- 您现在的位置：买卖IC网 > PDF目录21903 > 4430-T-B1 D 950 (Silicon Laboratories Inc)KIT DEV TEST EZRADIOPRO SI4430 PDF资料下载
参数资料
| 型号： | 4430-T-B1 D 950 |
| 厂商： | Silicon Laboratories Inc |
| 文件页数： | 15/47页 |
| 文件大小： | 799K |
| 描述： | KIT DEV TEST EZRADIOPRO SI4430 |
| 标准包装： | 1 |
| 附件类型： | 测试卡，收发器，950MHz |
| 适用于相关产品： | EZRadioPRO? |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页当前第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页
Si4430/31/32-B1
Rev 1.1
15
2. Functional Description
The Si4430/31/32 are ISM wireless transceivers with continuous frequency tuning over their specified bands which
encompasses from 240960 MHz. The wide operating voltage range of 1.83.6 V and low current consumption
makes the Si4430/31/32 an ideal solution for battery powered applications.
The Si4430/31/32 operates as a time division duplexing (TDD) transceiver where the device alternately transmits
and receives data packets. The device uses a single-conversion mixer to downconvert the 2-level FSK/GFSK/OOK
modulated receive signal to a low IF frequency. Following a programmable gain amplifier (PGA) the signal is
converted to the digital domain by a high performance DS ADC allowing filtering, demodulation, slicing, and packet
handling to be performed in the built-in DSP increasing the receivers performance and flexibility versus analog
based architectures. The demodulated signal is then output to the system MCU through a programmable GPIO or
via the standard SPI bus by reading the 64-byte RX FIFO.
A single high precision local oscillator (LO) is used for both transmit and receive modes since the transmitter and
receiver do not operate at the same time. The LO is generated by an integrated VCO and DS Fractional-N PLL
synthesizer. The synthesizer is designed to support configurable data rates, output frequency and frequency
deviation at any frequency between 240960 MHz. The transmit FSK data is modulated directly into the DS data
stream and can be shaped by a Gaussian low-pass filter to reduce unwanted spectral content.
The Si4432s PA output power can be configured between +1 and +20 dBm in 3 dB steps, while the Si4430/31's
PA output power can be configured between 8 and +13 dBm in 3 dB steps. The PA is single-ended to allow for
easy antenna matching and low BOM cost. The PA incorporates automatic ramp-up and rampdown control to
reduce unwanted spectral spreading. The +20 dBm power amplifier of the Si4432 can also be used to compensate
for the reduced performance of a lower cost, lower performance antenna or antenna with size constraints due to a
small form-factor. Competing solutions require large and expensive external PAs to achieve comparable
performance. The Si4430/31/32 supports frequency hopping, TX/RX switch control, and antenna diversity switch
control to extend the link range and improve performance.
The Si4430/31/32 is designed to work with a microcontroller, crystal, and a few external components to create a
very low cost system as shown Figure 1. Voltage regulators are integrated on-chip which allows for a wide
operating supply voltage range from +1.8 to +3.6 V. A standard 4-pin SPI bus is used to communicate with an
external microcontroller. Three configurable general purpose I/Os are available. A complete list of the available
GPIO functions is shown in "8. Auxiliary Functions" on page 50 and includes microcontroller clock output, Antenna
Diversity, POR, and various interrupts.
The application shown in Figure 1 is designed for a system with a TX/RX direct-tie configuration without the use of
a TX/RX switch. Most lower power applications will use this configuration. A complete direct-tie reference design is
available from Silicon Laboratories applications support.
For applications seeking improved performance in the presence of multipath fading antenna diversity can be used.
Antenna diversity support is integrated into the Si4430/31/32 and can improve the system link budget by 810 dB
in the presence of these fading conditions, resulting in substantial range increases. A complete Antenna Diversity
reference design is available from Silicon Laboratories applications support.
相关PDF资料 |
PDF描述 |
|---|---|
| B82432X2 | KIT INDUCTOR 1812-C SERIES |
| XPGWHT-L1-0000-00BE8 | LED WARM WHITE 2700K SMD |
| B82422X100 | KIT INDUCTOR 1210-A SERIES |
| B82422X1 | KIT INDUCTOR 1210-T SERIES |
| B82559X1 | KIT INDUCTOR POWER 82559 SERIES |
相关代理商/技术参数 |
参数描述 |
|---|---|
| 4431 | 制造商:Thomas & Betts 功能描述:TRIPLE HEX DIE 制造商:Thomas & Betts 功能描述:Triple Hex Die |
| 4431.1001 | 功能描述:摇臂开关与扳钮开关 UV PROTECTION SWITCH Rocker, 230V 50HZ RoHS:否 制造商:C&K Components 触点形式: 开关功能: 电流额定值:50 mA 电压额定值 AC: 电压额定值 DC:30 V 功率额定值: 端接类型: 执行器:Paddle 颜色: 安装风格:Panel 端子密封: 触点电镀: 照明:Not Illuminated 照明颜色: |
| 4431.1002 | 功能描述:摇臂开关与扳钮开关 UV PROTECTION SWITCH Rocker, 115V 50HZ RoHS:否 制造商:C&K Components 触点形式: 开关功能: 电流额定值:50 mA 电压额定值 AC: 电压额定值 DC:30 V 功率额定值: 端接类型: 执行器:Paddle 颜色: 安装风格:Panel 端子密封: 触点电镀: 照明:Not Illuminated 照明颜色: |
| 4431.1003 | 功能描述:摇臂开关与扳钮开关 UV PROTECTION SWITCH Rocker, 120V 60HZ RoHS:否 制造商:C&K Components 触点形式: 开关功能: 电流额定值:50 mA 电压额定值 AC: 电压额定值 DC:30 V 功率额定值: 端接类型: 执行器:Paddle 颜色: 安装风格:Panel 端子密封: 触点电镀: 照明:Not Illuminated 照明颜色: |
| 4431.1004 | 功能描述:摇臂开关与扳钮开关 UV PROTECTION SWITCH Rocker, 230V 50HZ RoHS:否 制造商:C&K Components 触点形式: 开关功能: 电流额定值:50 mA 电压额定值 AC: 电压额定值 DC:30 V 功率额定值: 端接类型: 执行器:Paddle 颜色: 安装风格:Panel 端子密封: 触点电镀: 照明:Not Illuminated 照明颜色: |
发布紧急采购，3分钟左右您将得到回复。