS STEP DOWN SWITCHER WITH INTEGRATED FET (SWIFTTM ) |
| TPS54327DDA | 功能描述:直流/直流开关转换器 4.5-18Vin,3A Sync Step-Down Cnvrtr RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT |
| TPS54327DDAR | 功能描述:直流/直流开关转换器 4.5-18Vin,3A Sync Step-Down Cnvrtr RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT |
| TPS54327DRCR | 制造商:Texas Instruments 功能描述:IC REG BUCK SYNC ADJ 3A 10SON 制造商:Texas Instruments 功能描述:3A Single Sync DC/DC converter |
| TPS54327DRCT | 制造商:Texas Instruments 功能描述:3A SINGLE SYNC DC/DC CONVERTER - Tape and Reel 制造商:Texas Instruments 功能描述:3A SINGLE SYNC DC/DC CONVERTER - Cut TR (SOS) 制造商:Texas Instruments 功能描述:IC REG BUCK SYNC ADJ 3A 10SON 制造商:Texas Instruments 功能描述:IC SYNC STEP DOWN 700KHZ SO 制造商:Texas Instruments 功能描述:IC, SYNC STEP DOWN, 700KHZ, SON-10 制造商:Texas Instruments 功能描述:Voltage Regulators - Switching Regulators 4.5-18Vin,3A Sync SD DCAP Mode Cnvrtr 制造商:Texas Instruments 功能描述:IC, SYNC STEP DOWN, 700KHZ, SON-10, Primary Input Voltage:18V, No. of Outputs:1, Output Voltage:7V, Output Current:3A, Voltage Regulator Case Style:SON, No. of Pins:10, Operating Temperature Min:-40C, Operating Temperature Max:85C, 制造商:Texas Instruments 功能描述:3A Single Sync DC/DC converter 制造商:Texas Instruments 功能描述:DC-DC CONV, BUCK, ADJ, 700KHZ, SON-10, Primary Input Voltage:18V, No. of Outputs:1, Output Voltage:7V, Output Current:3A, No. of Pins:10, Operating Temperature Min:-40C, Operating Temperature Max:85C, MSL:MSL 2 - 1 year , RoHS Compliant: Yes |
发布紧急采购，3分钟左右您将得到回复。