参数资料
型号: LT3510EFE#PBF
厂商: Linear Technology
文件页数: 20/30页
文件大小: 0K
描述: IC REG BUCK ADJ 2A DL 20TSSOP
标准包装: 74
类型: 降压(降压)
输出类型: 可调式
输出数: 2
输出电压: 0.8 V ~ 23.8 V
输入电压: 3.1 V ~ 25 V
PWM 型: 电流模式
频率 - 开关: 250kHz ~ 1.5MHz
电流 - 输出: 2A
同步整流器:
工作温度: -40°C ~ 125°C
安装类型: 表面贴装
封装/外壳: 20-TSSOP(0.173",4.40mm 宽)裸露焊盘
包装: 管件
供应商设备封装: 20-TSSOP-EP
产品目录页面: 1332 (CN2011-ZH PDF)
LT3510
APPLICATIONS INFORMATION
If the synchronization signal powers up in a high impedance
state (Hi-Z), connect a resistor from the R T /SYNC pin to
ground. The equivalent resistance seen from the R T /SYNC
pin to ground will set the start-up frequency.
defaults the open-pin condition to be operating (see Typical
Performance Characteristics). Current hysteresis is added
above the SHDN threshold. This can be used to set voltage
hysteresis of the UVLO using the following:
+ 3 μ A
If the synchronization signal changes between high and
low impedance states during power up (V OL , Hi-Z), connect
the synchronization circuitry to the LT3510 as shown in
the Typical Applications section. This will allow the LT3510
to start-up with a switching frequency determined by the
equivalent resistance from the R T /SYNC pin to ground.
R1 =
R2 =
V H – V L
7 μ A
1.28
V H – 1.28
R1
Shutdown and Undervoltage Lockout
Figure 8 shows how to add undervoltage lockout (UVLO)
to the LT3510. Typically, UVLO is used in situations where
the input supply is current limited, or has a relatively high
source resistance. A switching regulator draws constant
power from the source, so source current increases as
V H = Turn-on threshold
V L = Turn-off threshold
Example: switching should not start until the input is above
4.75V and is to stop if the input falls below 3.75V.
V H = 4.75V
R1 =
sourcevoltagedrops.Thislookslikeanegativeresistance
load to the source and can cause the source to current limit
or latch low under low source voltage conditions. UVLO
prevents the regulator from operating at source voltages
V L = 3.75V
4.75 – 3.75
7 μ A
? 143k
where these problems might occur.
An internal comparator will force the part into shutdown
below the minimum V IN1 of 2.8V. This feature can be
used to prevent excessive discharge of battery-operated
R2 =
1.28
4.75 – 1.28
143k
+ 3 μ A
? 47k
systems.
Since V IN2 supplies the output stage of channel 2 and is
not monitored, care must be taken to insure that V IN2 is
present before channel 2 is allowed to switch.
If an adjustable UVLO threshold is required, the SHDN
pin can be used. The threshold voltage of the SHDN
pin comparator is 1.28V. A 3μA internal current source
Keep the connections from the resistors to the SHDN
pin short and make sure that the interplane or surface
capacitance to switching nodes is minimized. If high re-
sistor values are used, the SHDN pin should be bypassed
with a 1nF capacitor to prevent coupling problems from
the switch node.
Soft-Start
V IN1 > 2.8V
LT3510
V IN1
The output of the LT3510 regulates to the lowest voltage
present at either the SS pin or an internal 0.8V reference.
A capacitor from the SS pin to ground is charged by an
V IN1 OR V IN2
R1
SHDN
3μA
7μA
+
1.28V
INTERNAL
REGULATOR
internal 3.25μA current source resulting in a linear output
ramp from 0V to the regulated output whose duration is
given by:
C1
R2
3510 F08
t RAMP =
C SS ? 0.8V
3.25 μ A
Figure 8. Undervoltage Lockout
3510fe
20
相关PDF资料
PDF描述
LT3686HDD#PBF IC REG BUCK ADJ 1.2A 10-DFN
380LX123M016H022 CAP ALUM 12000UF 16V 20% SNAP
EGM28DTKH CONN EDGECARD 56POS DIP .156 SLD
ECO-S1KA562EA CAP ALUM 5600UF 80V 20% SNAP
LT1308ACS8#PBF IC REG BOOST 5V 1A 8SOIC
相关代理商/技术参数
参数描述
LT3510EFE-TR 制造商:LINER 制造商全称:Linear Technology 功能描述:Monolithic Dual Tracking 2A Step-Down Switching Regulator
LT3510EFE-TRPBF 制造商:LINER 制造商全称:Linear Technology 功能描述:Monolithic Dual Tracking 2A Step-Down Switching Regulator
LT3510FE 制造商:LINER 制造商全称:Linear Technology 功能描述:Monolithic Dual Tracking 2A Step-Down Switching Regulator
LT3510IFE 制造商:Linear Technology 功能描述:Conv DC-DC Dual Step Down 3.1V to 25V 20-Pin TSSOP EP
LT3510IFE#PBF 功能描述:IC REG BUCK ADJ 2A DL 20TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 产品培训模块:MIC23xxx HyperLight Load™ Regulators 标准包装:5,000 系列:HyperLight Load® 类型:降压(降压) 输出类型:固定 输出数:1 输出电压:1.8V 输入电压:2.7 V ~ 5.5 V PWM 型:混合物 频率 - 开关:4MHz 电流 - 输出:2A 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘,8-MLF? 包装:带卷 (TR) 供应商设备封装:8-MLF?(2x2) 产品目录页面:1094 (CN2011-ZH PDF) 其它名称:576-3303-2