参数资料
型号: AD9240ASZRL
厂商: Analog Devices Inc
文件页数: 14/24页
文件大小: 0K
描述: IC ADC 14BIT 10MSPS 44-MQFP TR
标准包装: 800
位数: 14
采样率(每秒): 10M
数据接口: 并联
转换器数目: 7
功率耗散(最大): 330mW
电压电源: 模拟和数字
工作温度: -40°C ~ 85°C
安装类型: 表面贴装
封装/外壳: 44-QFP
供应商设备封装: 44-MQFP(10x10)
包装: 带卷 (TR)
输入数目和类型: 2 个单端,单极;1 个差分,单极
AD9240
REV.
–21–
the bandlimited IF signal aliases back into the center of the ADC’s
baseband region (i.e. FS/4). At a sample rate of 10 MSPS, an
image of the IF signal centered at 37.5 MHz will be aliased back
to 2.5 MHz which corresponds to one quarter of the sample rate
(i.e. FS/4). Note, the IF signal in this case will have undergone a
frequency inversion that may easily be corrected for in the digital
domain.
200
0.1 F
AD9240
VINA
CML
VINB
50
AD8009
50
280
93.1
AD8009
200
22.1
50
SAW FILTER
OUTPUT
G1 = 20dB
G2 = 12dB
MINI-CIRCUITS
T4-6T
Figure 52. Simplified AD9240 IF Sampling Circuit
To maximize its distortion performance, the AD9240 is config-
ured in the differential mode using a transformer. Preceding the
AD9240 is a bandpass filter and a 32 dB gain stage. A large
gain stage may be required to compensate for the high insertion
losses of a SAW filter used for image rejection. The gain stage
will also provide adequate isolation for the SAW filter from the
transient currents associated with AD9240’s input stage.
The gain stage can be realized using one or two cascaded AD8009
op amps. The AD8009 is a low cost current-feedback op amp
having a third order intercept of 33 dB for a gain of +10 MHz
at 37.5 MHz. A passive bandpass filter is required after the
AD8009 to reduce the resulting second order distortion prod-
ucts and limit its out-of-band noise. The specifications of this
filter are application dependent and will affect both the total
distortion and noise performance of this circuit.
Figure 53 shows the single-tone SNR and SFDR performance of
the AD9240 configured in the 2 V and 5 V span without using
the AD8009 gain stage. Only a slight degradation in SNR perfor-
mance (i.e., 1 dB) was noted with the inclusion of the AD8009
gain stage and a bandpass filter. Note, the tradeoff in SNR and
SFDR (dBFS) performance between the 5 V and 2 V spans at
different signal levels.
INPUT POWER LEVEL – dBFS
40
–30
–80
–70
–60
–40
80
60
50
70
30
20
WORST
CASE
SPURIOUS
AND
SNR
dBc
10
0
–50
–20
–10
0
SFDR w/5V SPAN
SFDR w/2V SPAN
SNR w/5V SPAN
SNR w/2V SPAN
Figure 53. Single-Tone SNR/SFDR vs. Input Amplitude
@ 37.45 MHz
Figure 54 compares the two tone SFDR performance of the
AD9240 in the 2 V span with and without the use of the AD8009
gain stage. No degradation in distortion performance was noted
with the inclusion of the AD8009 gain stage provided that the
AD8009 2nd order distortion products are sufficiently attenu-
ated by the bandpass filter.
INPUT POWER LEVEL (f1 = f2) – dBFS
40
–90
–30
–80
–70
–60
–40
100
90
80
60
50
70
30
20
WORST
CASE
SPURIOUS
dBc
AND
dBFS
10
0
–50
–20
–10
0
w/o AD8009 – dBFS
w/AD8009 – dBFS
w/o AD8009 – dBc
w/AD8009 – dBc
85 dB REFERENCE LINE
Figure 54. Two Tone SFDR vs. Input Amplitude
@ f1 = 36.40 MHz and f2 = 38.60 MHz
B
相关PDF资料
PDF描述
IDT7201LA25SOI8 IC MEM FIFO 512X9 25NS 28-SOIC
AD7880CRZ-REEL IC ADC 12BIT MONO LP 24-SOIC
VI-222-IW-F4 CONVERTER MOD DC/DC 15V 100W
LTC1604CG#TR IC ADC 16BIT SAMPL SHTDWN 36SSOP
VE-2NX-MX-F3 CONVERTER MOD DC/DC 5.2V 75W
相关代理商/技术参数
参数描述
AD9240EB 制造商:AD 制造商全称:Analog Devices 功能描述:Complete 14-Bit, 10 MSPS Monolithic A/D Converter
AD9240-EB 制造商:Analog Devices 功能描述:
AD9241 制造商:AD 制造商全称:Analog Devices 功能描述:Complete 14-Bit, 1.25 MSPS Monolithic A/D Converter
AD9241ACHIPS 制造商:Analog Devices 功能描述:
AD9241AS 制造商:Analog Devices 功能描述:ADC Single Pipelined 1.25Msps 14-bit Parallel 44-Pin MQFP 制造商:Rochester Electronics LLC 功能描述:14BIT 1.25 MSPS MONOLITHIC A/D CONVERTER - Bulk 制造商:Analog Devices 功能描述:IC 14-BIT ADC