参数资料
型号: IR3522MTRPBF
厂商: International Rectifier
文件页数: 2/32页
文件大小: 0K
描述: IC CTRL XPHASE3 DDR/VVT 32-MLPQ
标准包装: 3,000
系列: XPhase3™
应用: 处理器
电流 - 电源: 7mA
电源电压: 4.75 V ~ 7.5 V
工作温度: 0°C ~ 100°C
安装类型: 表面贴装
封装/外壳: 32-VFQFN 裸露焊盘
供应商设备封装: 32-MLPQ(5x5)
包装: 带卷 (TR)
IR3522
ORDERING INFORMATION
Device
IR3522MTRPBF
* IR3522MPBF
* Samples only
PIN DESCRIPTION
Package
32 Lead MLPQ (5 x 5 mm body)
32 Lead MLPQ (5 x 5 mm body)
Order Quantity
3000 per reel
100 piece strips
Reference voltage programmed by the I C inputs and error amplifier non-inverting
PIN#
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
PIN SYMBOL
SDA
PGBIAS
ENABLE
IIN2
ADDR1
ADDR2
OCSET2
EAOUT2
FB2
VOUT2
VOSEN2+
VOSEN2-
VOSEN1-
VOSEN1+
VOUT1
FB1
EAOUT1
OCSET1
VREF1
SS/DEL1
PIN DESCRIPTION
SDA (Serial Data) is a bidirectional signal that is an input and open drain output for
both master (I 2 C controller) and slave (IR3522). SDA requires a pull resistor to a
bias voltage and should not be floated.
Input to provide bias to the Power Good output transistor directly from the converter
input voltage. Enables the Power Good output to assert even if there is no bias
supplied to the VCCL pin. Internal voltage clamp protects the pin. Do not exceed
100 uA of pull-up current.
Enable input. A logic low applied to this pin puts the IC into fault mode. A logic high
on the pin resets and enables the converter. Do not float this pin as the logic state
will be undefined.
Output 2 average current input from the output 2 phase IC(s).
Digital input to program bit 1 of the 2 bit address code with internal pull-up. Connect
to LGND for logic “0”, float for logic “1”
Digital input to program bit 2 of the 2 bit address code with internal pull-up. Connect
to LGND for logic “0”, float for logic “1”
Programs the output 2 constant converter output current limit through an external
resistor tied to VREF1 and an internal current source from this pin. Over-current
protection can be disabled by over sizing the resistor value to program the threshold
higher than IIN2 pin possible signal amplitude, but no greater than 5V (do not float
this pin as improper operation will occur).
Output of the output 2 error amplifier.
Inverting input to the output 2 error amplifier.
Output 2 remote sense amplifier output.
Output 2 remote sense amplifier input. Connect to output at the load.
Output 2 remote sense amplifier input. Connect to ground at the load.
Output 1 remote sense amplifier input. Connect to ground at the load.
Output 1 remote sense amplifier input. Connect to output at the load.
Output 1 remote sense amplifier output. Provides reference to Error Amp2.
Inverting input to the output 1 error amplifier.
Output of the output 1 error amplifier.
Programs the output 1 constant converter output current limit through an external
resistor tied to VREF1 and an internal current source from this pin. Over-current
protection can be disabled by over sizing the resistor value to program the threshold
higher than IIN2 pin possible signal amplitude, but no greater than 5V (do not float
this pin as improper operation will occur).
2
input. Connect an external RC network to LGND to program dynamic VID slew rate
and provide compensation for the internal buffer amplifier.
Connect an external capacitor to LGND to program startup and Fault delay timing
Page 2
V3.01
相关PDF资料
PDF描述
IR3523MTRPBF IC XPHASE3 CTLR VR11.1 40-MLPQ
IR3527MTRPBF IC CTRL XPHASE3 DUAL 24-MLPQ
IR3529MTRPBF IC CTRL XPHASE CPU/ASIC 20-MLPQ
IR3550MTRPBF IC DRIVER GATE 60A PQFN
IR3553MTRPBF IC DRIVER GATE 40A PQFN
相关代理商/技术参数
参数描述
IR3523 制造商:IRF 制造商全称:International Rectifier 功能描述:XPHASE3TM DUAL OUTPUT CONTROL IC
IR3523MPBF 制造商:IRF 制造商全称:International Rectifier 功能描述:XPHASE3TM DUAL OUTPUT CONTROL IC
IR3523MTRPBF 功能描述:开关变换器、稳压器与控制器 X-PHASE IR3523 AMD SVID CTRL IC RoHS:否 制造商:Texas Instruments 输出电压:1.2 V to 10 V 输出电流:300 mA 输出功率: 输入电压:3 V to 17 V 开关频率:1 MHz 工作温度范围: 安装风格:SMD/SMT 封装 / 箱体:WSON-8 封装:Reel
IR3527 制造商:IRF 制造商全称:International Rectifier 功能描述:XPHASE3TM DUAL PHASE IC
IR3527MPBF 制造商:IRF 制造商全称:International Rectifier 功能描述:XPHASE3TM DUAL PHASE IC