- 您现在的位置：买卖IC网 > PDF目录21903 > 4430-T-B1 D 950 (Silicon Laboratories Inc)KIT DEV TEST EZRADIOPRO SI4430 PDF资料下载
参数资料
| 型号： | 4430-T-B1 D 950 |
| 厂商： | Silicon Laboratories Inc |
| 文件页数： | 47/47页 |
| 文件大小： | 799K |
| 描述： | KIT DEV TEST EZRADIOPRO SI4430 |
| 标准包装： | 1 |
| 附件类型： | 测试卡，收发器，950MHz |
| 适用于相关产品： | EZRadioPRO? |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页当前第47页
Si4430/31/32-B1
Rev 1.1
47
6.7. Preamble Length
The preamble detection threshold determines the number of valid preamble bits the radio must receive to qualify a
valid preamble. The preamble threshold should be adjusted depending on the nature of the application. The
required preamble length threshold will depend on when receive mode is entered in relation to the start of the
transmitted packet and the length of the transmit preamble. With a shorter than recommended preamble detection
threshold the probability of false detection is directly related to how long the receiver operates on noise before the
transmit preamble is received. False detection on noise may cause the actual packet to be missed. The preamble
detection threshold is programmed in register 35h. For most applications with a preamble length longer than 32 bits
the default value of 20 is recommended for the preamble detection threshold. A shorter Preamble Detection
Threshold may be chosen if occasional false detections may be tolerated. When antenna diversity is enabled a 20-
bit preamble detection threshold is recommended. When the receiver is synchronously enabled just before the
start of the packet, a shorter preamble detection threshold may be used. Table 14 demonstrates the recommended
preamble detection threshold and preamble length for various modes.
It is possible to use Si4432/31/30 in a raw mode without the requirement for a 010101... preamble. Contact
customer support for further details.
Note: The recommended preamble length and preamble detection threshold listed above are to achieve 0% PER. They may
be shortened when occasional packet errors are tolerable.
6.8. Invalid Preamble Detector
When scanning channels in a frequency hopping system it is desirable to determine if a channel is valid in the
minimum amount of time. The preamble detector can output an invalid preamble detect signal. which can be used
to identify the channel as invalid. After a configurable time set in Register 60h[7:4], an invalid preamble detect
signal is asserted indicating an invalid channel. The period for evaluating the signal for invalid preamble is defined
as (inv_pre_th[3:0] x 4) x Bit Rate Period. The preamble detect and invalid preamble detect signals are available in
"Register 03h. Interrupt/Status 1" and Register 04h. Interrupt/Status 2.
6.9. Synchronization Word Configuration
The synchronization word length for both TX and RX can be configured in Reg 33h, synclen[1:0]. The expected or
transmitted sync word can be configured from 1 to 4 bytes as defined below:
n synclen[1:0] = 00Expected/Transmitted Synchronization Word (sync word) 3.
n synclen[1:0] = 01Expected/Transmitted Synchronization Word 3 first, followed by sync word 2.
n synclen[1:0] = 10Expected/Transmitted Synchronization Word 3 first, followed by sync word 2, followed by
sync word 1.
n synclen[1:0] = 1Send/Expect Synchronization Word 3 first, followed by sync word 2, followed by sync word 1,
followed by sync word 0.
The sync is transmitted or expected in the following sequence: sync 3畇ync 2畇ync 1畇ync 0. The sync word
values can be programmed in Registers 36h39h. After preamble detection, the part will search for sync for a fixed
Table 14. Minimum Receiver Settling Time
Mode
Approximate
Receiver
Settling Time
Recommended Preamble
Length with 8-Bit
Detection Threshold
Recommended Preamble
Length with 20-Bit
Detection Threshold
(G)FSK AFC Disabled
1 byte
20 bits
32 bits
(G)FSK AFC Enabled
2 byte
28 bits
40 bits
(G)FSK AFC Disabled +Antenna
Diversity Enabled
1 byte
64 bits
(G)FSK AFC Enabled +Antenna
Diversity Enabled
2 byte
8 byte
OOK
2 byte
3 byte
4 byte
OOK + Antenna Diversity Enabled
8 byte
8 byte
相关PDF资料 |
PDF描述 |
|---|---|
| B82432X2 | KIT INDUCTOR 1812-C SERIES |
| XPGWHT-L1-0000-00BE8 | LED WARM WHITE 2700K SMD |
| B82422X100 | KIT INDUCTOR 1210-A SERIES |
| B82422X1 | KIT INDUCTOR 1210-T SERIES |
| B82559X1 | KIT INDUCTOR POWER 82559 SERIES |
相关代理商/技术参数 |
参数描述 |
|---|---|
| 4431 | 制造商:Thomas & Betts 功能描述:TRIPLE HEX DIE 制造商:Thomas & Betts 功能描述:Triple Hex Die |
| 4431.1001 | 功能描述:摇臂开关与扳钮开关 UV PROTECTION SWITCH Rocker, 230V 50HZ RoHS:否 制造商:C&K Components 触点形式: 开关功能: 电流额定值:50 mA 电压额定值 AC: 电压额定值 DC:30 V 功率额定值: 端接类型: 执行器:Paddle 颜色: 安装风格:Panel 端子密封: 触点电镀: 照明:Not Illuminated 照明颜色: |
| 4431.1002 | 功能描述:摇臂开关与扳钮开关 UV PROTECTION SWITCH Rocker, 115V 50HZ RoHS:否 制造商:C&K Components 触点形式: 开关功能: 电流额定值:50 mA 电压额定值 AC: 电压额定值 DC:30 V 功率额定值: 端接类型: 执行器:Paddle 颜色: 安装风格:Panel 端子密封: 触点电镀: 照明:Not Illuminated 照明颜色: |
| 4431.1003 | 功能描述:摇臂开关与扳钮开关 UV PROTECTION SWITCH Rocker, 120V 60HZ RoHS:否 制造商:C&K Components 触点形式: 开关功能: 电流额定值:50 mA 电压额定值 AC: 电压额定值 DC:30 V 功率额定值: 端接类型: 执行器:Paddle 颜色: 安装风格:Panel 端子密封: 触点电镀: 照明:Not Illuminated 照明颜色: |
| 4431.1004 | 功能描述:摇臂开关与扳钮开关 UV PROTECTION SWITCH Rocker, 230V 50HZ RoHS:否 制造商:C&K Components 触点形式: 开关功能: 电流额定值:50 mA 电压额定值 AC: 电压额定值 DC:30 V 功率额定值: 端接类型: 执行器:Paddle 颜色: 安装风格:Panel 端子密封: 触点电镀: 照明:Not Illuminated 照明颜色: |
发布紧急采购，3分钟左右您将得到回复。