- 您现在的位置：买卖IC网 > PDF目录1809 > IR3522MTRPBF (International Rectifier)IC CTRL XPHASE3 DDR/VVT 32-MLPQ PDF资料下载
参数资料
| 型号： | IR3522MTRPBF |
| 厂商： | International Rectifier |
| 文件页数： | 19/32页 |
| 文件大小： | 0K |
| 描述： | IC CTRL XPHASE3 DDR/VVT 32-MLPQ |
| 标准包装： | 3,000 |
| 系列： | XPhase3™ |
| 应用： | 处理器 |
| 电流 - 电源： | 7mA |
| 电源电压： | 4.75 V ~ 7.5 V |
| 工作温度： | 0°C ~ 100°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 32-VFQFN 裸露焊盘 |
| 供应商设备封装： | 32-MLPQ（5x5） |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页当前第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页
IR3522
Remote Voltage Sensing
VOSEN X + and VOSEN X - are used for remote sensing and are connected directly to the load. The remote sense
differential amplifiers are high speed, have low input offset and low input bias currents to ensure accurate voltage
sensing and fast transient response.
Start-up Sequence
The IR3522 is designed as a chipset with the IR3506 Phase IC to achieve output voltage tracking. VOUT2’s
internal reference (VREF_TRACK) is generated by a divided-by-half internal resistor divider. This will ensure
VOUT2 remains half the value of VOUT1 preventing possible damage to some DDR system’s microprocessors. In
addition, a track-fault comparator is implemented to monitor both outputs which will further guarantee the outputs
remain at least 1.0 V apart and will generate a fault if this limit is surpassed, further protecting the DDR system.
When VCCL is applied to the IC and the SS/DEL is below 0.3V, IIN1 (only) is pulled up to VCCL through an internal
PFET enabling a diode emulation preset latch on the IR3506 phase IC. Diode emulation mode ensures proper
current sharing during system soft-start by turning off the bottom sync FET when negative inductor current is
sensed via the CSIN- and CSIN+ pins. The IIN1 pin is release once SS/DEL charges above 0.3 V. Once VOUT1
reaches 75% of its final operating value, the diode emulation mode is reset allowing the phase ICs to sink current.
The IR3522 has a programmable soft-start and soft-stop function. The soft-start helps limit the surge current during
the converter start-up, whereas the soft-stop is needed to maintain output tracking during system turn-off.
A
capacitor connected between the SS/DEL and LGND pins controls timing. A constant source and sink current
control the charge and discharge rates of the SS/DEL.
Figure 10 depicts the SVID start-up sequence. When the ENABLE input is asserted and there are no faults, the
SS/DEL pin will begin charging. If the IC receives a SVID communication prior to the ENABLE pin going high, the
output ramps up to the program value listed in Table 2, otherwise the VOUT1 and VOUT2 default to 1.5 V and 0.75
V, respectively. The error amplifier output, EAOUT x, is clamped low until SS/DEL reaches 1.4V. The error amplifier
will then regulate the converter’s output voltage to match the V(SS/DEL)-1.4V offset until the converter output
reaches the SVID code or default state. The SS/DEL voltage continues to increase until it rises above the threshold
of Delay Comparator where the PGOOD output is allowed to go high.
A low signal on the ENABLE or VID_OFF input immediately sets the fault latch, which causes the EAOUT pin to
drive low, thereby turning off the phase IC drivers. The PGOOD pin also drives low and SS/DEL discharges to 0.2V.
If the fault has cleared, the fault latch will be reset by the SS/DEL discharge comparator allowing another soft start
charge cycle to occur.
All other faults (See Table 5) will set a different fault latch that can only be reset by cycling ENABLE or the
VID_OFF SVID command. These faults discharge SS/DEL, pull down EAOUT X , pull up CROWBAR to VCCLDRV
and drive PGOOD low. The CROWBAR circuit is design to drive an external NMOS device to pull the output
voltage to ground. This feature minimizes negative voltage undershoots at the output by reducing sync FET current
during fault events.
The converter can be disabled by pulling the SS/DEL pins below 0.6V
Page 19
V3.01
相关PDF资料 |
PDF描述 |
|---|---|
| IR3523MTRPBF | IC XPHASE3 CTLR VR11.1 40-MLPQ |
| IR3527MTRPBF | IC CTRL XPHASE3 DUAL 24-MLPQ |
| IR3529MTRPBF | IC CTRL XPHASE CPU/ASIC 20-MLPQ |
| IR3550MTRPBF | IC DRIVER GATE 60A PQFN |
| IR3553MTRPBF | IC DRIVER GATE 40A PQFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| IR3523 | 制造商:IRF 制造商全称:International Rectifier 功能描述:XPHASE3TM DUAL OUTPUT CONTROL IC |
| IR3523MPBF | 制造商:IRF 制造商全称:International Rectifier 功能描述:XPHASE3TM DUAL OUTPUT CONTROL IC |
| IR3523MTRPBF | 功能描述:开关变换器、稳压器与控制器 X-PHASE IR3523 AMD SVID CTRL IC RoHS:否 制造商:Texas Instruments 输出电压:1.2 V to 10 V 输出电流:300 mA 输出功率: 输入电压:3 V to 17 V 开关频率:1 MHz 工作温度范围: 安装风格:SMD/SMT 封装 / 箱体:WSON-8 封装:Reel |
| IR3527 | 制造商:IRF 制造商全称:International Rectifier 功能描述:XPHASE3TM DUAL PHASE IC |
| IR3527MPBF | 制造商:IRF 制造商全称:International Rectifier 功能描述:XPHASE3TM DUAL PHASE IC |
发布紧急采购，3分钟左右您将得到回复。