参数资料
型号: LTC3728IUH#PBF
厂商: Linear Technology
文件页数: 22/36页
文件大小: 0K
描述: IC REG CTRLR BUCK PWM CM 32-QFN
标准包装: 73
系列: PolyPhase®
PWM 型: 电流模式
输出数: 2
频率 - 最大: 590kHz
占空比: 99%
电源电压: 3.5 V ~ 36 V
降压:
升压:
回扫:
反相:
倍增器:
除法器:
Cuk:
隔离:
工作温度: -40°C ~ 85°C
封装/外壳: 32-WFQFN 裸露焊盘
包装: 管件
LTC3728
APPLICATIONS INFORMATION
Fault Conditions: Overcurrent Latchoff
The RUN/SS pins also provide the ability to latch off the
controller(s) when an overcurrent condition is detected. The
RUN/SS capacitor, C SS , is used initially to turn on and limit
the inrush current. After the controller has been started and
given adequate time to charge up the output capacitor and
provide full load current, the RUN/SS capacitor is used for
a short-circuit timer. If the regulator’s output voltage falls
to less than 70% of its nominal value after C SS reaches
4.1V, C SS begins discharging on the assumption that the
output is in an overcurrent condition. If the condition lasts
for a long enough period, as determined by the size of the
C SS and the speci?ed discharge current, the controller will
be shut down until the RUN/SS pin voltage is recycled.
If the overload occurs during start-up, the time can be
approximated by:
t LO1 ≈ [C SS (4.1 – 1.5 + 4.1 – 3.5)]/(1.2 μA)
= 2.7 ? 10 6 (C SS )
If the overload occurs after start-up, the voltage on C SS
will begin discharging from the Zener clamp voltage:
t LO2 ≈ [C SS (6 – 3.5)]/(1.2μA) = 2.1 ? 10 6 (C SS )
This built-in overcurrent latchoff can be overridden by
providing a pull-up resistor to the RUN/SS pin, as shown
in Figure 7. This resistance shortens the soft-start period
and prevents the discharge of the RUN/SS capacitor during
an over current condition. Tying this pull-up resistor to
V IN (as in Figure 7) defeats overcurrent latchoff.
Why should you defeat overcurrent latchoff? During the
prototyping stage of a design there may be a problem
with noise pickup or poor layout, causing the protection
circuit to latch off. Defeating this feature will easily allow
troubleshooting of the circuit and PC layout. The internal
short-circuit and foldback current limiting still remains
active, thereby protecting the power supply system from
failure. After the design is complete, a decision can be
made whether to enable the latchoff feature.
The value of the soft-start capacitor C SS may need to be
scaled with output voltage, output capacitance and load
current characteristics. The minimum soft-start capaci-
tance is given by:
C SS > (C OUT )(V OUT ) (10 –4 ) (R SENSE )
The minimum recommended soft-start capacitor of
C SS = 0.1μF will be suf?cient for most applications.
Fault Conditions: Current Limit and Current Foldback
The LTC3728 current comparator has a maximum sense
voltage of 75mV, resulting in a maximum MOSFET cur-
rent of 75mV/R SENSE . The maximum value of current
limit generally occurs with the largest V IN at the highest
ambient temperature —conditions that cause the highest
power dissipation in the top MOSFET.
The LTC3728 includes current foldback to help further
limit load current when the output is shorted to ground.
The foldback circuit is active even when the overload
shutdown latch previously described is overridden. If the
output falls below 70% of its nominal output level, then
the maximum sense voltage is progressively lowered from
75mV to 25mV. Under short-circuit conditions with very
low duty cycles, the LTC3728 will begin cycle skipping in
order to limit the short-circuit current. In this situation,
the bottom MOSFET will be dissipating most of the power
but less than in normal operation. The short-circuit ripple
current is determined by the minimum on-time t ON(MIN)
3.3V OR 5V
D1
V IN
RUN/SS
R SS *
C SS
of the LTC3728 (less than 200ns), the input voltage and
inductor value:
ΔI L(SC) = t ON(MIN) (V IN /L)
The resulting short-circuit current is:
*OPTIONAL TO DEFEAT OVERCURRENT LATCHOFF
I SC =
25mV
R SENSE
+
1
2
I L(SC)
3728 F07
Figure 7. RUN/SS Pin Interfacing
3728fg
22
相关PDF资料
PDF描述
VE-J70-EY-F3 CONVERTER MOD DC/DC 5V 50W
VE-J70-EY-F2 CONVERTER MOD DC/DC 5V 50W
LTC3880EUJ#TRPBF IC REG CTRLR BUCK PWM CM 40-QFN
VE-J5K-EY-F3 CONVERTER MOD DC/DC 40V 50W
VE-J5K-EY-F2 CONVERTER MOD DC/DC 40V 50W
相关代理商/技术参数
参数描述
LTC3728LCGN 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC3728LCGN#PBF 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC3728LCGN#TR 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC3728LCGN#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC3728LCUH 功能描述:IC REG CTRLR BUCK PWM CM 32-QFN RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX