参数资料
型号: LT1737IS#TRPBF
厂商: Linear Technology
文件页数: 16/28页
文件大小: 0K
描述: IC REG CTRLR FLYBK ISO CM 16SOIC
标准包装: 2,500
PWM 型: 电流模式
输出数: 1
频率 - 最大: 125kHz
占空比: 90%
电源电压: 4.1 V ~ 20 V
降压:
升压:
回扫:
反相:
倍增器:
除法器:
Cuk:
隔离:
工作温度: -40°C ~ 125°C
封装/外壳: 16-SOIC(0.154",3.90mm 宽)
包装: 带卷 (TR)
LT1737
APPLICATIO S I FOR ATIO
this frequency the sense resistor will behave like an
inductor.
Several techniques can be used to tame this potential
parasitic inductance problem. First, any resistor used for
current sensing purposes must be of an inherently non-
inductive construction. Mounting this resistor directly
above an unbroken ground plane and minimizing its
ground side connection will serve to absolutely minimize
parasitic inductance. In the case of low valued sense
resistors, these may be implemented as a parallel combi-
nation of several resistors for the thermal considerations
cited above. The parallel combination will help to lower the
parasitic inductance. Finally, it may be necessary to place
a “pole” between the current sense resistor and the
LT1737 I SENSE pin to undo the action of the inductive zero
(see Figure 5). A value of 51 ? is suggested for the resistor,
while the capacitor is selected empirically for the particular
application and layout. Using good high frequency mea-
surement techniques, the I SENSE pin waveform may be
observed directly with an oscilloscope while the capacitor
value is varied.
threshold is deliberately set at a V BE plus several hundred
millivolts.) When this condition is removed, a nominal
40 μ A current acts to charge up the SFST node towards
roughly 3V. So, for example, a 0.1 μ F soft-start capacitor
will place a 0.4V/ms limit on the ramp rate at the V C node.
UVLO PIN FUNCTION
The UVLO pin effects both undervoltage lockout and
shutdown functions. This is accomplished by using differ-
ent voltage thresholds for the two functions—the shut-
down function is at roughly a V BE above ground (0.75V at
25 ° C, large temperature variation), while the UVLO func-
tion is at nearly a bandgap voltage (1.25V, fairly stable with
temperature). An external resistor divider between the
input supply and ground can then be used to achieve a
user-programmable undervoltage lockout (see Figure 6a).
An additional feature of this pin is that there is a change in
the input bias current at this pin as a function of the state
of the internal UVLO comparator. As the pin is brought
above the UVLO threshold, the bias current sourced by the
part increases. This positive feedback effects a hysteresis
f = SENSE
2 π (51 ? )C COMP
R SENSE (51 ? )
GATE
I SENSE
SGND PGND
51 ?
C COMP
PARASITIC
INDUCTANCE
R SENSE
L P
1737 F05
SENSE RESISTOR ZERO AT:
R
2 π L P
COMPENSATING POLE AT:
1
f=
FOR CANCELLATION:
L P
C COMP =
band for reliable switching action. Note that the size of the
hysteresis is proportional to the Thevenin impedance of
the external UVLO resistor divider network, which makes
it user programmable. As a rough rule of thumb, each 4k
or so of impedance generates about 1% of hysteresis.
(This is based on roughly 1.25V for the threshold and 3 μ A
for the bias current shift.)
Even in good quality ground plane layouts, it is common
Figure 5
SOFT-START FUNCTION
The LT1737 contains an optional soft-start function that is
enabled by connecting an explicit external capacitor be-
tween the SFST pin and ground. Internal circuitry prevents
the control voltage at the V C pin from exceeding that on the
SFST pin.
The soft-start function is enagaged whenever V CC power
is removed, or as a result of either undervoltage lockout
or thermal (overtemperature) shutdown. The SFST node
is then discharged rapidly to roughly a V BE above ground.
(Remember that the V C pin control node switching
for the switching node (MOSFET drain) to couple to the
UVLO pin with a stray capacitance of several thousandths
of a pF. To ensure proper UVLO action, a 100pF capacitor
is recommended from this pin to ground as shown in
Figure 6b. This will typically reduce the coupled noise to
a few millivolts. The UVLO filter capacitor should not be
made much larger than a few hundred pF, however, as the
hysteresis action will become too slow. In cases where
further filtering is required, e.g., to attenuate high speed
supply ripple, the topology in Figure 6c is recommended.
Resistor R1 has been split into two equal parts. This
provides a node for effecting capacitor filtering of high
speed supply ripple, while leaving the UVLO pin node
impedance relatively unchanged at high frequency.
1737fa
16
相关PDF资料
PDF描述
ASC06DRYN-S93 CONN EDGECARD 12POS DIP .100 SLD
MIC2198YML IC REG CTRLR BUCK PWM CM 12-MLF
SRP1235-R33M INDUCTOR 330NH 36.5A SMD
LTC3832-1ES8#TRPBF IC REG CTRLR BUCK PWM VM 8-SOIC
LTC3832-1ES8#TR IC REG CTRLR BUCK PWM VM 8-SOIC
相关代理商/技术参数
参数描述
LT1738 制造商:LINER 制造商全称:Linear Technology 功能描述:Slew Rate Controlled Ultralow Noise DC/DC Controller
LT1738EG 功能描述:IC REG CTRLR PWM CM 20-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR)
LT1738EG#PBF 功能描述:IC REG CTRLR PWM CM 20-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR
LT1738EG#TR 功能描述:IC REG CTRLR PWM CM 20-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR)
LT1738EG#TRPBF 功能描述:IC REG CTRLR PWM CM 20-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR)