参数资料
型号: XR17C158CV-F
厂商: Exar Corporation
文件页数: 65/67页
文件大小: 0K
描述: IC UART PCI BUS 5V OCTAL 144LQFP
产品培训模块: UART Product Overview
标准包装: 60
特点: *
通道数: 8
FIFO's: 64 字节
规程: RS485
电源电压: 4.5 V ~ 5.5 V
带自动流量控制功能:
带IrDA 编码器/解码器:
带故障启动位检测功能:
带调制解调器控制功能:
安装类型: 表面贴装
封装/外壳: 144-LQFP
供应商设备封装: 144-LQFP(20x20)
包装: 托盘
其它名称: 1016-1287
xr
XR17C158
REV. 1.4.3
5V PCI BUS OCTAL UART
7
FUNCTIONAL DESCRIPTION
The XR17C158 (158) integrates the functions of 8 enhanced 16550 UARTs with the PCI Local Bus interface
and a non-volatile memory interface for PCI bus’s plug-and-play auto-configuration, a 16-bit timer/counter, 8
multi-purpose inputs/outputs, and an on-chip oscillator. The PCI local bus is a synchronous timing bus where
all bus transactions are associated to the bus clock of up to 33.34MHz. The 158 supports 32-bit wide read and
write data transfer operations including data burst mode through the PCI Local Bus interface. Read and write
data operations may be in byte, word or double-word (DWORD) format. A single 32-bit interrupt status register
provides interrupts status for all 8 UARTs, timer/counter, multipurpose inputs/outputs, and a special sleep wake
up indicator. There are three sets of register in the device. First, the PCI local bus configuration registers for
PCI auto configuration. A set of device configuration registers for overall control, 32-bit wide transmit and re-
ceive data transfer, and monitoring of the 8 UART channels. Lastly, each UART channel has its own 16550
UART compatible configuration register set for individual channel control, status, and byte wide data transfer.
Each UART has 64-byte FIFOs, automatic RTS/CTS or DTR/DSR hardware flow control with hysteresis con-
trol, automatic Xon/Xoff and special character software flow control, programmable transmit and receive FIFO
trigger level, FIFO level counters, infrared encoder and decoder (IrDA ver. 1.0), programmable baud rate gen-
erator with a prescaler of 1X or 4X, and data rate up to 6.25 Mbps at 8X sampling clock. The XR17C158 bus
timing and drive capability meets the PCI local bus specification revision 2.2 for 5 volt operation over the tem-
perature range. For a pin-to-pin compatible part that can operate at 3.3V, see the XR17D158. The XR17C158
is available in a thin 144-pin LQFP (20x20x1.0mm) package in commercial and industrial temperature ranges.
PCI Local Bus Interface
This is the host interface and it meets the PCI Local Bus Specification revision 2.2 at 5V. The PCI local bus op-
erations are synchronous meaning each transaction is associated to the bus clock. The XR17C158 can oper-
ate with the bus clock of up to a 33.34MHz. Data transfers operation can be formatted in 8-bit, 16-bit, 24-bit or
32-bit wide. With 32-bit data operations, it pushes the data transfer rate on the bus up to 132 MByte/sec. This
increases the overall system’s communication performance up to 16 times better than the 8-bit ISA bus. See
PCI local bus specification revision 2.2 for bus operation details.
PCI Local Bus Configuration Space Registers
A set of PCI local bus configuration space register is provided. These registers provide the PCI local bus oper-
ating system with the card’s vendor ID, device ID, sub-vendor ID, product model number, and resources and
capabilities. The PCI local bus operating system collects this data from all the cards on the bus during the auto
configuration phase that follows immediately after a power up or system reset/reboot. After it has sorted out all
devices on the bus, it defines and download the operating conditions to the cards. One of the definitions is the
base address loaded into the Base Address Register (BAR) where the card will be operating in the PCI local
bus memory space.
EEPROM Interface
An external 93C46 EEPROM is only used to store the vendor’s ID and model number, and the sub-vendor’s ID
and product model number. This information is only used with the plug-and-play auto configuration of the PCI
local bus. These data provide automatic hardware installation onto the PCI bus. The EEPROM interface con-
sists of 4 signals, EEDI, EEDO, EECS, and EECK. The EEPROM is not needed when auto configuration is not
required in the application. However, If your design requires non-volatile memory for other purpose. It is possi-
ble to store and retrieve data on the EEPROM through a special PCI device configuration register. See applica-
tion note DAN112 for its programming details.
相关PDF资料
PDF描述
XR17D158CV-F IC UART PCI BUS OCTAL 144LQFP
ATMEGA168-15MZ MCU AVR 16K FLASH 15MHZ 32-QFN
XR17V258IVTR-F IC UART PCI BUS OCTAL 144LQFP
XR16L788IQTR-F IC UART FIFO 64B OCTAL 100QFP
XR17C154IV-F IC UART PCI BUS QUAD 144LQFP
相关代理商/技术参数
参数描述
XR17C158CVTR-F 制造商:Exar Corporation 功能描述:UART 8-CH 64Byte FIFO 5V 144-Pin LQFP T/R 制造商:Exar Corporation 功能描述:XR17C158CVTR-F
XR17C158IV 功能描述:UART 接口集成电路 UART RoHS:否 制造商:Texas Instruments 通道数量:2 数据速率:3 Mbps 电源电压-最大:3.6 V 电源电压-最小:2.7 V 电源电流:20 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:LQFP-48 封装:Reel
XR17C158IV-F 功能描述:UART 接口集成电路 UART RoHS:否 制造商:Texas Instruments 通道数量:2 数据速率:3 Mbps 电源电压-最大:3.6 V 电源电压-最小:2.7 V 电源电流:20 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:LQFP-48 封装:Reel
XR17C158IVTR-F 制造商:Exar Corporation 功能描述:UART 8-CH 64Byte FIFO 5V 144-Pin LQFP T/R 制造商:Exar Corporation 功能描述:XR17C158IVTR-F
XR17D152 制造商:EXAR 制造商全称:EXAR 功能描述:UNIVERSAL (3.3V AND 5V) PCI BUS DUAL UART