- 您现在的位置：买卖IC网 > PDF目录1839 > MAX1717EEG+ (Maxim Integrated Products)IC REG CTRLR BUCK PWM CM 24-QSOP PDF资料下载
参数资料
| 型号： | MAX1717EEG+ |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 16/33页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM CM 24-QSOP |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 50 |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 频率 - 最大： | 1MHz |
| 占空比： | 100% |
| 电源电压： | 4.5 V ~ 5.5 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 24-SSOP（0.154"，3.90mm 宽） |
| 包装： | 管件 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页当前第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页
Dynamically Adjustable, Synchronous
Step-Down Controller for Notebook CPUs
The dead-time effect increases the effective on-time,
reducing the switching frequency. It occurs only in
PWM mode (SKP/ SDN = open) and dynamic output
voltage transitions when the inductor current reverses
at light or negative load currents. With reversed inductor
current, the inductor’s EMF causes LX to go high earlier
than normal, extending the on-time by a period equal to
the DH-rising dead time.
For loads above the critical conduction point, where the
dead-time effect is no longer a factor, the actual switching
frequency is:
f = (V OUT + V DROP1 ) / t ON (V IN + V DROP1 - V DROP2 )
where V DROP1 is the sum of the parasitic voltage drops
in the inductor discharge path, including synchronous
rectifier, inductor, and PC board resistances; V DROP2 is
the sum of the parasitic voltage drops in the inductor
charge path, including high-side switch, inductor, and
PC board resistances; t ON is the on-time calculated by
the MAX1717.
Integrator Amplifiers
Three integrator amplifiers provide a fine adjustment to
the output regulation point. One amplifier integrates the
difference between GNDS and GND, a second inte-
grates the difference between FBS and FB. The third
amplifier integrates the difference between REF and the
DAC output. These three transconductance amplifiers’
outputs are directly summed inside the chip, so the
integration time constant can be set easily with one
capacitor. The g m of each amplifier is 160μS (typ).
The integrator block has the ability to lower the output
voltage by 2% and raise it by 6%. For each amplifier, the
differential input voltage range is at least ±70mV total,
including DC offset and AC ripple. The integrator corrects
for approximately 90% of the total error, due to finite gain.
The FBS amplifier corrects for DC voltage drops in PC
board traces and connectors in the output bus path
between the DC-DC converter and the load. The GNDS
amplifier performs a similar DC correction task for the
output ground bus. The third integrator amplifier cor-
rects the small offset of the error amplifier and provides
an averaging function that forces V OUT to be regulated
at the average value of the output ripple waveform.
Integrators have both beneficial and detrimental char-
acteristics. Although they correct for drops due to DC
bus resistance and tighten the DC output voltage toler-
ance limits by averaging the peak-to-peak output ripple,
they can interfere with achieving the fastest possible
load-transient response. The fastest transient response
is achieved when all three integrators are disabled.
This can work very well if the MAX1717 circuit is placed
very close to the CPU.
All three integrators can be disabled by connecting
FBS to V CC . When the integrators are disabled, CC can
be left unconnected, which eliminates a component,
but leaves GNDS connected to any convenient ground.
When the inductor is in continuous conduction, the output
voltage will have a DC regulation higher than the trip
level by 50% of the ripple. In discontinuous conduction
(SKP/ SDN open, light-loaded), the output voltage will
have a DC regulation higher than the trip level by
approximately 1.5% due to slope compensation.
There is often a connector, or at least many milliohms of
PC board trace resistance, between the DC-DC con-
verter and the CPU. In these cases, the best strategy is
to place most of the bulk bypass capacitors close to
the CPU, with just one capacitor on the other side of the
connector near the MAX1717 to control ripple if the
CPU card is unplugged. In this situation, the remote-
sense lines (GNDS and FBS) and integrators provide a
real benefit.
When operating the MAX1717 in a voltage-positioned
circuit (Figure 3), GNDS can be offset with a resistor
divider from REF to GND, which causes the GNDS inte-
grator to increase the output voltage by 90% of the
applied offset (27mV typ). A low-value (5m Ω typ) voltage-
positioning resistor is added in series between the
external inductor and the output capacitor. FBS is con-
nected to FB directly at the junction of the external
inductor and the voltage-positioning resistor. The net
effect of these two changes is an output voltage that is
slightly higher than the programmed DAC voltage at
light loads, and slightly less than the DAC voltage at
full-load current. For further information on voltage-posi-
tioning, see the Applications section.
Automatic Pulse-Skipping Switchover
In skip mode (SKP/ SDN high), an inherent automatic
switchover to PFM takes place at light loads (Figure 4).
This switchover is effected by a comparator that trun-
cates the low-side switch on-time at the inductor current’s
zero crossing. This mechanism causes the threshold
between pulse-skipping PFM and nonskipping PWM
operation to coincide with the boundary between con-
tinuous and discontinuous inductor-current operation
(see the Continuous-to-Discontinuous Inductor Current
Point graph in the Typical Operating Characteristics ).
16
______________________________________________________________________________________
相关PDF资料 |
PDF描述 |
|---|---|
| MAX1720EUT | IC REG SWITCHD CAP INV ADJ 6TSOP |
| MAX1721EUT-T | IC REG SWITCHED CAP INV SOT23-6 |
| MAX1724EZK50-T | IC REG BST SYNC 5V .15A TSOT23-5 |
| MAX1725EUK+T | IC REG LDO ADJ 20MA SOT23-5 |
| MAX1729EUB | IC REG BUCK BST ADJ 2.5MA 10UMAX |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX1717EEG+ | 功能描述:DC/DC 开关控制器 Adj Synchronous Step-Down RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
| MAX1717EEG+C71058 | 功能描述:DC/DC 开关控制器 Step-Down Controller for Notebook CPU RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
| MAX1717EEG+T | 功能描述:DC/DC 开关控制器 Adj Synchronous Step-Down RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
| MAX1717EEG-C71058 | 制造商:Rochester Electronics LLC 功能描述: 制造商:Maxim Integrated Products 功能描述: |
| MAX1717EEG-T | 功能描述:DC/DC 开关控制器 RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
发布紧急采购，3分钟左右您将得到回复。