参数资料
| 型号： | ISL78220ANEZ-T |
| 厂商： | Intersil |
| 文件页数： | 16/22页 |
| 文件大小： | 0K |
| 描述： | IC PWM CONTROLLER |
| 标准包装： | 1,000 |
| 系列： | * |
ISL78220
5X 10
V
SR SS = ----------------------- ? ------ ?
C SS
Soft-Start Ramp Slew Rate
Calculation
The soft-start ramp slew rate SR SS is determined by the capacitor
value C SS from SS pin to GND. C SS can be calculated based on
Equation 3:
– 12
(EQ. 3)
? μ s ?
Figure 18 shows the relationship between C SS and SR SS .
5.0
4.5
4.0
3.5
3.0
2.5
2.0
1.5
1.0
0.5
0
The maximum frequency at each PWM output is 1MHz. If the FS
pin is accidentally shorted to GND or connected to a low
impedance node, the internal circuits will detect this fault
condition and fold back the switching frequency to the 75kHz
minimal value.
The ISL78220 contains a phase lock loop (PLL) circuit and has
frequency synchronization capability by simply connecting SYNC
pin to an external square pulse waveform (typically 20% to 80%
duty cycle). In normal operation, the external SYNC frequency
needs to be at least 20% faster than the internal oscillator
frequency setting. The ISL78220 will synchronize its switching
frequency to the fundamental frequency of the input waveform.
The frequency synchronization feature will synchronize the rising
edge of the PWM1 clock signal with the rising edge of the
external clock signal at the SYNC pin.
The PLL is compensated with a series resistor-capacitor (Rc and
Cc) from the PLL_COMP pin to GND and a capacitor (Cp) from
PLL_COMP to GND. Typical values are Rc = 6.8k Ω , Cc = 6.8nF,
Cp = 1nF. The typical lock time is around 0.5ms.
The CLK_OUT pin provides a square pulse waveform at the
switching frequency. The amplitude is 5V with approximately
1
10
Css (nF)
FIGURE 18. SOFT- START CAPACITOR vs SLEW RATE
100
40% positive duty cycle, and the rising edge is synchronized with
the leading edge of PWM1.
Oscillator and Synchronization
The switching frequency is determined by the selection of the
frequency-setting resistor, R FS , connected from FS pin to GND.
Equation 4 is provided to assist in selecting the correct resistor
value.
Current Sensing
The ISL78220 senses the current continuously for fast response.
It supports both sense resistor and inductor DCR current sensing
methods. The sensed current for each active channel will be used
for loop control, phase current balance, individual channel
overcurrent protection and total average current protection. The
10 ? 1
---------- – 5X 10 ?
? f ?
R FS = 4X 10
SW
– 8
(EQ. 4)
internal circuitry, shown in Figures 20 and 21, represents a single
channel. This circuitry is repeated for each channel, but may not
be active depending on the status of the PWM3, PWM4, PWM5,
where f SW is the switching frequency of each phase. Figure 19
shows the relationship between Rfs and switching frequency.
1000
900
800
700
600
500
400
300
200
and PWM6 pin voltage.
Peak current mode control is implemented by feeding back the
current output of the current sense amplifier (CSA) to the
regulator control loop. Individual channel peak current limit is
implemented by comparing the CSA output current with 160μA.
When the peak current limit comparator is tripped, the PWM
on-pulse is terminated and the IC is latched off.
Sense Resistor Current Sensing
A sense resistor can be placed in series with the power inductor.
As shown in Figure 20, The ISL78220 acquires the channel
current information by sensing the voltage signal across the
sense resistor. Because the voltage on both the positive input
100
0
0
100
200
300
400
500
600
and the negative input of CSA are forced to be equal, the voltage
across R SET is equivalent to the voltage drop across the R SEN
resistor. The resulting current into the ISENxP pin is proportional
I SEN = I L ? ----------------
R SEN
R FS (k Ω )
FIGURE 19. R FS vs SWITCHING FREQUENCY
16
to the channel current, I L . Equation 5 for I SEN is derived where I L
is the channel current:
(EQ. 5)
R I SE T
FN7688.3
December 24, 2013
相关PDF资料 |
PDF描述 |
|---|---|
| ISL78225ANEZ-T | IC PWM CONTROLLER |
| ISL78228ARZ | IC REG BUCK SYNC ADJ DL 10-DFN |
| ISL78301FVEAZ | IC REG LDO 3.3V .15A 14HTSSOP |
| ISL78302AARBJZ | IC REG LDO 1.5V/2.8V .3A 10DFN |
| ISL78307FBECZ | IC REG LDO ADJ 50MA 8SOIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL78220ANZ-T | 制造商:Intersil Corporation 功能描述:AUTOMOTIVE GRADE 6-PHASE BOOST PWM CONTROLLER - 44LD TQFP PB - Tape and Reel |
| ISL78220EVAL1Z | 制造商:Intersil Corporation 功能描述:ISL78220 EVALUATION BOARD 1 - 44 LEAD - TQFP - ROHS COMPLIAN - Bulk |
| ISL78223 | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:ZVS Full-Bridge PWM Controller with Adjustable Synchronous Rectifier Control |
| ISL78223AAZ | 功能描述:电流型 PWM 控制器 ZVS Full Bridge PWM Controller Adj Rect. RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
| ISL78223AAZ-T | 制造商:Intersil Corporation 功能描述:ZVS FULL BRIDGE PWM CONTROLLER, 20LD QSOP, PB-FREE W/ ANNEAL - Tape and Reel 制造商:Intersil Corporation 功能描述:IC REG CTRLR PWM ISOLATED 20QSOP 制造商:Intersil 功能描述:ZVS Full Bridge PWM- Controller Adj Rect. |
发布紧急采购，3分钟左右您将得到回复。