参数资料
| 型号： | ISL78220ANEZ-T |
| 厂商： | Intersil |
| 文件页数： | 14/22页 |
| 文件大小： | 0K |
| 描述： | IC PWM CONTROLLER |
| 标准包装： | 1,000 |
| 系列： | * |
ISL78220
feature to pre-bias the V SS based on V FB information during this
time. The duration time for t 5 is around 50μs.
After t 5 the soft-start process will begin. The following section will
discuss the soft-start in detail for different applications.
V
Vfb
SOFT-START WAVEFORM (CASE A)
DIODE EMULATION
Soft-Start Process for Different
Modes (Refer to Table 1)
At the beginning of soft-start, the SS pin voltage will start ramping
up from a voltage equaling to FB voltage. The soft-start period ends
when the SS pin voltage reaches the lower power-good threshold
that is 80% of the lower value of VREF2 or 2V.
Case A (V MODE = VCC, V PWM_TRI = VCC)
Figure 15 shows the pre-bias start-up PWM waveform for case A
in Table 1. The V PWM_TRI = VCC so that PWM can output tri-level
signal, which the external drivers need to identify, and
V MODE = VCC to ban the automatic phase dropping function.
0
V
5V
2.5V
0
5V
2.5V
Vref
t4
t5
NOTE: t4, t5 PERIOD ARE FROM FIGURE 5
t6 t7
SYNCHRONOUS
OPERATION
LOWER FET TURN ON
SYNCHRONOUS
DIODE EMULATION
OPERATION
(PWM_INV = 0)
PWM
(PWM_INV = 1)
PWM
Time t 4 , t 5 : Same as the t 4 , t 5 in Figure 14, soft-start has not started
yet. See “Operation Initialization Before Soft-Start” on page 13 for a
detailed description.
0
Time t 6 : At the beginning of t 6 the SS pin has already been
pre-biased to a value very close to the V FB , so that the internal
reference signal will start from the voltage close to FB pin. This
scheme will eliminate the internal delay for a non pre-biased
5V
DRIVE_EN
application.
The DRIVE_EN pin, which is connected to the enable pins of the
external drivers, will be pulled high when first PWM toggles at the
beginning of t 6, as a results external drivers will start working.
The PWM signals will switch between tri-level and low. The driver
will only turn on the lower MOSFET accordingly, and the duty
cycle will increase gradually from 0 to steady state. The
synchronous MOSFET (Upper FET for Boost converter) will never
turn on during this time, so diode emulation can be achieved
during the start-up and in turn prevent negative current flowing
from output to input.
Time t 7 : Soft-start finishes at the beginning of t 7 . The PWMs will
change to a 2-level 0V to 5V switching signal and the
synchronous MOSFET will be turned on.
14
0
FIGURE 15. SOFT-START WAVEFORM (CASE A)
Case B (V MODE < 4V, V PWM_TRI = VCC, Light
Load Condition)
The only difference between the case A and case B start-up
waveforms is that at light load, case B can drop phases and have
cycle-by-cycle diode emulation at PWM1 and PWM2.
For the case B applications, where good light load efficiency is
always preferred, the ISL78220 provides three light load
efficiency enhancement methods. When the load current
reduces, the ISL78220 will first assert the automatic phase
dropping function to reduce the active phase number according
to the load level. The minimum active phase number is two. If the
load current further reduces even when running at two-phase
operation, the ISL78220 will assert a second method by utilizing
cycle-by-cycle diode emulation. During this time the IC will sense
the inductor current, and when the current is approximately zero
it will turn off the synchronous MOSFET. If the load current is
further reduced to deep light load operation, pulse skipping
function will kick in to optimize the overall efficiency.
FN7688.3
December 24, 2013
相关PDF资料 |
PDF描述 |
|---|---|
| ISL78225ANEZ-T | IC PWM CONTROLLER |
| ISL78228ARZ | IC REG BUCK SYNC ADJ DL 10-DFN |
| ISL78301FVEAZ | IC REG LDO 3.3V .15A 14HTSSOP |
| ISL78302AARBJZ | IC REG LDO 1.5V/2.8V .3A 10DFN |
| ISL78307FBECZ | IC REG LDO ADJ 50MA 8SOIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL78220ANZ-T | 制造商:Intersil Corporation 功能描述:AUTOMOTIVE GRADE 6-PHASE BOOST PWM CONTROLLER - 44LD TQFP PB - Tape and Reel |
| ISL78220EVAL1Z | 制造商:Intersil Corporation 功能描述:ISL78220 EVALUATION BOARD 1 - 44 LEAD - TQFP - ROHS COMPLIAN - Bulk |
| ISL78223 | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:ZVS Full-Bridge PWM Controller with Adjustable Synchronous Rectifier Control |
| ISL78223AAZ | 功能描述:电流型 PWM 控制器 ZVS Full Bridge PWM Controller Adj Rect. RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
| ISL78223AAZ-T | 制造商:Intersil Corporation 功能描述:ZVS FULL BRIDGE PWM CONTROLLER, 20LD QSOP, PB-FREE W/ ANNEAL - Tape and Reel 制造商:Intersil Corporation 功能描述:IC REG CTRLR PWM ISOLATED 20QSOP 制造商:Intersil 功能描述:ZVS Full Bridge PWM- Controller Adj Rect. |
发布紧急采购，3分钟左右您将得到回复。