- 您现在的位置：买卖IC网 > PDF目录1776 > ADP1821ARQZ-R7 (Analog Devices Inc)IC REG CTRLR BUCK PWM VM 16-QSOP PDF资料下载
参数资料
| 型号： | ADP1821ARQZ-R7 |
| 厂商： | Analog Devices Inc |
| 文件页数： | 13/24页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM VM 16-QSOP |
| 标准包装： | 1 |
| PWM 型： | 电压模式 |
| 输出数： | 1 |
| 频率 - 最大： | 720kHz |
| 占空比： | 90% |
| 电源电压： | 3.7 V ~ 5.5 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 16-SSOP（0.154"，3.90mm 宽） |
| 包装： | 标准包装 |
| 产品目录页面： | 791 (CN2011-ZH PDF) |
| 其它名称： | ADP1821ARQZ-R7DKR |
ADP1821
In the case of output capacitors where the impedance of the
ESR and ESL are small at the switching frequency, for instance,
The total power dissipation of the high-side MOSFET is the
sum of all the previous losses, or
where the output capacitor is a bank of parallel MLCC capaci-
tors, the capacitive impedance dominates and the ripple
P D ? P C + P G + P T
(11)
Δ V OUT ?
Δ I L
equation reduces to
(7)
8 C OUT f SW
Make sure that the ripple current rating of the output capacitors
is greater than the maximum inductor ripple current.
During a load step transient on the output, the output capacitor
supplies the load until the control loop has a chance to ramp the
inductor current. This initial output voltage deviation due to a
where P D is the total high-side MOSFET power loss.
The conduction losses may need an adjustment to account
for the MOSFET R DSON variation with temperature. Note that
MOSFET R DSON increases with increasing temperature. A MOSFET
data sheet should list the thermal resistance of the package, θ JA ,
along with a normalized curve of the temperature coefficient of
the R DSON . For the power dissipation estimated above, calculate
the MOSFET junction temperature rise over the ambient
temperature of interest.
change in load is dependent on the output capacitor character-
T J = T A + θ JA P D
(12)
istics. Again, usually the capacitor ESR dominates this response,
and the ΔV OUT in Equation 6 can be used with the load step
current value for ΔI L .
SELECTING THE MOSFETS
The choice of MOSFET directly affects the dc-to-dc converter
performance. The MOSFET must have low on resistance to reduce
I 2 R losses and low gate charge to reduce transition losses. In
addition, the MOSFET must have low thermal resistance to
ensure that the power dissipated in the MOSFET does not result
in excessive MOSFET die temperature.
The high-side MOSFET carries the load current during on time
and carries all the transition losses of the converter. Typically,
the lower the MOSFET on resistance, the higher the gate charge
and vice versa. Therefore, it is important to choose a high-side
MOSFET that balances the two losses. The conduction loss of
the high-side MOSFET is determined by the equation
Then calculate the new R DSON from the temperature coefficient
curve and the R DSON spec at 25°C. A typical value of the temperature
coefficient (TC) of the R DSON is 0.004/°C, thus, an alternate
method to calculate the MOSFET R DSON at a second
temperature, T J , is
R DSON @ T J = R DSON @ 25°C(1 + TC ( T J ? 25°C)) (13)
Next, the conduction losses can be recalculated and the pro-
cedure iterated once or twice until the junction temperature
calculations are relatively consistent.
The synchronous rectifier, or low-side MOSFET, carries the
inductor current when the high-side MOSFET is off. The low-
side MOSFET transition loss is small and can be neglected in
the calculation. For high input voltage and low output voltage,
the low-side MOSFET carries the current most of the time.
Therefore, to achieve high efficiency, it is critical to optimize
the low-side MOSFET for low on resistance. In cases where the
P C ? ( I LOAD ) 2 R DSON ? ? OUT
? V ?
?
P LS ? ( I LOAD ) 2 R DSON ? 1 ? OUT ?
?
? V IN ?
where:
P C is the conduction power loss.
R DSON is the MOSFET on resistance.
The gate charging loss is approximated by the equation
(8)
power loss exceeds the MOSFET rating or lower resistance is
required than is available in a single MOSFET, connect multiple
low-side MOSFETs in parallel. The equation for low-side
MOSFET power loss is
? V ?
(14)
? V IN ?
P G ? V PVCC Q G f SW (9)
where:
P G is the gate charging loss power.
V PVCC is the gate driver supply voltage.
Q G is the MOSFET total gate charge.
f SW is the converter switching frequency.
The high-side MOSFET transition loss is approximated by the
equation
where:
P LS is the low-side MOSFET on resistance.
R DSON is the total on resistance of the low-side MOSFET(s).
Check the gate charge losses of the synchronous rectifier
using the P G equation (Equation 9) to be sure it is reasonable.
If multiple low-side MOSFETs are used in parallel, then use
the parallel combination of the on resistances for determining
R DSON to solve this equation.
P T =
V IN I LOAD ( t R + t F ) f SW
2
(10)
where:
P T is the high-side MOSFET switching loss power.
t R is the MOSFET rise time.
t F is the MOSFET fall time.
Rev. C | Page 13 of 24
相关PDF资料 |
PDF描述 |
|---|---|
| ADP1822ARQZ-R7 | IC REG CTRLR BUCK PWM VM 24-QSOP |
| ADP1823ACPZ-R7 | IC REG CTRLR BUCK PWM VM 32LFCSP |
| ADP1828ACPZ-R7 | IC REG CTRLR BUCK PWM VM 20LFCSP |
| ADP1829ACPZ-R7 | IC REG CTRLR BUCK PWM VM 32LFCSP |
| ADP1850ACPZ-R7 | IC REG CTRLR BUCK PWM CM 32LFCSP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ADP1821-BL1-EVZ | 制造商:Analog Devices 功能描述:Evaluation Board For Step-Down DC-To-DC Controller 制造商:Analog Devices 功能描述:BLANK ADISIMPOWER EVAL ADP1821 - Boxed Product (Development Kits) |
| ADP1821-BL2-EVZ | 制造商:Analog Devices 功能描述:Evaluation Board For Step-Down DC-To-DC Controller 制造商:Analog Devices 功能描述:BLANK ADISIMPOWER EVAL ADP1821 - Boxed Product (Development Kits) |
| ADP1821-EVAL | 功能描述:电源管理IC开发工具 Evaluation Board I.C. RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:Battery Management 工具用于评估:MAX17710GB 输入电压: 输出电压:1.8 V |
| ADP1822 | 制造商:AD 制造商全称:Analog Devices 功能描述:PWM, Step-Down DC-to-DC Controller with Margining and Tracking |
| ADP1822ARQZ-R7 | 功能描述:IC REG CTRLR BUCK PWM VM 24-QSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:75 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.3 V ~ 13.5 V 降压:是 升压:是 回扫:是 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:0°C ~ 70°C 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:管件 产品目录页面:1051 (CN2011-ZH PDF) 其它名称:296-2543-5 |
发布紧急采购，3分钟左右您将得到回复。