- 您现在的位置：买卖IC网 > PDF目录1834 > LTC4155IUFD#TRPBF (Linear Technology)IC I2C POWER MANAGER DUAL 28QFN PDF资料下载
参数资料
| 型号： | LTC4155IUFD#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 24/52页 |
| 文件大小： | 0K |
| 描述： | IC I2C POWER MANAGER DUAL 28QFN |
| 标准包装： | 2,500 |
| 系列： | PowerPath™ |
| 功能： | 充电管理，电源管理 |
| 电池化学： | 锂离子（Li-Ion）、锂聚合物（Li-Pol） |
| 电源电压： | 4.35 V ~ 5.5 V |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 28-WFQFN 裸露焊盘 |
| 供应商设备封装： | 28-QFN（4x5） |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页当前第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页
LTC4155
OPERATION
Low Power Ship-and-Store Mode
The LTC4155 can reduce its already low standby current
to approximately 1μA in a special mode designed for
shipment and storage. Unlike normal standby mode, in
this mode the external PMOS gate is driven to the battery
voltage to disable FET conduction through the external
PMOS. This mode may be used to cut off all power to
any downstream load on V OUT to maximize battery life
between product manufacture and sale. Note that the bulk
connection inside the external PMOS will provide a con-
ductive path from the battery to V OUT , independent of the
voltage on its gate. To block conduction to V OUT , typically
two PMOS transistors must be connected in series with
either the sources or drains of each device connected in
the center, as shown in Figure 4. If the application does
not require the battery to be isolated from downstream
devices, significant power savings in the LTC4155 may
still be realized by activating this mode.
Ship-and-store mode is armed following the acknowledge
of any data byte written to sub address 0x07 by the I 2 C
bus master. The contents of the data byte are ignored, but
the full byte and acknowledge clock cycle must be sent.
Ship-and-store mode is activated as V BUS falls below ap-
proximately 1V, or immediately if no input power is present
when the I 2 C command is issued. V BUS quiescent current
falls to nearly zero when power is removed from the USB
and WALL inputs, resulting in a delay of up to several hours
for V BUS to self-discharge to the 1V activation threshold.
Faster activation may be achieved by connecting a 1M
resistor between V BUS and GND. Reading from sub ad-
dress 0x07 has no effect on arming or activation and the
returned data is undefined, independent of the arming or
activation state.
CHGSNS
LTC4155
BATGATE
Once engaged, ship-and-store mode can be disengaged
by applying power to the USB or WALL input or by writ-
ing any full data byte and acknowledge clock cycle to sub
address 0x06 if the I 2 C bus master is still powered.
I 2 C Interface
The LTC4155 may communicate with a bus master using
the standard I 2 C 2-wire interface. The Timing Diagram
shows the relationship of the signals on the bus. The two
bus lines, SDA and SCL, must be HIGH when the bus is
not in use. External pull-up resistors or current sources,
such as the LTC1694 SMBus accelerator, are required
on these lines. The LTC4155 is both a slave receiver and
slave transmitter. The I 2 C control signals, SDA and SCL,
are scaled internally to the DVCC supply. DVCC should be
connected to the same power supply as the bus pull-up
resistors.
The I 2 C port has an undervoltage lockout on the DVCC pin.
When DVCC is below approximately 1V, the I 2 C serial port
is cleared, the LTC4155 is set to its default configuration,
pending interrupts will be cleared, and future interrupts
will be disabled.
Bus Speed
The I 2 C port is designed to operate at speeds of up to
400kHz. It has built-in timing delays to ensure correct
operation when addressed from an I 2 C compliant master
device. It also contains input filters designed to suppress
glitches.
START and STOP Conditions
A bus master signals the beginning of communications
by transmitting a START condition. A START condition is
generated by transitioning SDA from HIGH to LOW while
SCL is HIGH. The master may transmit either the slave
write or the slave read address. Once data is written to
the LTC4155, the master may transmit a STOP condi-
tion which commands the LTC4155 to act upon its new
BATSNS
+
command set. A STOP condition is sent by the master by
transitioning SDA from LOW to HIGH while SCL is HIGH.
4155 F04
Figure 4. Ship-and-Store Mode Required Components
to Enforce Downstream (V OUT ) Shutdown
24
4155fc
相关PDF资料 |
PDF描述 |
|---|---|
| LTC4160EUDC-1#TRPBF | IC SWITCH POWER MANAGER 20-QFN |
| LTC4410ES6#TRPBF | IC POWER MANAGER USB TSOT23-6 |
| LTC4411ES5#TRMPBF | IC IDEAL DIODE LOW LOSS TSOT23-5 |
| LTC4412IS6#TRMPBF | IC PWR PATH CNTRLR TSOT23-6 |
| LTC4413EDD-1#PBF | IC IDEAL DIODE DUAL 10-DFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC4156EUFD#PBF | 功能描述:IC POWER LI-ION CHARGER 28-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 电池管理 系列:* 其它有关文件:STC3100 View All Specifications 特色产品:STC3100 - Battery Monitor IC 标准包装:4,000 系列:- 功能:燃料，电量检测计/监控器 电池化学:锂离子（Li-Ion） 电源电压:2.7 V ~ 5.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-TSSOP，8-MSOP（0.118"，3.00mm 宽） 供应商设备封装:8-MiniSO 包装:带卷 (TR) 其它名称:497-10526-2 |
| LTC4156EUFD#TRPBF | 功能描述:IC POWER LI-ION CHARGER 28-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 电池管理 系列:* 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- 功能:电池监控器 电池化学:碱性，锂离子，镍镉，镍金属氢化物 电源电压:1 V ~ 5.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-6 供应商设备封装:SOT-6 包装:带卷 (TR) |
| LTC4156IUFD#PBF | 功能描述:IC POWER LI-ION CHARGER 28-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 电池管理 系列:* 其它有关文件:STC3100 View All Specifications 特色产品:STC3100 - Battery Monitor IC 标准包装:4,000 系列:- 功能:燃料，电量检测计/监控器 电池化学:锂离子（Li-Ion） 电源电压:2.7 V ~ 5.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-TSSOP，8-MSOP（0.118"，3.00mm 宽） 供应商设备封装:8-MiniSO 包装:带卷 (TR) 其它名称:497-10526-2 |
| LTC4156IUFD#TRPBF | 功能描述:IC POWER LI-ION CHARGER 28-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 电池管理 系列:* 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- 功能:电池监控器 电池化学:碱性，锂离子，镍镉，镍金属氢化物 电源电压:1 V ~ 5.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-6 供应商设备封装:SOT-6 包装:带卷 (TR) |
| LTC4160 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Switching Power Manager with USB On-The-Go And Overvoltage Protection |
发布紧急采购，3分钟左右您将得到回复。