参数资料
| 型号： | ATAM893T-TKQ |
| 厂商： | Atmel |
| 文件页数： | 30/98页 |
| 文件大小： | 0K |
| 描述： | IC MON TIRE-PRESS ATARX9X SER |
| 标准包装： | 4,000 |
| 系列： | MARC4 |
| 核心处理器： | MARC4 |
| 芯体尺寸： | 4-位 |
| 速度： | 4MHz |
| 连通性： | SSI（2 线，3 线） |
| 外围设备： | 欠压检测/复位，POR，PWM，WDT |
| 输入/输出数： | 16 |
| 程序存储器容量： | 4KB（4K x 8） |
| 程序存储器类型： | EEPROM |
| EEPROM 大小： | 64 x 16 |
| RAM 容量： | 256 x 4 |
| 电压 - 电源 (Vcc/Vdd)： | 1.8 V ~ 6.5 V |
| 振荡器型： | 内部 |
| 工作温度： | -40°C ~ 125°C |
| 封装/外壳： | 20-SOIC（0.209"，5.30mm 宽） |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页当前第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页
36
4680C–4BMCU–01/05
ATAM893-D
5.3.2
Timer 2
Timer 2 is an 8/12-bit timer used for:
Interrupt, square-wave, pulse and duty cycle generation
Baud-rate generation for the internal shift register
Manchester and Bi-phase modulation together with the SSI
Carrier frequency generation and modulation together with the SSI
Timer 2 can be used as interval timer for interrupt generation, as signal generator or as baud-
rate generator and modulator for the serial interface. It consists of a 4-bit and an 8-bit up counter
stage which both have compare registers. The 4-bit counter stages of Timer 2 are cascadable
as a 12-bit timer or as an 8-bit timer with a 4-bit prescaler. The timer can also be configured as
an 8-bit timer and separate a 4-bit prescaler.
The Timer 2 input can be supplied via the system clock, the external input clock (T2I), the Timer
1 output clock, the Timer 3 output clock or the shift clock of the serial interface. The external
input clock T2I is not synchronized with SYSCL. Therefore, it is possible to use Timer 2 with a
higher clock speed than SYSCL. Furthermore, with that input clock the Timer 2 operates in the
power-down mode SLEEP (CPU core
→sleep and OSC-Stop →yes) as well as in POWER-
DOWN (CPU core
→sleep and OSC-Stop →no). All other clock sources supply no clock signal in
SLEEP if NSTOP = 0. The 4-bit counter stages of Timer 2 have an additional clock output
(POUT).
Its output has a modulator stage that allows the generation of pulses as well as the generation
and modulation of carrier frequencies. The Timer 2 output can modulate with the shift register
data output to generate Bi-phase- or Manchester code.
If the serial interface is used to modulate a bit-stream, the 4-bit stage of Timer 2 has a special
task. The shift register can only handle bit-stream lengths divisible by 8. For other lengths, the
4-bit counter stage can be used to stop the modulator after the right bit-count is shifted out.
If the timer is used for carrier frequency modulation, the 4-bit stage works together with an addi-
tional 2-bit duty cycle generator like a 6-bit prescaler to generate carrier frequency and duty
cycle. The 8-bit counter is used to enable and disable the modulator output for a programmable
count of pulses.
For programming the time interval, the timer has a 4-bit and an 8-bit compare register. For pro-
gramming the timer function, it has four mode and control registers. The comparator output of
stage 2 is controlled by a special compare mode register (T2CM). This register contains mask
bits for the actions (counter reset, output toggle, timer interrupt) which can be triggered by a
compare match event or the counter overflow. This architecture enables the timer function for
various modes.
Table 5-7.
Watchdog Time Control Bits
WDT1
WDT0
Divider
Delay Time to Reset with
SUBCL = 32 kHz
Delay Time to Reset with
SYSCL = 2/1 MHz
0
512
15.625 ms
0.256 ms/0.512 ms
0
1
2048
62.5 ms
1.024 ms/2.048 ms
1
0
16384
0.5 s
8.2 ms/16.4 ms
1
131072
4 s
65.5 ms/131 ms
相关PDF资料 |
PDF描述 |
|---|---|
| TSC80251G2D-L16CER | IC MCU 8BIT 16MHZ LO VOLT 44VQFP |
| TSC87251G2D-L16CER | IC MCU 8BIT 32K OTP 16MHZ 44VQFP |
| PIC18F86K90-I/PTRSL | MCU PIC 64K FLASH XLP 80TQFP |
| 201692-4 | CONN HOUSING PLUG 104POS BLACK |
| 202800-2 | CONN HOUSING RECEPT 160POS BLACK |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ATAM893T-TKQYD | 功能描述:4位微控制器 - MCU Marc4 micrium 4 k FLASH RoHS:否 最大时钟频率:32 KHz/4 MHz 程序存储器大小:4 KB 封装 / 箱体:SSO-20 制造商:Atmel 核心:MARC4 数据总线宽度:4 bit 安装风格:SMD/SMT |
| ATAM893T-TKS | 功能描述:IC MON TIRE-PRESS ATARX9X SER RoHS:否 类别:集成电路 (IC) >> 嵌入式 - 微控制器， 系列:MARC4 标准包装:1,500 系列:AVR® ATtiny 核心处理器:AVR 芯体尺寸:8-位 速度:16MHz 连通性:I²C，LIN，SPI，UART/USART，USI 外围设备:欠压检测/复位，POR，PWM，温度传感器，WDT 输入/输出数:16 程序存储器容量:8KB（4K x 16） 程序存储器类型:闪存 EEPROM 大小:512 x 8 RAM 容量:512 x 8 电压 - 电源 (Vcc/Vdd):2.7 V ~ 5.5 V 数据转换器:A/D 11x10b 振荡器型:内部 工作温度:-40°C ~ 125°C 封装/外壳:20-SOIC（0.295"，7.50mm 宽） 包装:带卷 (TR) |
| ATAM893T-TKSYD | 功能描述:4位微控制器 - MCU Marc4 micrium 4k FLASH RoHS:否 最大时钟频率:32 KHz/4 MHz 程序存储器大小:4 KB 封装 / 箱体:SSO-20 制造商:Atmel 核心:MARC4 数据总线宽度:4 bit 安装风格:SMD/SMT |
| ATAM893X-TKHYZ | 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:Flash Version for ATAR080, ATAR090/890 and ATAR092/892 |
| ATAM893X-TKQYZ | 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:Flash Version for ATAR080, ATAR090/890 and ATAR092/892 |
发布紧急采购，3分钟左右您将得到回复。