参数资料
型号: M34501M2-XXXFP
元件分类: 微控制器/微处理器
英文描述: 4-BIT, MROM, MICROCONTROLLER, PDSO20
封装: 5.30 X 12.60 MM, 1.27 MM PITCH, PLASTIC, SOP-20
文件页数: 69/118页
文件大小: 952K
代理商: M34501M2-XXXFP
Rev.3.01
2005.02.07
page 52 of 112
REJ03B0104-0301
4501 Group
Electric Characteristic Differences Between Mask ROM and One
Time PROM Version MCU
There are differences in electric characteristics, operation margin,
noise immunity, and noise radiation between Mask ROM and One
Time PROM version MCUs due to the difference in the manufac-
turing processes.
When manufacturing an application system with the One time
PROM version and then switching to use of the Mask ROM ver-
sion, please perform sufficient evaluations for the commercial
samples of the Mask ROM version.
Note on Power Source Voltage
When the power source voltage value of a microcomputer is less
than the value which is indicated as the recommended operating
conditions, the microcomputer does not operate normally and
may perform unstable operation.
In a system where the power source voltage drops slowly when
the power source voltage drops or the power supply is turned off,
reset a microcomputer when the supply voltage is less than the
recommended operating conditions and design a system not to
cause errors to the system by this unstable operation.
Power-on reset
Reset can be automatically performed at power on (power-on re-
set) by the built-in power-on reset circuit. When the built-in
power-on reset circuit is used, the time for the supply voltage to
rise from 0 V to 2.0 V must be set to 100
s or less. If the rising
time exceeds 100
s, connect a capacitor between the RESET
pin and VSS at the shortest distance, and input “L” level to RE-
SET pin until the value of supply voltage reaches the minimum
operating voltage.
Clock control
Execute the CMCK or the CRCK instruction in the initial setting
routine of program (executing it in addres 0 in page 0 is recom-
mended).
The oscillation circuit by the CMCK or CRCK instruction can be
selected only at once. The oscillation circuit corresponding to the
first executed one of these two instruction is valid. Other oscilla-
tion circuits and the on-chip oscillator stop.
On-chip oscillator
The clock frequency of the on-chip oscillator depends on the sup-
ply voltage and the operation temperature range.
Be careful that variable frequencies when designing application
products.
Also, the oscillation stabilize wait time after system is released
from reset is generated by the on-chip oscillator clock. When
considering the oscillation stabilize wait time after system is re-
leased from reset, be careful that the variable frequency of the
on-chip oscillator clock.
External clock
When the external signal clock is used as the source oscillation
(f(XIN)), note that the RAM back-up mode (POF and POF2 in-
structions) cannot be used.
23
24
19
20
21
22
相关PDF资料
PDF描述
M34501E4FP 4-BIT, OTPROM, MICROCONTROLLER, PDSO20
M34501M4-XXXFP 4-BIT, MROM, MICROCONTROLLER, PDSO20
M34501E4FP 4-BIT, OTPROM, MICROCONTROLLER, PDSO20
M34502M2-XXXFP 4-BIT, MROM, MICROCONTROLLER, PDSO24
M34502M4-XXXFP 4-BIT, MROM, MICROCONTROLLER, PDSO24
相关代理商/技术参数
参数描述
M34501M4 制造商:MITSUBISHI 制造商全称:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER
M34501M4-XXXFP 制造商:MITSUBISHI 制造商全称:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER
M34502E4 制造商:RENESAS 制造商全称:Renesas Technology Corp 功能描述:SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER
M34502E4FP 制造商:RENESAS 制造商全称:Renesas Technology Corp 功能描述:4-BIT CISC SINGLE-CHIP MICROCOMPUTER 4500 SERIES
M34502M2 制造商:RENESAS 制造商全称:Renesas Technology Corp 功能描述:SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER