- 您现在的位置：买卖IC网 > PDF目录1834 > LTC4155IUFD#TRPBF (Linear Technology)IC I2C POWER MANAGER DUAL 28QFN PDF资料下载
参数资料
| 型号： | LTC4155IUFD#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 28/52页 |
| 文件大小： | 0K |
| 描述： | IC I2C POWER MANAGER DUAL 28QFN |
| 标准包装： | 2,500 |
| 系列： | PowerPath™ |
| 功能： | 充电管理，电源管理 |
| 电池化学： | 锂离子（Li-Ion）、锂聚合物（Li-Pol） |
| 电源电压： | 4.35 V ~ 5.5 V |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 28-WFQFN 裸露焊盘 |
| 供应商设备封装： | 28-QFN（4x5） |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页当前第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页
LTC4155
OPERATION
a NACK is irrelevant. Finally, a STOP condition returns the
bus to the idle state.
SMBus Send Byte Protocol
sponds to the LTC4155 read address, which is 0x09 when
interpreted as a 7-bit word (0b 000 1001), followed by
RD (value 0b1). The LTC4155 will acknowledge its read
address. At this time the bus master becomes a receiver
1
S
7
SLAVE ADDRESS
1 1
WR A
8
DATA BYTE
1
A
1
P
while continuing to clock SCL. The LTC4155 becomes a
slave transmitter and controls SDA to place data on the
bus. Following the single data byte, the bus master has
The SMBus send byte protocol can be used to modify
the contents of the sub address pointer register without
modifying the contents of any control registers. It has util-
ity when preparing to later read status information from
the LTC4155 using the SMBus receive byte protocol. The
transaction is initiated by the bus master with a START
condition. The SMBus slave address corresponds to the
LTC4155 write address, which is 0x09 when interpreted as
a 7-bit word (0b 000 1001) followed by WR (value 0b0).
The LTC4155 will acknowledge its write address. The
SMBus data byte corresponds to the sub address pointer
value and will be written to the sub address pointer register
in the LTC4155. Note that the data byte in this protocol
is analogous to the command code in the write byte and
read byte protocols. The LTC4155 will acknowledge the
SMBus data byte. Finally, a STOP condition returns the
bus to the idle state.
SMBus Receive Byte Protocol
the option of transmitting either an ACK or a NACK bit.
According to the I 2 C specification, a master must trans-
mit a NACK at the end of a read transaction to instruct
the slave to terminate data transmission. Because the
LTC4155 terminates data transmission after one byte in
all cases, whether the bus master transmits an ACK or a
NACK is irrelevant. Finally, a STOP condition returns the
bus to the idle state.
Programmable Interrupt Controller
The LTC4155 can optionally generate active LOW, level-
triggered interrupt requests on the IRQ pin in response
to a number of status change or fault events. The three
available bytes of status information are also frozen at
the time the interrupt is triggered to aid in determining
the cause of a transient interrupt. The contents of the
four writeable command registers are never frozen by
interrupts. The interrupt trigger events are grouped into
six individually maskable categories corresponding to
1
S
7
SLAVE ADDRESS
1 1
RD A
8
DATA BYTE
1
A
1
P
battery charger status, faults, input power detection, USB
On-The-Go, input current limit and input undervoltage cur-
rent limit. The interrupt mask register (IMR) is located at
The SMBus receive byte protocol can be used to read
the contents of the command or status register already
selected by the sub address pointer register. This protocol
is incapable of modifying the contents of the sub address
pointer register, but may be useful to poll a single status
register repeatedly with much less bus overhead than the
other SMBus protocols. The sub address pointer register
can be modified by any of the SMBus write byte, read
byte or send byte protocols and the register contents
will persist until they are modified again by one of these
three protocols.
The receive byte transaction is initiated by the bus master
with a START condition. The SMBus slave address corre-
sub address location 0x06, with the six most significant
bits representing the mask programming. Refer to Table?3.
Table 4 lists the status triggers for each interrupt category.
Upon power-up, all interrupts default to disabled (masked).
Each interrupt category may be enabled by writing a “1”
to the appropriate position in the IMR. Any data written to
sub address 0x06 also has the side effect of clearing the
pending interrupt upon the acknowledge bit of the data
(third) byte. Clearing the interrupt releases the IRQ pin
and resumes status reporting of live data until the next
interrupt. If no change to the interrupt mask is desired, the
bus master must rewrite the previous data to sub address
0x06 to clear an interrupt request.
4155fc
28
相关PDF资料 |
PDF描述 |
|---|---|
| LTC4160EUDC-1#TRPBF | IC SWITCH POWER MANAGER 20-QFN |
| LTC4410ES6#TRPBF | IC POWER MANAGER USB TSOT23-6 |
| LTC4411ES5#TRMPBF | IC IDEAL DIODE LOW LOSS TSOT23-5 |
| LTC4412IS6#TRMPBF | IC PWR PATH CNTRLR TSOT23-6 |
| LTC4413EDD-1#PBF | IC IDEAL DIODE DUAL 10-DFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC4156EUFD#PBF | 功能描述:IC POWER LI-ION CHARGER 28-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 电池管理 系列:* 其它有关文件:STC3100 View All Specifications 特色产品:STC3100 - Battery Monitor IC 标准包装:4,000 系列:- 功能:燃料，电量检测计/监控器 电池化学:锂离子（Li-Ion） 电源电压:2.7 V ~ 5.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-TSSOP，8-MSOP（0.118"，3.00mm 宽） 供应商设备封装:8-MiniSO 包装:带卷 (TR) 其它名称:497-10526-2 |
| LTC4156EUFD#TRPBF | 功能描述:IC POWER LI-ION CHARGER 28-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 电池管理 系列:* 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- 功能:电池监控器 电池化学:碱性，锂离子，镍镉，镍金属氢化物 电源电压:1 V ~ 5.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-6 供应商设备封装:SOT-6 包装:带卷 (TR) |
| LTC4156IUFD#PBF | 功能描述:IC POWER LI-ION CHARGER 28-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 电池管理 系列:* 其它有关文件:STC3100 View All Specifications 特色产品:STC3100 - Battery Monitor IC 标准包装:4,000 系列:- 功能:燃料，电量检测计/监控器 电池化学:锂离子（Li-Ion） 电源电压:2.7 V ~ 5.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-TSSOP，8-MSOP（0.118"，3.00mm 宽） 供应商设备封装:8-MiniSO 包装:带卷 (TR) 其它名称:497-10526-2 |
| LTC4156IUFD#TRPBF | 功能描述:IC POWER LI-ION CHARGER 28-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 电池管理 系列:* 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- 功能:电池监控器 电池化学:碱性，锂离子，镍镉，镍金属氢化物 电源电压:1 V ~ 5.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-6 供应商设备封装:SOT-6 包装:带卷 (TR) |
| LTC4160 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Switching Power Manager with USB On-The-Go And Overvoltage Protection |
发布紧急采购，3分钟左右您将得到回复。