参数资料
| 型号： | CS5376A-IQZ |
| 厂商： | Cirrus Logic Inc |
| 文件页数： | 6/49页 |
| 文件大小： | 0K |
| 描述： | IC FILTER DGTL MULTI-CH 64-TQFP |
| 标准包装： | 160 |
| 滤波器类型： | 数字 |
| 滤波器数： | 4 |
| 滤波器阶数： | 2nd |
| 电源电压： | 3 V ~ 5 V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 64-LQFP |
| 供应商设备封装： | 64-TQFP（10x10） |
| 包装： | 管件 |
| 配用： | 598-1778-ND - EVALUATION BOARD FOR CS5376 |
第1页第2页第3页第4页第5页当前第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页
2008 Fairchild Semiconductor Corporation
www.fairchildsemi.com
FUSB2805 Rev. 1.0.3
14
F
USB2
8
0
5
—
USB2
.0
High
-S
pee
d
OTG
Tra
nsc
e
iv
e
rw
ith
UL
P
I
Inter
fac
e
Link sends
TXCMD
CLOCK
D0-D7
STP
DIR
NXT
DATA
RXCMD
DATA
TXCMD
Turn
around
Turn
around
FUSB2805
accepts
TXCMD
Link sends
next data.
FUSB2805
accepts
Link signals
end of data
ULPI bus
is idle
FUSB2805
asserts DIR,
causing
turnaround cycle
FUSB2805
sends
RXCMD
(NXT low)
FUSB2805
sends USB
data
(NXT high)
FUSB2805
de-asserts DIR,
causing
turnaround cycle
Figure 8. ULPI Generic Data Transmit Followed by Data Receive
On power-up, the FUSB2805 performs an internal
power-on reset and asserts DIR to indicate to the link
that the ULPI bus cannot be used. When the internal
PLL is stable, the FUSB2805 de-asserts DIR. The
power-up time depends on the VCC supply rise time and
the PLL startup time (tstartPLL).
Whenever DIR is asserted, the FUSB2805 drives the
NXT pin LOW and must drive the data bus (D0-D7) with
RXCMD values. When DIR is de-asserted, the link must
drive the data bus (D0-D7) to the default LOW. Before
beginning USB packets, the FUSB2805 is reset by the
link setting the RESET bit in the function control
register. After the RESET bit is set, the FUSB2805
asserts DIR until the internal reset completes. The
FUSB2805 automatically de-asserts DIR and clears the
RESET bit when the reset has completed. After every
reset, an RX CMD is sent to the link to update USB
status information. After this sequence, the ULPI bus is
ready for use and the link can start USB operations.
If Chip_Select_N is de-asserted, the FUSB2805 is
retained in power-down mode, where all ULPI interface
pins are three-state, internal regulators are shut down,
and power consumption is reduced even further than in
low-power mode.
If low-power mode is entered due to no VIO, the
recommended power-up sequence for the link is:
1.
Connect VCC and VIO supplies.
2.
Chip_Select_N goes HIGH to LOW to enable the
FUSB2805.
3.
Link waits for at least tPWRUP, ignoring all ULPI pins
status.
4.
The link may start to detect DIR status level; if the
DIR is detected LOW, the link may send a reset
command.
5.
The ULPI interface is ready for use.
相关PDF资料 |
PDF描述 |
|---|---|
| CS61577-IL1Z | IC LINE INTERFACE T1/E1 28PLCC |
| CS61584A-IQ3Z | IC LINE INTERFACE T1/E1 64LQFP |
| CS61884-IRZ | IC LN INTERF T1/E1/J1 160-LFBGA |
| CS8130-CS | IC IR TRANSCEIVER 2-5V 20-SSOP |
| CS8190EDWF20G | IC TACH/SPEEDO DRVR PREC 20SOICW |
相关代理商/技术参数 |
参数描述 |
|---|---|
| CS5376A-IQZR | 功能描述:特殊用途放大器 LP Multi-Ch. Decimation Filter RoHS:否 制造商:Texas Instruments 通道数量:Single 共模抑制比（最小值）: 输入补偿电压: 工作电源电压:3 V to 5.5 V 电源电流:5 mA 最大功率耗散: 最大工作温度:+ 70 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:QFN-20 封装:Reel |
| CS5376-BQ | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| CS5378 | 制造商:CIRRUS 制造商全称:Cirrus Logic 功能描述:Low-power Single-channel Decimation Filter |
| CS5378_08 | 制造商:CIRRUS 制造商全称:Cirrus Logic 功能描述:Low-power Single-channel Decimation Filter |
| CS5378-IS | 功能描述:特殊用途放大器 IC LP Single-Ch Decimation Filter RoHS:否 制造商:Texas Instruments 通道数量:Single 共模抑制比（最小值）: 输入补偿电压: 工作电源电压:3 V to 5.5 V 电源电流:5 mA 最大功率耗散: 最大工作温度:+ 70 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:QFN-20 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。