- 您现在的位置：买卖IC网 > PDF目录13065 > LTC3734EUH#TR (Linear Technology)IC CTRLR DC/DC 1PH HI EFF 32QFN PDF资料下载
参数资料
| 型号： | LTC3734EUH#TR |
| 厂商： | Linear Technology |
| 文件页数： | 21/28页 |
| 文件大小： | 0K |
| 描述： | IC CTRLR DC/DC 1PH HI EFF 32QFN |
| 标准包装： | 2,500 |
| 应用： | 控制器，Intel 移动式 CPU |
| 输入电压： | 4 V ~ 30 V |
| 输出数： | 1 |
| 输出电压： | 0.7 V ~ 1.71 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 32-WFQFN 裸露焊盘 |
| 供应商设备封装： | 32-QFN 裸露焊盘（5x5） |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页当前第21页第22页第23页第24页第25页第26页第27页第28页
LTC3734
APPLICATIONS INFORMATION
Transition Loss = V IN2 ?
I OUT
? f ? C RSS ? R DR ?
? V DR – V TH(MIN)
V TH(MIN) ?
output.EfficiencyvariesastheinversesquareofV OUT for
the same external components and output power level.
The combined effects of increasingly lower output voltages
and higher currents required by high performance digital
systems is not doubling but quadrupling the importance
of loss terms in the switching regulator system!
2) Transition losses apply only to the topside MOSFET(s),
and are significant only when operating at high input volt-
ages (typically 12V or greater). Transition losses can be
estimated from:
2
? 1 1 ?
? + ?
3) PV CC drives both top and bottom MOSFETs. The MOSFET
driver current results from switching the gate capacitance
of the power MOSFETs. Each time a MOSFET gate is
switched from low to high to low again, a packet of charge
dQ moves from PV CC to ground. The resulting dQ/dt is a
current out of PV CC that is typically much larger than the
control circuit current. In continuous mode, I GATECHG =
(Q T + Q B )f, where Q T and Q B are the gate charges of the
topside and bottom side MOSFETs and f is the switching
frequency.
4) The input capacitor has the difficult job of filtering the
large RMS input current to the regulator. It must have a
very low ESR to minimize the AC I 2 R loss and sufficient
capacitance to prevent the RMS current from causing
additional upstream losses in fuses or batteries.
Other losses, including C OUT ESR loss, Schottky diode
conduction loss during dead time, inductor core loss and
internal control circuitry supply current generally account
for less than 2% additional loss.
Checking Transient Response
The regulator loop response can be checked by look-
ing at the load transient response. Switching regulators
take several cycles to respond to a step in DC (resistive)
load current. When a load step occurs, V OUT shifts by an
amount equal to ?I LOAD (ESR), where ESR is the effective
series resistance of C OUT . ?I LOAD also begins to charge or
discharge C OUT generating the feedback error signal that
forces the regulator to adapt to the current change and
return V OUT to its steady-state value. During this recovery
time V OUT can be monitored for excessive overshoot or
ringing, which would indicate a stability problem. The
availability of the I TH pin not only allows optimization of
control loop behavior but also provides a DC coupled and
AC filtered closed loop response test point. The DC step,
rise time, and settling at this test point truly reflects the
closed loop response. Assuming a predominantly second
order system, phase margin and/or damping factor can be
estimated using the percentage of overshoot seen at this
pin. The bandwidth can also be estimated by examining the
rise time at the pin. The I TH external components shown
in the Figure 1 circuit will provide an adequate starting
point for most applications.
The I TH series R C -C C filter sets the dominant pole-zero
loop compensation. The values can be modified slightly
(from 0.2 to 5 times their suggested values) to optimize
transient response once the final PC layout is done and
the particular output capacitor type and value have been
determined. The output capacitors need to be decided
upon first because the various types and values determine
the loop gain and phase. An output current pulse of 20%
to 80% of full-load current having a rise time of <1μs will
produce output voltage and I TH pin waveforms that will
give a sense of the overall loop stability without breaking
the feedback loop. The initial output voltage step result-
ing from the step change in output current may not be
within the bandwidth of the feedback loop, so this signal
cannot be used to determine phase margin. This is why
it is better to look at the I TH pin signal which is in the
feedback loop and is the filtered and compensated control
loop response. The gain of the loop will be increased
by increasing R C and the bandwidth of the loop will be
increased by decreasing C C . If R C is increased by the
same factor that C C is decreased, the zero frequency will
be kept the same, thereby keeping the phase the same in
the most critical frequency range of the feedback loop.
The output voltage settling behavior is related to the
stability of the closed-loop system and will demonstrate
the actual overall supply performance.
3734fa
21
相关PDF资料 |
PDF描述 |
|---|---|
| C0603X7R1E222M | CAP CER 2200PF 25V 20% X7R 0201 |
| LTC3720EGN#TR | IC STP-DN CNTRLR SNGL-PHS 28SSOP |
| UWZ1E151MCL1GS | CAP ALUM 150UF 25V 20% SMD |
| LT1184CS#TRPBF | IC SW REG CCFL CONTRAST 16-SOIC |
| 450USC150MEFCSN25X30 | CAP ALUM 150UF 450V 20% SNAP-IN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3735EG | 功能描述:IC CTRLR DC/DC 2PH HI EFF 36SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件 |
| LTC3735EG#PBF | 功能描述:IC CTRLR DC/DC 2PH HI EFF 36SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:2,000 系列:- 应用:控制器，DSP 输入电压:4.5 V ~ 25 V 输出数:2 输出电压:最低可调至 1.2V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:30-TFSOP（0.173"，4.40mm 宽） 供应商设备封装:30-TSSOP 包装:带卷 (TR) |
| LTC3735EG#TR | 功能描述:IC CTRLR DC/DC 2PH HI EFF 36SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件 |
| LTC3735EG#TRPBF | 功能描述:IC CTRLR DC/DC 2PH HI EFF 36SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件 |
| LTC3735EUHF | 功能描述:IC CTRLR DC/DC 2PH HI EFF 38-QFN RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件 |
发布紧急采购，3分钟左右您将得到回复。