- 您现在的位置：买卖IC网 > PDF目录16702 > MAX1533AETJ+T (Maxim Integrated Products)IC POWER SUPPLY CONTROLER 32TQFN PDF资料下载
参数资料
| 型号： | MAX1533AETJ+T |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 18/38页 |
| 文件大小： | 0K |
| 描述： | IC POWER SUPPLY CONTROLER 32TQFN |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 2,500 |
| 应用： | 电源控制器 |
| 输入电压： | 4.5 V ~ 26 V |
| 电流 - 电源： | 15µA |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 32-WFQFN 裸露焊盘 |
| 供应商设备封装： | 32-TQFN-EP（5x5） |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页当前第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页
High-Efficiency, 5x Output, Main Power-Supply
Controllers for Notebook Computers
SMPS to LDO Bootstrap Switchover
When the 5V main output voltage is above the LDO5
bootstrap-switchover threshold, an internal 0.75 Ω (typ)
p-channel MOSFET shorts CSL5 to LDO5 while simulta-
neously shutting down the LDO5 linear regulator.
Similarly, when the 3.3V main output voltage is above
the LDO3 bootstrap-switchover threshold, an internal
1 Ω (typ) p-channel MOSFET shorts CSL3 to LDO3 while
simultaneously shutting down the LDO3 linear regula-
tor. These actions bootstrap the device, powering the
internal circuitry and external loads from the output
SMPS voltages, rather than through linear regulators
from the battery. Bootstrapping reduces power dissipa-
tion due to gate charge and quiescent losses by pro-
viding power from a 90%-efficient switch-mode source,
rather than from a much-less-efficient linear regulator.
The output current limit increases to 200mA when the
LDO_ outputs are switched over.
SMPS 5V Bias Supply (LDO5 and V CC )
The A switch-mode power supplies (SMPS) require a
5V bias supply in addition to the high-power input sup-
ply (battery or AC adapter). This 5V bias supply is gen-
erated by the MAX1533A/MAX1537As’ internal 5V linear
regulator (LDO5). This bootstrapped LDO allows the
MAX1533A/MAX1537A to power-up independently. The
gate-driver input supply is connected to the fixed 5V
linear-regulator output (LDO5). Therefore, the 5V LDO
supply must provide V CC (PWM controller) and the
gate-drive power, so the maximum supply current
required is:
I BIAS = I CC + f SW (Q G(LOW) + Q G(HIGH) )
= 5mA to 50mA (typ)
where I CC is 1mA (typ), f SW is the switching frequency,
and Q G(LOW) and Q G(HIGH) are the MOSFET data
sheet’s total gate-charge specification limits at V GS = 5V.
Reference (REF)
The 2V reference is accurate to ±1% over temperature
and load, making REF useful as a precision system ref-
erence. Bypass REF to GND with a 0.22μF or greater
ceramic capacitor. The reference sources up to 100μA
and sinks 10μA to support external loads. If highly
accurate specifications ( ± 0.5%) are required for the
main SMPS output voltages, the reference should not
be loaded. Loading the reference reduces the LDO5,
LDO3, OUT5, and OUT3 output voltages slightly
because of the reference load-regulation error.
System Enable/Shutdown ( SHDN )
Drive SHDN below the precise SHDN input falling-edge
trip level to place the MAX1533A/MAX1537A in their
low-power shutdown state. The MAX1533A/MAX1537A
consume only 5μA of quiescent current while in shut-
down mode. When shutdown mode activates, the refer-
ence turns off, making the threshold to exit shutdown
less accurate. To guarantee startup, drive SHDN above
2.2V ( SHDN input rising-edge trip level). For automatic
shutdown and startup, connect SHDN to V IN . The accu-
rate 1V falling-edge threshold on SHDN can be used to
detect a specific input-voltage level and shut the
device down. Once in shutdown, the 1.6V rising-edge
threshold activates, providing sufficient hysteresis for
most applications.
SMPS Detailed
Description
SMPS POR, UVLO, and Soft-Start
Power-on reset (POR) occurs when V CC rises above
approximately 1V, resetting the undervoltage, overvolt-
age, and thermal-shutdown fault latches. The POR cir-
cuit also ensures that the low-side drivers are pulled
low if OVP is disabled ( OVP = V CC ), or driven high if
OVP is enabled ( OVP = GND) until the SMPS con-
trollers are activated.
The V CC input undervoltage-lockout (UVLO) circuitry
inhibits switching if the 5V bias supply (LDO5) is below
the 4V input UVLO threshold. Once the 5V bias supply
(LDO5) rises above this input UVLO threshold and the
controllers are enabled, the SMPS controllers start
switching and the output voltages begin to ramp up
using soft-start.
The internal digital soft-start gradually increases the
internal current-limit level during startup to reduce the
input surge currents. The MAX1533A/MAX1537A divide
the soft-start period into five phases. During the first
phase, each controller limits its current limit to only 20%
of its full current limit. If the output does not reach regu-
lation within 128 clock cycles (1/f OSC ), soft-start enters
the second phase and the current limit is increased by
another 20%. This process repeats until the maximum
current limit is reached after 512 clock cycles (1/f OSC )
or when the output reaches the nominal regulation volt-
age, whichever occurs first (see the startup waveforms
in the Typical Operating Characteristics).
18
______________________________________________________________________________________
相关PDF资料 |
PDF描述 |
|---|---|
| REC5-2409DRW/H6/C | CONV DC/DC 5W 18-36VIN +/-09VOUT |
| V375C36T75BL3 | CONVERTER MOD DC/DC 36V 75W |
| RBM24DSXS | CONN EDGECARD 48POS DIP .156 SLD |
| GBM18DRST | CONN EDGECARD 36POS DIP .156 SLD |
| V72C15E150BL3 | CONVERTER MOD DC/DC 15V 150W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX1533ETJ | 功能描述:电流和电力监控器、调节器 RoHS:否 制造商:STMicroelectronics 产品:Current Regulators 电源电压-最大:48 V 电源电压-最小:5.5 V 工作温度范围:- 40 C to + 150 C 安装风格:SMD/SMT 封装 / 箱体:HPSO-8 封装:Reel |
| MAX1533ETJ+ | 功能描述:电流和电力监控器、调节器 PS Controllers for for Notebooks RoHS:否 制造商:STMicroelectronics 产品:Current Regulators 电源电压-最大:48 V 电源电压-最小:5.5 V 工作温度范围:- 40 C to + 150 C 安装风格:SMD/SMT 封装 / 箱体:HPSO-8 封装:Reel |
| MAX1533ETJ+T | 功能描述:电流和电力监控器、调节器 PS Controllers for for Notebooks RoHS:否 制造商:STMicroelectronics 产品:Current Regulators 电源电压-最大:48 V 电源电压-最小:5.5 V 工作温度范围:- 40 C to + 150 C 安装风格:SMD/SMT 封装 / 箱体:HPSO-8 封装:Reel |
| MAX1533ETJ-T | 功能描述:电流和电力监控器、调节器 RoHS:否 制造商:STMicroelectronics 产品:Current Regulators 电源电压-最大:48 V 电源电压-最小:5.5 V 工作温度范围:- 40 C to + 150 C 安装风格:SMD/SMT 封装 / 箱体:HPSO-8 封装:Reel |
| MAX1533EVKIT | 功能描述:电流和电力监控器、调节器 Evaluation Kit for the MAX1533 RoHS:否 制造商:STMicroelectronics 产品:Current Regulators 电源电压-最大:48 V 电源电压-最小:5.5 V 工作温度范围:- 40 C to + 150 C 安装风格:SMD/SMT 封装 / 箱体:HPSO-8 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。