- 您现在的位置：买卖IC网 > PDF目录20668 > ISL6236EVAL2 (Intersil)EVAL BOARD 2 FOR ISL6236 PDF资料下载
参数资料
| 型号： | ISL6236EVAL2 |
| 厂商： | Intersil |
| 文件页数： | 29/35页 |
| 文件大小： | 0K |
| 描述： | EVAL BOARD 2 FOR ISL6236 |
| 标准包装： | 1 |
| 系列： | * |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页当前第29页第30页第31页第32页第33页第34页第35页
ISL6236
OVERVOLTAGE PROTECTION
When the output voltage of V OUT1 is 11% (16% for V OUT2 )
above the set voltage, the overvoltage fault protection
activates. This latches on the synchronous rectifier MOSFET
with 100% duty cycle, rapidly discharging the output
capacitor until the negative current limit is achieved. Once
negative current limit is met, UGATE is turned on for a
minimum ON-time, followed by another LGATE pulse until
negative current limit. This effectively regulates the
discharge current at the negative current limit in an effort to
prevent excessively large negative currents that cause
potentially damaging negative voltages on the load. Once an
overvoltage fault condition is set, it can only be reset by
toggling SHDN, EN, or cycling VIN (POR).
UNDERVOLTAGE PROTECTION
When the output voltage drops below 70% of its regulation
voltage for at least 100μs, the controller sets the fault latch
UVP is ignored for at least 20ms (typical), after start-up or
after a rising edge on EN. Toggle EN or cycle VIN (POR) to
clear the undervoltage fault latch and restart the controller.
UVP only applies to the buck outputs.
THERMAL PROTECTION
The ISL6236 has thermal shutdown to protect the devices
from overheating. Thermal shutdown occurs when the die
temperature exceeds +150°C. All internal circuitry shuts
down during thermal shutdown. The ISL6236 may trigger
thermal shutdown if LDO is not bootstrapped from OUT
while applying a high input voltage on V IN and drawing the
maximum current (including short circuit) from LDO. Even if
large power dissipation on the bootstrap switches, which
may result in thermal shutdown. Cycling EN, EN LDO, or
VIN (POR) ends the thermal-shutdown state.
Discharge Mode (Soft-Stop)
When a transition to standby or shutdown mode occurs, or
the output undervoltage fault latch is set, the outputs
discharge to GND through an internal 25 Ω switch. The
reference remains active to provide an accurate threshold
and to provide overvoltage protection.
Shutdown Mode
The ISL6236 SMPS1, SMPS2 and LDO have independent
enabling control. Drive EN1, EN2 and EN LDO below the
precise input falling-edge trip level to place the ISL6236 in its
low-power shutdown state. The ISL6236 consumes only
20μA of quiescent current while in shutdown. When
shutdown mode activates, the 3.3V VREF3 remain on. Both
SMPS outputs are discharged to 0V through a 25 Ω switch.
Power-Up Sequencing and On/Off Controls (EN)
EN1 and EN2 control SMPS power-up sequencing. EN1 or
EN2 rising above 2.4V enables the respective outputs. EN1
or EN2 falling below 1.6V disables the respective outputs.
Connecting EN1 or EN2 to REF will force its outputs off while
the other output is below regulation. The sequenced SMPS
will start once the other SMPS reaches regulation. The
second SMPS remains on until the first SMPS turns off, the
device shuts down, a fault occurs or PVCC goes into
undervoltage lockout. Both supplies begin their power-down
sequence immediately when the first supply turns off. Driving
EN below 0.8V clears the overvoltage, undervoltage and
thermal fault latches.
LDO is bootstrapped from OUT, overloading the LDO causes
TABLE 3. OPERATING-MODE TRUTH TABLE
MODE
Power-Up
Run
Overvoltage
Protection
Undervoltage
Protection
Discharge
Standby
Shutdown
Thermal Shutdown
CONDITION
PVCC < UVLO threshold.
EN LDO = high, EN1 or EN2
enabled.
Either output > 111% (VOUT1) or
116% (VOUT2) of nominal level.
Either output < 70% of nominal after
20ms time-out expires and output is
enabled.
Either SMPS output is still high in
either standby mode or shutdown
mode
EN1, EN2 < startup threshold, EN
LDO = High
EN1, EN2, EN LDO = low
TJ > +150°C
29
COMMENT
Transitions to discharge mode after a VIN POR and after REF becomes valid. LDO,
VREF3, and REF remain active.
Normal operation
LGATE is forced high. LDO, VREF3 and REF active. Exited by a VIN POR, or by
toggling EN1 or EN2.
The internal 25 Ω switch turns on. LDO, VREF3 and REF are active. Exited by a VIN
POR or by toggling EN1 or EN2.
Discharge switch (25 Ω ) connects OUT to GND. One output may still run while the
other is in discharge mode. Activates when PVCC is in UVLO, or transition to UVLO,
standby, or shutdown has begun. LDO, VREF3 and REF active.
LDO, VREF3 and REF active.
Discharge switch (25 Ω ) connects OUT to PGND. All circuitry off except VREF3.
All circuitry off. Exited by VIN POR or cycling EN. VREF3 remain active.
FN6373.6
April 29, 2010
相关PDF资料 |
PDF描述 |
|---|---|
| VE-BN2-EU-F1 | CONVERTER MOD DC/DC 15V 200W |
| ISL6605CBZA-T | IC MOSFET DRVR SYNC BUCK 8-SOIC |
| ACB70DHLD | CONN EDGECARD 140PS .050 DIP SLD |
| TC1303A-PP3EUN | IC REG DL BCK/LINEAR SYNC 10MSOP |
| M7WXK-0910J | D-SUB CABLE - MFU09K/MC10G/X |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL6236IRZA | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:High-Efficiency, Quad-Output, Main Power Supply Controllers for Notebook Computers |
| ISL6236IRZAR5281 | 功能描述:IC MAIN PWR CTRLR QUAD 32-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件 |
| ISL6236IRZA-T | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:High-Efficiency, Quad-Output, Main Power Supply Controllers for Notebook Computers |
| ISL6236IRZA-TKR5281 | 功能描述:IC QUAD OUT POWER CONTROL 32-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:2,000 系列:- 应用:控制器，DSP 输入电压:4.5 V ~ 25 V 输出数:2 输出电压:最低可调至 1.2V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:30-TFSOP（0.173"，4.40mm 宽） 供应商设备封装:30-TSSOP 包装:带卷 (TR) |
| ISL6236IRZA-TR5281 | 功能描述:IC MAIN PWR CTRLR QUAD 32-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件 |
发布紧急采购，3分钟左右您将得到回复。