参数资料
型号: M34518E8SP
元件分类: 微控制器/微处理器
英文描述: 4-BIT, OTPROM, 6 MHz, MICROCONTROLLER, PDIP32
封装: 8.90 X 28 MM, 1.78 MM PITCH, PLASTIC, SDIP-32
文件页数: 134/162页
文件大小: 1149K
代理商: M34518E8SP
Rev.3.01
2005.06.15
page 71 of 157
REJ03B0008-0301
4518 Group
Stack registers (SKS)
Stack registers (SKs) are eight identical registers, so that subrou-
tines can be nested up to 8 levels. However, one of stack
registers is used respectively when using an interrupt service
routine and when executing a table reference instruction. Accord-
ingly, be careful not to over the stack when performing these
operations together.
10
11
Multifunction
The input/output of P30 and P31 can be used even when INT0
and INT1 are selected.
The input of ports P20–P22 can be used even when SIN, SOUT
and SCK are selected.
The input/output of D6 can be used even when CNTR0 (input) is
selected.
The input of D6 can be used even when CNTR0 (output) is selected.
The input/output of D7 can be used even when CNTR1 (input) is
selected.
The input of D7 can be used even when CNTR1 (output) is selected.
Prescaler
Stop counting and then execute the TABPS instruction to read
from prescaler data.
Stop counting and then execute the TPSAB instruction to set
prescaler data.
Timer count source
Stop timer 1, 2, 3 and 4 counting to change its count source.
Reading the count value
Stop timer 1, 2, 3 or 4 counting and then execute the data read
instruction (TAB1, TAB2, TAB3, TAB4) to read its data.
Writing to the timer
Stop timer 1, 2, 3 or 4 counting and then execute the data write
instruction (T1AB, T2AB, T3AB, T4AB) to write its data.
Writing to reload register R1, R3, R4H
When writing data to reload register R1, reload register R3 or re-
load register R4H while timer 1, timer 3 or timer 4 is operating,
avoid a timing when timer 1, timer 3 or timer 4 underflows.
Timer 4
Avoid a timing when timer 4 underflows to stop timer 4 at the use
of PWM output function.
When “H” interval extension function of the PWM signal is set to
be “valid”, set “1” or more to reload register R4H.
LIST OF PRECAUTIONS
Noise and latch-up prevention
Connect a capacitor on the following condition to prevent noise
and latch-up;
connect a bypass capacitor (approx. 0.1
F) between pins VDD
and VSS at the shortest distance,
equalize its wiring in width and length, and
use relatively thick wire.
In the One Time PROM version, CNVSS pin is also used as VPP
pin. Accordingly, when using this pin, connect this pin to VSS
through a resistor about 5 k
(connect this resistor to CNVSS/
VPP pin as close as possible).
Register initial values 1
The initial value of the following registers are undefined after sys-
tem is released from reset. After system is released from reset,
set initial values.
Register Z (2 bits)
Register D (3 bits)
Register E (8 bits)
Register initial values 2
The initial value of the following registers are undefined at RAM back-
up. After system is returned from RAM back-up, set initial values.
Register Z (2 bits)
Register X (4 bits)
Register Y (4 bits)
Register D (3 bits)
Register E (8 bits)
相关PDF资料
PDF描述
M34518M2-XXXFP 4-BIT, MROM, 6 MHz, MICROCONTROLLER, PQFP32
M34519M6-XXXFP 4-BIT, MROM, 6 MHz, MICROCONTROLLER, PDSO42
M34519M8-XXXFP 4-BIT, MROM, 6 MHz, MICROCONTROLLER, PDSO42
M34519E8FP 4-BIT, OTPROM, 6 MHz, MICROCONTROLLER, PDSO42
M34519M8-XXXFP 4-BIT, MROM, 6 MHz, MICROCONTROLLER, PDSO42
相关代理商/技术参数
参数描述
M34518M2-XXXFP 制造商:RENESAS 制造商全称:Renesas Technology Corp 功能描述:SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER
M34518M2-XXXSP 制造商:RENESAS 制造商全称:Renesas Technology Corp 功能描述:SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER
M34518M4-XXXFP 制造商:RENESAS 制造商全称:Renesas Technology Corp 功能描述:SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER
M34518M4-XXXSP 制造商:RENESAS 制造商全称:Renesas Technology Corp 功能描述:SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER
M34518M6-XXXFP 制造商:RENESAS 制造商全称:Renesas Technology Corp 功能描述:SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER