- 您现在的位置：买卖IC网 > PDF目录15304 > LT3837EFE#TRPBF (Linear Technology)IC REG CTRLR FLYBK ISO 16-TSSOP PDF资料下载
参数资料
| 型号： | LT3837EFE#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 20/28页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR FLYBK ISO 16-TSSOP |
| 标准包装： | 2,500 |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 频率 - 最大： | 250kHz |
| 占空比： | 88% |
| 电源电压： | 4.5 V ~ 20 V |
| 降压： | 无 |
| 升压： | 无 |
| 回扫： | 是 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 是 |
| 工作温度： | -40°C ~ 125°C |
| 封装/外壳： | 16-TSSOP（0.173"，4.40mm）裸露焊盘 |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页当前第20页第21页第22页第23页第24页第25页第26页第27页第28页
LT3837
APPLICATIONS INFORMATION
I SC ? ( R SEC + R DS(ON) )
DC MIN = t ON(MIN) ? f OSC <
MinimumLoadConsiderations
At light loads, the LT3837 derived regulator goes into
forced continuous conduction mode. The primary side
switch always turns on for a short time as set by the
t ON(MIN) resistor. If this produces more power than the
load requires, power will flow back into the primary during
the “off” period when the synchronization switch is on.
This does not produce any inherently adverse problems,
though light load efficiency is reduced.
Maximum Load Considerations
The current mode control uses the V C node voltage and
amplified sense resistor voltage as inputs to the current
comparator. When the amplified sense voltage exceeds the
V C node voltage, the primary side switch is turned off.
In normal use, the peak switch current increases while
FB is below the internal reference. This continues until
V C reaches its 2.56V clamp. At clamp, the primary side
MOSFET will turn off at the rated 98mV V SENSE level. This
repeats on the next cycle.
It is possible for the peak primary switch currents as
referred across R SENSE to exceed the max 98mV rating
because of the minimum switch-on time blanking. If the
voltage on V SENSE reaches 206mV after the minimum
turn-on time, the SFST capacitor is discharged, which also
discharges the V C capacitor. This then reduces the peak
current on the next cycle and will reduce overall stress in
the primary switch.
Short-Circuit Conditions
Loss of current limit is possible under certain conditions
such as an output short-circuit. If the duty cycle exhib-
ited by the minimum on-time is greater than the ratio of
secondary winding voltage (referred-to-primary) divided
by input voltage, then peak current is not controlled at
the nominal value. It ratchets up cycle-by-cycle to some
higher level. Expressed mathematically, the requirement
to maintain short-circuit control is:
V IN ? N SP
where:
t ON(MIN) = primary side switch minimum on-time
I SC = short-circuit output current
Other variables as previously defined.
Trouble is typically encountered only in applications with a
relatively high product of input voltage times secondary-
to-primary turns ratio and/or a relatively long minimum
switch-on time. Additionally, several real world effects such
as transformer leakage inductance, AC winding losses, and
output switch voltage drop combine to make this simple
theoretical calculation a conservative estimate. Prudent
design evaluates the switcher for short-circuit protection
and adds any additional circuitry to prevent destruction.
Output Voltage Error Sources
The LT3837’s feedback sensing introduces additional
sources of errors. The following is a summary list.
The internal bandgap voltage reference sets the reference
voltage for the feedback amplifier. The specifications detail
its variation.
The external feedback resistive divider ratio proportional
directly affects regulated voltage. Use 1% components.
Leakage inductance on the transformer secondary reduces
the effective secondary-to-feedback winding turns ratio
(N S /N F ) from its ideal value. This increases the output volt-
age target by a similar percentage. Since secondary leakage
inductance is constant from part to part (with a tolerance)
adjust the feedback resistor ratio to compensate.
The transformer secondary current flows through the im-
pedances of the winding resistance, synchronous MOSFET
R DS(ON) and output capacitor ESR. The DC equivalent
current for these errors is higher than the load current
because conduction occurs only during the converter’s
“off” time. So divide the load current by (1 – DC).
3837fd
20
相关PDF资料 |
PDF描述 |
|---|---|
| GBM43DCBS | CONN EDGECARD 86POS R/A .156 SLD |
| UVY1E102MPD | CAP ALUM 1000UF 25V 20% RADIAL |
| VE-J2X-EY-F1 | CONVERTER MOD DC/DC 5.2V 50W |
| LTC1735CF#TR | IC REG CTRLR BUCK PWM CM 20TSSOP |
| IMC1210EB82NJ | INDUCTOR WW 82NH 5% 1210 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3837IFE#PBF | 功能描述:IC REG CTRLR FLYBK ISO 16-TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LT3837IFE#TRPBF | 功能描述:IC REG CTRLR FLYBK ISO 16-TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LT383L313 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Optoelectronic |
| LT3844 | 制造商:LINER 制造商全称:Linear Technology 功能描述:High Voltage, Current Mode Switching Regulator Controller with Programmable Operating Frequency |
| LT3844EFE | 制造商:LINER 制造商全称:Linear Technology 功能描述:High Voltage, Current Mode Switching Regulator Controller with Programmable Operating Frequency |
发布紧急采购，3分钟左右您将得到回复。