- 您现在的位置：买卖IC网 > PDF目录1834 > LTC4160EUDC-1#TRPBF (Linear Technology)IC SWITCH POWER MANAGER 20-QFN PDF资料下载
参数资料
| 型号： | LTC4160EUDC-1#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 22/32页 |
| 文件大小： | 0K |
| 描述： | IC SWITCH POWER MANAGER 20-QFN |
| 标准包装： | 2,500 |
| 系列： | Bat-Track™, PowerPath™ |
| 功能： | 电源管理 |
| 电池化学： | 锂离子（Li-Ion）、锂聚合物（Li-Pol） |
| 电源电压： | 4.35 V ~ 5.5 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 20-WFQFN 裸露焊盘 |
| 供应商设备封装： | 20-QFN（3x4） |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页当前第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页
LTC4160/LTC4160-1
APPLICATIONS INFORMATION
USB/WALL
V BUS
ThereareMLCCsavailablewithseveraltypesofdielectrics
each having considerably different characteristics. For
example, X7R MLCCs have the best voltage and tempera-
ture stability. X5R MLCCs have apparently higher packing
density but poorer performance over their rated voltage
and temperature ranges. Y5V MLCCs have the highest
packing density, but must be used with caution, because
of their extreme nonlinear characteristic of capacitance
versus voltage. The actual in-circuit capacitance of a
ceramic capacitor should be measured with a small AC
signal and DC bias as is expected in-circuit. Many vendors
specify the capacitance versus voltage with a 1V RMS AC
test signal and, as a result, over state the capacitance that
the capacitor will present in the application. Using similar
operating conditions as the application, the user must
measure or request from the vendor the actual capacitance
to determine if the selected capacitor meets the minimum
capacitance that the application requires.
Overvoltage Protection
V BUS can be protected from overvoltage damage with two
additional components, a resistor R1 and an N-channel
MOSFET MN1, as shown in Figure 5. Suitable choices for
MN1 are listed in Table 4.
R1 is a 6.2k resistor and must be rated for the power dis-
sipated during maximum overvoltage. In an overvoltage
condition the OVSENS pin will be clamped at 6V. R1 must
be sized appropriately to dissipate the resultant power.
For example, a 1/10W 6.2k resistor can have at most
√ (PMAX ? 6.2k Ω ) = 25V applied across its terminals. With
the 6V at OVSENS, the maximum overvoltage magnitude
that this resistor can withstand is 31V. A 1/4W 6.2k resis-
tor raises this value to 45V. OVSENS’s absolute maximum
current rating of 10mA imposes an upper limit of 68V
protection.
Reverse Voltage Protection
The LTC4160/LTC4160-1 can also be easily protected
against the application of reverse voltages, as shown in
Figure 6. D1 and R1 are necessary to limit the maximum
V GS seen by MP1 during positive overvoltage events. D1’s
breakdown voltage must be safely below MP1’s BVGS. The
circuit shown in Figure 6 offers forward voltage protection
up to MN1’s BVDSS and reverse voltage protection up to
MP1’s BVDSS.
MP1 MN1
ADAPTER
D1 C1
Table 4. Recommended N-Channel MOSFETs for the Overvoltage
Protection Circuit
PART # BVDSS R ON PACKAGE
R1
R2
LTC4160/
LTC4160-1
OVGATE
OVSENS
Si1472DH
Si2302ADS
Si2306BDS
30V
20V
30V
57mΩ
60mΩ
47mΩ
SC70-6
SOT-23
SOT-23
V BUS POSITIVE PROTECTION UP TO BVDSS OF MN1
V BUS NEGATIVE PROTECTION UP TO BVDSS OF MP1
Figure 6. Dual Polarity Voltage Protection
41601 F06
USB/WALL
V BUS
OVGATE
Si2316DS 30V 50mΩ SOT-23
IRLML2502 20V 50mΩ SOT-23
FDN372S 30V 50mΩ SOT-23
NTLJS4114N 30V 35mΩ WDFN6
MN1
ADAPTER
C1 LTC4160/
LTC4160-1
R1
OVSENS
41601 F05
Figure 5. Overvoltage Protection
Battery Charger Over Programming
The USB high power specification allows for up to 2.5W
to be drawn from the USB port. The LTC4160/LTC4160-1’s
bidirectional switching regulator in step-down mode con-
verts the voltage at V BUS to a voltage just above BAT on
V OUT , while limiting power to less than the amount pro-
grammed at CLPROG. The charger should be programmed
(with the PROG pin) to deliver the maximum safe charging
current without regard to the USB specifications. If there
is insufficient current available to charge the battery at the
programmed rate, the charge current will be reduced until
the system load on V OUT is satisfied and the V BUS cur-
rent limit is satisfied. Programming the charger for more
41601fa
22
相关PDF资料 |
PDF描述 |
|---|---|
| LTC4410ES6#TRPBF | IC POWER MANAGER USB TSOT23-6 |
| LTC4411ES5#TRMPBF | IC IDEAL DIODE LOW LOSS TSOT23-5 |
| LTC4412IS6#TRMPBF | IC PWR PATH CNTRLR TSOT23-6 |
| LTC4413EDD-1#PBF | IC IDEAL DIODE DUAL 10-DFN |
| LTC4413EDD#PBF | IC IDEAL DIODE DUAL 10-DFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC4210 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual Supply Hot Swap Controller for Advanced Mezzanine Card |
| LTC4210-1 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Hot Swap Controller in 6-Lead SOT-23 Package |
| LTC42101CS6 | 制造商:Linear Technology 功能描述: |
| LTC4210-1CS6 | 制造商:Linear Technology 功能描述:Hot Swap Controller 1-CH 16.5V 6-Pin TSOT-23 |
| LTC4210-1CS6#PBF | 制造商:Linear Technology 功能描述:Hot Swap Controller 1-CH 16.5V 6-Pin TSOT-23 制造商:Linear Technology 功能描述:IC HOT SWAP CONT 制造商:Linear Technology 功能描述:HOT SWAP CNTRL 16.5VIN 6SOT23 制造商:Linear Technology 功能描述:HOT SWAP, CNTRL, 16.5VIN, 6SOT23 制造商:Linear Technology 功能描述:IC, HOT SWAP CONT; Controller Applications:Hot Board Insertion, Electronic Circuit Breaker, Industrial High Side Switch; Input Voltage:16.5V; Internal Switch:Yes; Supply Voltage Min:2.7V; Supply Voltage Max:16.5V; No. of Pins:6 ;RoHS Compliant: Yes |
发布紧急采购，3分钟左右您将得到回复。