参数资料
型号: MAX1717EEG+
厂商: Maxim Integrated Products
文件页数: 22/33页
文件大小: 0K
描述: IC REG CTRLR BUCK PWM CM 24-QSOP
产品培训模块: Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program
标准包装: 50
PWM 型: 电流模式
输出数: 1
频率 - 最大: 1MHz
占空比: 100%
电源电压: 4.5 V ~ 5.5 V
降压:
升压:
回扫:
反相:
倍增器:
除法器:
Cuk:
隔离:
工作温度: -40°C ~ 85°C
封装/外壳: 24-SSOP(0.154",3.90mm 宽)
包装: 管件
Dynamically Adjustable, Synchronous
Step-Down Controller for Notebook CPUs
2.7V TO 5.5V
1k Ω
1k Ω
100k Ω
D4
D3
D2
D1
D0
MAX1717
A/B
1k Ω
1k Ω
A/B = LOW = 1.60V
A/B = HIGH = 1.35V
NOTE: USE PULLUP FOR A-MODE 1, PULLDOWN FOR A-MODE 0.
USE ≥ 100k Ω FOR B-MODE 1, ≤ 1k Ω FOR B-MODE 0.
Figure 9. Using the Internal Mux with Both VID Codes Resistor Programmed
Output Voltage Transition Timing
The MAX1717 is designed to perform output voltage
transitions in a controlled manner, automatically mini-
mizing input surge currents. This feature allows the cir-
cuit designer to achieve nearly ideal transitions,
guaranteeing just-in-time arrival at the new output volt-
age level with the lowest possible peak currents for a
given output capacitance. This makes the IC very suit-
able for CPUs featuring SpeedStep technology and
other ICs that operate in two or more modes with differ-
ent core voltage levels.
Intel’s mobile Pentium III CPU with SpeedStep technol-
ogy operates at two distinct clock frequencies and
requires two distinct core voltages. When transitioning
from one clock frequency to the other, the CPU first
goes into a low-power state, then the output voltage
and clock frequency are changed. The change must
be accomplished in 100μs or the system may halt.
At the beginning of an output voltage transition, the
MAX1717 brings the VGATE output low, indicating that
a transition is beginning. VGATE remains low during the
transition and goes high when the slew-rate controller
has set the internal DAC to the final value and one
additional slew-rate clock period has passed. The slew-
rate clock frequency (set by resistor R TIME ) must be set
fast enough to ensure that VGATE goes high within the
allowed 100μs. Alternatively, the slew-rate clock can be
set faster than necessary and VGATE’s rising edge can
be detected so that normal system operation can
resume even earlier.
The output voltage transition is performed in 25mV
steps, preceded by a 4μs delay and followed by one
additional clock period after which VGATE goes high if
the output voltage is in regulation. The total time for a
transition depends on R TIME , the voltage difference,
and the accuracy of the MAX1717’s slew-rate clock,
and is not dependent on the total output capacitance.
The greater the output capacitance, the higher the
surge current required for the transition. The MAX1717
will automatically control the current to the minimum
level required to complete the transition in the calculat-
ed time, as long as the surge current is less than the
current limit set by ILIM.
22
______________________________________________________________________________________
相关PDF资料
PDF描述
MAX1720EUT IC REG SWITCHD CAP INV ADJ 6TSOP
MAX1721EUT-T IC REG SWITCHED CAP INV SOT23-6
MAX1724EZK50-T IC REG BST SYNC 5V .15A TSOT23-5
MAX1725EUK+T IC REG LDO ADJ 20MA SOT23-5
MAX1729EUB IC REG BUCK BST ADJ 2.5MA 10UMAX
相关代理商/技术参数
参数描述
MAX1717EEG+ 功能描述:DC/DC 开关控制器 Adj Synchronous Step-Down RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK
MAX1717EEG+C71058 功能描述:DC/DC 开关控制器 Step-Down Controller for Notebook CPU RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK
MAX1717EEG+T 功能描述:DC/DC 开关控制器 Adj Synchronous Step-Down RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK
MAX1717EEG-C71058 制造商:Rochester Electronics LLC 功能描述: 制造商:Maxim Integrated Products 功能描述:
MAX1717EEG-T 功能描述:DC/DC 开关控制器 RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK