- 您现在的位置：买卖IC网 > PDF目录15274 > LTC1149CS-5#PBF (Linear Technology)IC REG CTRLR BUCK PWM CM 16-SOIC PDF资料下载
参数资料
| 型号： | LTC1149CS-5#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 13/20页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM CM 16-SOIC |
| 标准包装： | 50 |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 频率 - 最大： | 250kHz |
| 占空比： | 100% |
| 电源电压： | 最高 48V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | 0°C ~ 70°C |
| 封装/外壳： | 16-SOIC（0.154"，3.90mm 宽） |
| 包装： | 管件 |
LTC1149
LTC1149-3.3/LTC1149-5
APPLICATIO S I FOR ATIO
LTC1149 Package Dissipation
High input voltage applications in which large MOSFETs
are being driven at high frequencies may cause the maxi-
mum junction temperature rating for the LTC1149 series
The same calculations were repeated for a smaller device,
the Motorola MTD2955 (R DS(ON) = 0.3 ? ) and a larger one,
the Harris RFP30P05 (R DS(ON) = 0.065 ? ). The results are
summarized in the table.
to be exceeded. The LTC1149 supply current is dominated
by the gate charge supply current, which is given as a
CONDITIONS
V IN = 24V, V OUT = 5V
P-CHANNEL MOSFET
function of operating frequency in the Typical Perfor-
mance Characteristics. The LTC1149 series junction tem-
perature can be estimated by using the equations given in
Note 1 of the Electrical Characteristics. For example, the
LT1149CS is limited to less than 11mA from a 48V supply:
F = 100kHz, I OUT = 2.5A
Est. I 2 R Loss (100 ° C)
Est. Transition Loss
Est. Gate Charge Loss
Est. Total Loss
MTD2955
550mW
110mW
60mW
720mW
IRF9Z34
270mW
145mW
85mW
500mW
RFP30P05
120mW
290mW
240mW
650mW
R SENSE = 100mV = 0.039 ?
)
)
C T = 1– = 620pF
T J = 70 ° C + (11mA)(48V)(110 ° C/W)
= 128 ° C exceeds absolute maximum
To prevent the maximum junction temperature from being
exceeded, the Pin 2 supply current must be checked in
continuous mode when operating at the maximum V IN .
Design Example
As a design example, assume V IN = 24V, V OUT = 5V,
I MAX = 2.5A and f = 100kHz. R SENSE , C T and L can
immediately be calculated:
2.5
(7.8)(10 –5 ) 5V
100kHz 24V
L MIN = (5.1)(10 5 )(0.039 ? )(620pF)(5V) = 62 μ H
Selection of the P-channel MOSFET involves doing calcu-
lations for different sized MOSFETs to determine the
relative loss contributions. Taking an International Recti-
fier IRF9Z34 for example, R DS(ON) = 0.14 ? Max,
Q P = 35nC and C RSS = 200pF (V DS = V IN /2). These values
can be used to estimate the I 2 R losses, transition losses
and gate charge supply current losses:
Est. I 2 R Loss (T J = 100 ° C) =
(5V/24V)(2.5) 2 (1 + 0.5)0.14 ? = 270mW
Est. Transition Loss =
5(24V) 2 (2.5A)(200pF)(100kHz) = 145mW
Est. Gate Charge Loss =
(100kHz)(35nC)(24V) = 85mW
For this set of conditions, the midsized P-channel MOSFET
actually produces the lowest total losses at I MAX . The
resulting efficiency differences will be even more pro-
nounced at lower output currents. Note that only the I 2 R
and transition losses are dissipated in the MOSFET; the
gate charge supply current loss is dissipated by the
LTC1149 series.
Selection of the N-channel MOSFET is somewhat easier; it
need only be sized for the anticipated I 2 R losses at 100%
duty cycle (worst-case assumption for short circuit.) The
Siliconix Si9410, for example, has R DS(ON) = 0.03 ? Max
and Q N = 30nC. This will produce an I 2 R loss of 250mW at
100 ° C and a gate charge supply current loss of 75mW. As
with the P-channel device, the use of a larger MOSFET may
actually result in lower midcurrent efficiency.
C IN will require an RMS current rating of at least 1.25A at
temperature, and C OUT will require an ESR of 0.04 ? for
optimum efficiency. The output capacitor ESR require-
ment can be fulfilled by a single OS-CON or by two or more
surface mount tantalums in parallel.
Auxiliary Windings – Suppressing Burst Mode
Operation
The LTC1149 synchronous switch removes the normal
limitation that power must be drawn from the inductor
primary winding in order to extract power from auxiliary
windings. With synchronous switching, auxiliary outputs
may be loaded without regard to the primary output load,
providing that the loop remains in continuous mode
operation.
Burst Mode operation can be suppressed at low output
currents with a simple external network which cancels the
13
相关PDF资料 |
PDF描述 |
|---|---|
| LTC1149CS-5 | IC REG CTRLR BUCK PWM CM 16-SOIC |
| EYM22DRST | CONN EDGECARD 44POS DIP .156 SLD |
| EGM22DRST | CONN EDGECARD 44POS DIP .156 SLD |
| LTC3708EUH | IC REG CTRLR BUCK PWM CM 32-QFN |
| LTC3802EUH#PBF | IC REG CTRLR BUCK PWM VM 32-QFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC1149CSPBF | 制造商:Linear Technology 功能描述:DC-DC Controller Step-Down 48V SOIC16 |
| LTC1150 | 制造商:LINER 制造商全称:Linear Technology 功能描述:15V CHOPPER STABILIZED OPERATIONAL AMPLIFIER WITH INTERNAL CAPACITORS |
| LTC1150_03 | 制造商:LINER 制造商全称:Linear Technology 功能描述:【15V Zero-Drift Operational Amplifier with Internal Capacitors |
| LTC1150C | 制造商:LINER 制造商全称:Linear Technology 功能描述:+-15V Chopper Stabilized Operational Amplifier with Internal Capacitors |
| LTC1150CH | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Chopper-Stabilized Operational Amplifier |
发布紧急采购，3分钟左右您将得到回复。