- 您现在的位置：买卖IC网 > Datasheet目录340 > MAX15018BASA+ (Maxim Integrated Products)IC MOSF DRVR HALF BRDG HS 8-SOIC Datasheet资料下载
参数资料
| 型号： | MAX15018BASA+ |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 8/14页 |
| 文件大小： | 0K |
| 描述： | IC MOSF DRVR HALF BRDG HS 8-SOIC |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 100 |
| 配置： | 半桥 |
| 输入类型： | 反相和非反相 |
| 延迟时间： | 33ns |
| 电流 - 峰： | 3A |
| 配置数： | 1 |
| 输出数： | 2 |
| 高端电压 - 最大（自引导启动）： | 125V |
| 电源电压： | 8 V ~ 12.6 V |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-SOIC（0.154"，3.90mm Width）裸露焊盘 |
| 供应商设备封装： | 8-SOICN 裸露焊盘 |
| 包装： | 管件 |
125V/3A, High-Speed,
Half-Bridge MOSFET Drivers
Detailed Description
The MAX15018A/MAX15018B/MAX15019A/MAX15019B
half-bridge, n-channel MOSFET drivers control high-
and low-side MOSFETs in high-voltage, high peak-cur-
rent applications and offer a high 125V voltage range
that allows ample margin above the 100V transient
specification of telecom standards. These drivers oper-
ate with an IC supply voltage of 8V to 12.6V, and con-
sume only 2.75mA of supply current during typical
switching operations. The MAX15018_/MAX15019_ pro-
vide 3A (typ) sink/source peak current per output and
are capable of operating with large capacitive loads
and with switching frequencies near 1MHz.
These drivers are intended to be used to drive the
high-side MOSFET without requiring an isolation device
such as an optocoupler or a drive transformer. The
high-side driver is controlled by a TTL/CMOS logic sig-
nal referenced to ground and is powered by a boot-
strap circuit formed by an integrated diode and an
external capacitor. Undervoltage lockout (UVLO) pro-
tection is provided for both the high- and low-side dri-
ver supplies (BST and V DD ) and includes a UVLO
hysteresis of 0.5V (typ).
The drivers are independently controlled and feature
exceptionally fast switching times, very short propaga-
tion delays (35ns typ), and matched propagation delay-
times (2ns typ) between drivers, making them ideally
suited for high-frequency applications. Internal logic cir-
cuitry prevents shoot-through during output state
changes and minimizes package power dissipation.
These devices are available with CMOS (V DD /2) or TTL
logic-level inputs. The MAX15018A/MAX15018B accept
CMOS input logic levels, while the MAX15019A/
MAX15019B accept TTL input logic levels. For both ver-
sions, the logic inputs are protected against voltage
spikes up to +15V, regardless of V DD . See the Driver
Logic Inputs (IN_H, IN_L) section.
The MAX15018_/MAX15019_ are available with both
high-side and low-side noninverting logic inputs or with
noninverting high-side and inverting low-side logic inputs.
See the Functional Diagrams and Selector Guide. The
MAX15018A and MAX15019A are pin-for-pin replace-
ments for the HIP2100IB and HIP2101IB, respectively.
The MAX15018_/MAX15019_ are available in a space-
saving, high-power, 8-pin SO-EP package that can dissi-
pate up to 1.95W at +70°C. All devices operate over the
-40°C to +125°C automotive temperature range.
Undervoltage Lockout
Both the high- and low-side drivers feature separate
UVLO protection that monitors each driver’s input sup-
ply voltage (BST and V DD ). The low-side driver UVLO
threshold (V DD_UVLO ) is referenced to GND and pulls
both driver outputs low when V DD falls below 7.3V (typ).
The high-side driver UVLO threshold (V BST_UVLO ) is ref-
erenced to HS, and only pulls DH low when V BST falls
below 6.9V (typ) with respect to HS. After the IC is first
energized, and once V DD rises above its UVLO thresh-
old, DL starts switching and either follows the IN_L logic
input (MAX15018A/MAX15019A) or is inverted with refer-
ence to the IN_L logic input (MAX15018B/
MAX15019B). At this time, the bootstrap capacitor is not
charged, and DH does not switch since the BST-to-HS
voltage is below V BST_UVLO . Within a short time follow-
ing engagement of low-side switching, C BST charges
through V DD and causes V BST to exceed V BST_UVLO .
DH then starts switching and follows IN_H. For synchro-
nous buck and half-bridge converter topologies, the
bootstrap capacitor can charge up in one cycle. Normal
operation then begins in a few microseconds after the
BST-to-HS voltage exceeds V BST_UVLO . In the two-
switch forward topology, C BST takes more time (a few
hundred microseconds) to charge and increase its volt-
age above V BST_UVLO . The typical hysteresis for both
UVLO thresholds is 0.5V. The bootstrap capacitor value
should be selected carefully to avoid oscillations during
turn-on and turn-off at the DH output. Choose a capaci-
tor value 20 times greater than the total gate capaci-
tance of the MOSFET. Use a low ESR-type X7R
dielectric ceramic capacitor at BST (typically a 0.1μF
ceramic is adequate) and a parallel combination of 1μF
and 0.1μF ceramic capacitors from V DD to GND. The
high-side MOSFET’s continuous on-time is limited due
to the charge loss from the high-side driver’s quiescent
current. The maximum on-time is dependent on the size
of C BST , I BST (190μA, max), and V BST_UVLO .
8
_______________________________________________________________________________________
相关PDF资料 |
PDF描述 |
|---|---|
| MAX15022EVKIT+ | KIT EVAL FOR MAX15022 |
| MAX15025EATB+T | IC GATE DRVR 2CH 16NS 10TDFN-EP |
| MAX15053EVKIT+ | BOARD EVAL FOR MAX15053 |
| MAX15054AUT+T | IC MOSFET DVR HIGH SIDE SOT-23-6 |
| MAX15070BEUT+T | IC MOSFET DRIVER HNM LL SOT23-6 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX15018BASA+ | 功能描述:功率驱动器IC 125V/3A High-Speed Half-B MOSFET Drvr RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube |
| MAX15018BASA+T | 功能描述:功率驱动器IC 125V/3A High-Speed Half-B MOSFET Drvr RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube |
| MAX15019AASA+ | 功能描述:功率驱动器IC 125V/3A High-Speed Half-B MOSFET Drvr RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube |
| MAX15019AASA+T | 功能描述:功率驱动器IC 125V/3A High-Speed Half-B MOSFET Drvr RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube |
| MAX15019BASA+ | 功能描述:功率驱动器IC 125V/3A High-Speed Half-B MOSFET Drvr RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube |
发布紧急采购，3分钟左右您将得到回复。