参数资料
型号: LT3510EFE#PBF
厂商: Linear Technology
文件页数: 25/30页
文件大小: 0K
描述: IC REG BUCK ADJ 2A DL 20TSSOP
标准包装: 74
类型: 降压(降压)
输出类型: 可调式
输出数: 2
输出电压: 0.8 V ~ 23.8 V
输入电压: 3.1 V ~ 25 V
PWM 型: 电流模式
频率 - 开关: 250kHz ~ 1.5MHz
电流 - 输出: 2A
同步整流器:
工作温度: -40°C ~ 125°C
安装类型: 表面贴装
封装/外壳: 20-TSSOP(0.173",4.40mm 宽)裸露焊盘
包装: 管件
供应商设备封装: 20-TSSOP-EP
产品目录页面: 1332 (CN2011-ZH PDF)
LT3510
APPLICATIONS INFORMATION
to the internal planes with vias can further reduce ther-
mal resistance. With these steps, the thermal resistance
from die (or junction) to ambient can be reduced to θ JA
= 45°C/W.
The power dissipation in the other power components
such as catch diodes, boost diodes and inductors, cause
additional copper heating and can further increase what
the IC sees as ambient temperature. See the LT1767 data
sheet’s Thermal Considerations section.
Single, Low Ripple 4A Output
The LT3510 can generate a single, low ripple 4A output
if the outputs of the two switching regulators are tied
together and share a single output capacitor. By tying the
two FB pins together and the two V C pins together, the
two channels will share the load current. There are several
advantages to this 2-phase buck regulator. Ripple currents
at the input and output are reduced, reducing voltage ripple
and allowing the use of smaller, less expensive capacitors.
Although two inductors are required, each will be smaller
than the inductor required for a single-phase regulator. This
may be important when there are tight height restrictions
on the circuit.
There is one special consideration regarding the 2-phase
circuit. When the difference between the input voltage and
output voltage is less than 2.5V, then the boost circuits may
prevent the two channels from properly sharing current.
If, for example, channel 1 gets started ?rst, it can supply
the load current, while channel 2 never switches enough
current to get its boost capacitor charged.
In this case, channel 1 will supply the load until it reaches
current limit, the output voltage drops, and channel 2 gets
started. Two solutions to this problem are shown in the
Typical Applications section.
The single 3.3V/4A output converter generates a boost sup-
ply from either SW that will service both switch pins.
The synchronized 3.3V/8A output converter utilizes
undervoltage lockout to prevent the start-up condition.
Other Linear Technology Publications
Application notes AN19, AN35 and AN44 contain more
detailed descriptions and design information for buck
regulators and other switching regulators. The LT1376
data sheet has a more extensive discussion of output
ripple, loop compensation and stability testing. Design
Note DN100 shows how to generate a dual (+ and –)
output supply using a buck regulator.
3510fe
25
相关PDF资料
PDF描述
LT3686HDD#PBF IC REG BUCK ADJ 1.2A 10-DFN
380LX123M016H022 CAP ALUM 12000UF 16V 20% SNAP
EGM28DTKH CONN EDGECARD 56POS DIP .156 SLD
ECO-S1KA562EA CAP ALUM 5600UF 80V 20% SNAP
LT1308ACS8#PBF IC REG BOOST 5V 1A 8SOIC
相关代理商/技术参数
参数描述
LT3510EFE-TR 制造商:LINER 制造商全称:Linear Technology 功能描述:Monolithic Dual Tracking 2A Step-Down Switching Regulator
LT3510EFE-TRPBF 制造商:LINER 制造商全称:Linear Technology 功能描述:Monolithic Dual Tracking 2A Step-Down Switching Regulator
LT3510FE 制造商:LINER 制造商全称:Linear Technology 功能描述:Monolithic Dual Tracking 2A Step-Down Switching Regulator
LT3510IFE 制造商:Linear Technology 功能描述:Conv DC-DC Dual Step Down 3.1V to 25V 20-Pin TSSOP EP
LT3510IFE#PBF 功能描述:IC REG BUCK ADJ 2A DL 20TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 产品培训模块:MIC23xxx HyperLight Load™ Regulators 标准包装:5,000 系列:HyperLight Load® 类型:降压(降压) 输出类型:固定 输出数:1 输出电压:1.8V 输入电压:2.7 V ~ 5.5 V PWM 型:混合物 频率 - 开关:4MHz 电流 - 输出:2A 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘,8-MLF? 包装:带卷 (TR) 供应商设备封装:8-MLF?(2x2) 产品目录页面:1094 (CN2011-ZH PDF) 其它名称:576-3303-2