参数资料
型号: LTC3728IUH#PBF
厂商: Linear Technology
文件页数: 23/36页
文件大小: 0K
描述: IC REG CTRLR BUCK PWM CM 32-QFN
标准包装: 73
系列: PolyPhase®
PWM 型: 电流模式
输出数: 2
频率 - 最大: 590kHz
占空比: 99%
电源电压: 3.5 V ~ 36 V
降压:
升压:
回扫:
反相:
倍增器:
除法器:
Cuk:
隔离:
工作温度: -40°C ~ 85°C
封装/外壳: 32-WFQFN 裸露焊盘
包装: 管件
LTC3728
APPLICATIONS INFORMATION
Fault Conditions: Overvoltage Protection (Crowbar)
The overvoltage crowbar is designed to blow a system
input fuse when the output voltage of the regulator rises
much higher than nominal levels. The crowbar causes
huge currents to ?ow that blow the fuse to protect against
a shorted top MOSFET, if the short occurs while the con-
troller is operating.
A comparator monitors the output for overvoltage con-
ditions. The comparator (OV) detects overvoltage faults
greater than 7.5% above the nominal output voltage. When
this condition is sensed, the top MOSFET is turned off
and the bottom MOSFET is turned on until the overvolt-
age condition is cleared. The output of this comparator
is only latched by the overvoltage condition itself and
will, therefore, allow a switching regulator system hav-
ing a poor PC layout to function while the design is being
debugged. The bottom MOSFET remains on continuously
for as long as the OV condition persists. If V OUT returns
to a safe level, normal operation automatically resumes. A
shorted top MOSFET will result in a high current condition
which will open the system fuse. The switching regulator
will regulate properly with a leaky top MOSFET by altering
the duty cycle to accommodate the leakage.
Phase-Locked Loop and Frequency Synchronization
The LTC3728 has a phase-locked loop comprised of an
internal voltage controlled oscillator and phase detector.
This allows the top MOSFET turn-on to be locked to the
rising edge of an external source. The frequency range
of the voltage controlled oscillator is ± 50% around the
center frequency, f O . A voltage applied to the PLLFLTR
pin of 1.2V corresponds to a frequency of approximately
400kHz. The nominal operating frequency range of the
LTC3728 is 250kHz to 550kHz.
The phase detector used is an edge-sensitive digital
type which provides zero degrees phase shift between
the external and internal oscillators. This type of phase
detector will not lock up on input frequencies close to the
harmonics of the VCO center frequency. The PLL hold-in
range, Δf H , is equal to the capture range, Δf C:
Δf H = Δf C = ±0.5 f O (250kHz-550kHz)
The output of the phase detector is a complementary pair
of current sources charging or discharging the external
?lter network on the PLLFLTR pin.
If the external frequency (f PLLIN ) is greater than the oscil-
lator frequency, f OSC , current is sourced continuously,
pulling up the PLLFLTR pin. When the external frequency is
less than f OSC , current is sunk continuously, pulling down
the PLLFLTR pin. If the external and internal frequencies
are the same but exhibit a phase difference, the current
sources turn on for an amount of time corresponding to the
phase difference. Thus, the voltage on the PLLFLTR pin is
adjusted until the phase and frequency of the external and
internal oscillators are identical. At this stable operating
point, the phase comparator output is open and the ?lter
capacitor C LP holds the voltage. The LTC3728 PLLIN pin
must be driven from a low impedance source such as a
logic gate located close to the pin. When using multiple
LTC3728’s (or LTC3729’s, as shown in Figure 14) for a
phase-locked system, the PLLFLTR pin of the master
oscillator should be biased at a voltage that will guarantee
the slave oscillator(s) ability to lock onto the master’s
frequency. A DC voltage of 0.7V to 1.7V applied to the
master oscillator’s PLLFLTR pin is recommended in order
to meet this requirement. The resultant operating frequency
can range from 300kHz to 470kHz.
The loop ?lter components (C LP , R LP ) smooth out the
current pulses from the phase detector and provide a
stable input to the voltage controlled oscillator. The ?lter
components, C LP and R LP , determine how fast the loop
acquires lock. Typically, R LP =10kΩ, and C LP is 0.01μF
to 0.1μF.
3728fg
23
相关PDF资料
PDF描述
VE-J70-EY-F3 CONVERTER MOD DC/DC 5V 50W
VE-J70-EY-F2 CONVERTER MOD DC/DC 5V 50W
LTC3880EUJ#TRPBF IC REG CTRLR BUCK PWM CM 40-QFN
VE-J5K-EY-F3 CONVERTER MOD DC/DC 40V 50W
VE-J5K-EY-F2 CONVERTER MOD DC/DC 40V 50W
相关代理商/技术参数
参数描述
LTC3728LCGN 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC3728LCGN#PBF 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC3728LCGN#TR 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC3728LCGN#TRPBF 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC3728LCUH 功能描述:IC REG CTRLR BUCK PWM CM 32-QFN RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX