- 您现在的位置：买卖IC网 > PDF目录1809 > IR3503MTRPBF (International Rectifier)IC CTRL XPHASE VR11.0/1 32-MLPQ PDF资料下载
参数资料
| 型号： | IR3503MTRPBF |
| 厂商： | International Rectifier |
| 文件页数： | 14/39页 |
| 文件大小： | 0K |
| 描述： | IC CTRL XPHASE VR11.0/1 32-MLPQ |
| 标准包装： | 1 |
| 系列： | XPhase3™ |
| 应用： | 处理器 |
| 电流 - 电源： | 8mA |
| 电源电压： | 4.75 V ~ 7.5 V |
| 工作温度： | 0°C ~ 100°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 32-VFQFN 裸露焊盘 |
| 供应商设备封装： | 32-MLPQ（5x5） |
| 包装： | 标准包装 |
| 其它名称： | IR3503MTRPBFDKR |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页当前第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页
IR3503
Current Sense Amplifier
A high speed differential current sense amplifier is located in the phase IC, as shown in Figure 7. Its gain is nominally
33 at 25oC, and the 3850 ppm/oC increase in inductor DCR should be compensated in the voltage loop feedback path.
The current sense amplifier can accept positive differential input up to 50mV and negative up to -10mV before clipping.
The output of the current sense amplifier is summed with the VDAC voltage and sent to the control IC and other
phases through an on-chip 3 k
resistor connected to the IIN pin. The IIN pins of all the phases are tied together and
the voltage on the share bus represents the average current through all the inductors and is used by the control IC for
voltage positioning and current limit protection. The input offset of this amplifier is calibrated to +/- 1mV in order to
reduce the current sense error.
The input offset voltage is the primary source of error for the current share loop. In order to achieve very small input
offset error and superior current sharing performance, the current sense amplifier continuously calibrates itself. This
21calibration algorithm creates ripple on IIN bus with a frequency of
f SW
32 * 28
in a multiphase architecture.
Average Current Share Loop
Current sharing between the phases of the converter is achieved by the average current share loop in each phase IC.
The output of the current sense amplifier is compared with average current at the share bus. If current in a phase is
smaller than the average current, the share adjust amplifier of the phase will pull down the starting point of the PWM
ramp thereby increasing its duty cycle and output current; if current in a phase is larger than the average current, the
share adjust amplifier of the phase will pull up the starting point of the PWM ramp thereby decreasing its duty cycle and
output current. The current share amplifier is internally compensated; such that, the crossover frequency of the current
share loop is much slower than that of the voltage loop and the two loops do not interact.
IR3503 THEORY OF OPERATION
Block Diagram
The block diagram of the IR3503 is shown in figure 10.
VID Control
The control IC allows the processor voltage to be set by a parallel eight bit digital VID bus. The VID codes set the
VDAC as shown in Table 1. The VID pins require an external bias voltage and should not be floated. The VID input
comparators monitor the VID pins and control the Digital-to-Analog Converter (DAC), whose output is sent to the
VDAC buffer amplifier. The output of the buffer amplifier is the VDAC pin. The VDAC voltage, input offsets of error
amplifier and remote sense differential amplifier are post-package trimmed to achieve 0.5 % system set-point accuracy
for VID range between 1 V to 1.6 V. A set-point accuracy of ± 5 mV and ± 8 mV is achieved for VID ranges of 0.8 V-1 V
and 0.5 V-0.8 V respectively. The actual VDAC voltage does not determine the system accuracy, which has a wider
tolerance.
The IR3503 can accept changes in the VID code while operating and vary the VDAC voltage accordingly. The slew
rate of the voltage at the VDAC pin can be adjusted by an external capacitor between VDAC pin and LGND pin. A
resistor connected in series with this capacitor is required to compensate the VDAC buffer amplifier. Digital VID
transitions result in a smooth analog transition of the VDAC voltage and converter output voltage minimizing inrush
currents in the input and output capacitors and overshoot of the output voltage.
Page 14 of 39
February 12, 2010
相关PDF资料 |
PDF描述 |
|---|---|
| IR3504MTRPBF | IC CTRL XPHASE3 SVID 32-MLPQ |
| IR3505MPBF | IC XPHASE3 CONTROL 16-MLPQ |
| IR3505ZMTRPBF | IC XPHASE3 CTLR 2.5A 16-MLPQ |
| IR3506MTRPBF | IC CTRL XPHASE3 DDR 16-MLPQ |
| IR3507MTRPBF | IC XPHASE3 CONTROL 20-MLPQ |
相关代理商/技术参数 |
参数描述 |
|---|---|
| IR3504MPBF | 制造商:International Rectifier 功能描述:Control IC 32-Pin MLPQ Strip |
| IR3504MTRPBF | 功能描述:开关变换器、稳压器与控制器 X-PHASE IR3504 AMD SVID CTRL IC RoHS:否 制造商:Texas Instruments 输出电压:1.2 V to 10 V 输出电流:300 mA 输出功率: 输入电压:3 V to 17 V 开关频率:1 MHz 工作温度范围: 安装风格:SMD/SMT 封装 / 箱体:WSON-8 封装:Reel |
| IR3505 | 制造商:IRF 制造商全称:International Rectifier 功能描述:XPHASE3TM PHASE IC |
| IR3505MPBF | 功能描述:IC XPHASE3 CONTROL 16-MLPQ RoHS:是 类别:集成电路 (IC) >> PMIC - 电源管理 - 专用 系列:XPhase3™ 应用说明:Ultrasound Imaging Systems Application Note 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:37 系列:- 应用:医疗用超声波成像，声纳 电流 - 电源:- 电源电压:2.37 V ~ 6 V 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:56-WFQFN 裸露焊盘 供应商设备封装:56-TQFN-EP（8x8） 包装:管件 |
| IR3505MTRPBF | 功能描述:开关变换器、稳压器与控制器 XPHASE3 DDR VTT 7V 2A 3 Wire RoHS:否 制造商:Texas Instruments 输出电压:1.2 V to 10 V 输出电流:300 mA 输出功率: 输入电压:3 V to 17 V 开关频率:1 MHz 工作温度范围: 安装风格:SMD/SMT 封装 / 箱体:WSON-8 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。