- 您现在的位置：买卖IC网 > PDF目录21684 > MAX17410GTM+T (Maxim Integrated)IC CTLR QPWM 2PH FOR IMV 48TQFN PDF资料下载
参数资料
| 型号： | MAX17410GTM+T |
| 厂商： | Maxim Integrated |
| 文件页数： | 36/45页 |
| 文件大小： | 0K |
| 描述： | IC CTLR QPWM 2PH FOR IMV 48TQFN |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 2,500 |
| 系列： | * |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页当前第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页
Dual-Phase, Quick-PWM Controller
for IMVP6+ CPU Core Power Supplies
Power-Up Sequence (POR, UVLO)
The MAX17410 is enabled when SHDN is driven high
(Figure 9). The reference powers up first. Once the refer-
ence exceeds its undervoltage lockout threshold, the inter-
nal analog blocks are turned on and masked by a 150μs
one-shot delay. The PWM controller then begins switching.
Power-on reset (POR) occurs when V CC rises above
approximately 2V, resetting the fault latch and preparing
the controller for operation. The V CC undervoltage lock-
out (UVLO) circuitry inhibits switching until V CC rises
above 4.25V. The controller powers up the reference
once the system enables the controller, V CC above
4.25V and SHDN driven high. With the reference in reg-
ulation, the controller ramps the output voltage to the
boot voltage (1.2V) at 1/8th the slew rate set by R TIME :
current limit, so full output current is available immedi-
ately. CLKEN is pulled low approximately 60μs after the
MAX17410 reaches the boot voltage. At the same time,
the MAX17410 slews the output to the voltage set at the
VID inputs at the programmed slew rate. PWRGD and
PHASEGD becomes high impedance approximately
5ms after CLKEN is pulled low. The MAX17410 auto-
matically uses forced-PWM operation during soft-start
and soft-shutdown, regardless of the DPRSLPVR and
PSI configuration.
For automatic startup, the battery voltage should be
present before V CC . If the controller attempts to bring
the output into regulation without the battery voltage
present, the fault latch trips. The controller remains shut
down until the fault latch is cleared by toggling SHDN
t TRAN ( START ) =
8 V BOOT
( dV TARGET / dt )
or cycling the V CC power supply below 0.5V.
If the V CC voltage drops below 4.25V, the controller
assumes that there is not enough supply voltage to
make valid decisions. To protect the output from over-
where dV TARGET /dt = 12.5mV/μs x 71.5k Ω /R TIME is the
slew rate. The soft-start circuitry does not use a variable
V CC
SHDN
voltage faults, the controller shuts down immediately
and forces a high-impedance output.
VID (D0–D6)
SOFT-START =
1/8 SLEW RATE SET BY R TIME
V CORE
INVALID CODE
INVALID CODE
SOFT-SHUTDOWN =
1/8 SLEW RATE SET BY R TIME
INTERNAL
PWM CONTROL
SKIP
FORCED-PWM
FORCED-PWM
PHASEGD
CLKEN
PWRGD
t BLANK
t BLANK
60 μ s TYP
5ms TYP
t BLANK
20 μ s TYP
Figure 9. Power-Up and Shutdown Sequence Timing Diagram
t BLANK
20 μ s TYP
36
______________________________________________________________________________________
相关PDF资料 |
PDF描述 |
|---|---|
| BAV99W,115 | DIODE ARRAY 100V 130MA SOT323 |
| ATS049B | CRYSTAL 4.9152 MHZ 18PF |
| ATS221B | CRYSTAL 22.1184 MHZ 18 PF FUND |
| ATS20A | CRYSTAL 20.0 MHZ 20 PF FUND |
| ATS073B | CRYSTAL 7.3728 MHZ 18 PF FUND |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX17411GTM+ | 功能描述:电流型 PWM 控制器 IMVP7 CPU & Graphics Controller RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
| MAX17411GTM+T | 功能描述:电流型 PWM 控制器 IMVP7 CPU & Graphics Controller RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
| MAX17411RGTM+ | 功能描述:电流型 PWM 控制器 RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
| MAX17411RGTM+T | 功能描述:电流型 PWM 控制器 RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
| MAX17411RGTM+TW | 功能描述:电流型 PWM 控制器 RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
发布紧急采购，3分钟左右您将得到回复。