收藏本站
参数资料
型号： MC68HC705JJ7S
厂商： FREESCALE SEMICONDUCTOR INC
元件分类： 微控制器/微处理器
英文描述： 8-BIT, UVPROM, 2.1 MHz, MICROCONTROLLER, CDIP20
封装： WINDOWED, CERAMIC, DIP-20
文件页数： 158/164页
文件大小： 1165K
代理商： MC68HC705JJ7S
Current Source Features
MC68HC705JJ7 MC68HC705JP7 Advance Information Data Sheet, Rev. 4.1
Freescale Semiconductor
93
8.7.2 Voltage Comparator 2
Voltage comparator 2 can be used as a simple comparator if its charge current source and discharge
device are disabled by clearing the ISEN bit in the ACR. If the ISEN bit is set, the internal ramp discharge
device connected to PB0/AN0 may become active and try to pull down any voltage source that may be
connected to that pin. Also, since voltage comparator 2 is always connected to two of the port B I/O pins,
these pins should be configured as inputs and have their software programmable pulldowns disabled.
8.8 Current Source Features
The internal current source connected to the PB0/AN0 pin supplies about 100
A of current when the
discharge device is disabled and the current source is active. Therefore, this current source can be used
in an application if the ISEN enable bit is set to power up the current source and by setting the A/D
conversion method to manual mode 0 (ATD1 and ATD2 cleared) and the charge current enabled (CHG
set).
8.9 Internal Temperature Sensing Diode Features
An internal diode is forward biased to VSS and will have its voltage change, VD, for each degree
centigrade rise in the temperature of the device. This temperature sensing diode is powered up from a
current source only during the time that the diode is selected. When on, this current source typically adds
about 30
A to the IDD current.
The temperature sensing diode can be selected by setting both the HOLD and DHOLD bits in the AMUX
register (see 8.2 Analog Multiplex Register).
8.10 Sample and Hold
When using the internal sample capacitor to capture a voltage for later conversion, the HOLD or DHOLD
bit must be cleared first before changing any channel selection. If both the HOLD (or DHOLD) bit and the
channel selection are changed on the same write cycle, the sample may be corrupted during the switching
transitions.
NOTE
The sample capacitor can be affected by excessive noise created with
respect to the device’s VSS pin such that it may appear to leak down or
charge up depending on the voltage level stored on the sample capacitor.
It is recommended to avoid switching large currents through the port pins
while a voltage is to remain stored on the sample capacitor.
The additional option of adding an offset voltage to the bottom of the sample capacitor allows unknown
voltages near VSS to be sampled and then shifted up past the comparator offset and the device offset
caused by a single VSS return pin. This offset also provides a means to measure the internal VSS level
regardless of the comparator offset to determine NOFF as described in 8.6 Voltage Measurement
Methods. In either case the OPT bit must be set in the COPR located at $1FF0 as in Figure 8-12 and the
VOFF bit must be set in the ASR. It is not necessary to switch the VOFF bit during conversions, since the
offset is controlled by the HOLD and DHOLD bits when the VOFF is active. Refer to 8.2 Analog Multiplex
Register for more details on the design and decoding of the sample and hold circuit.
相关PDF资料
PDF描述
MC68HC705K1DWR2 8-BIT, OTPROM, MICROCONTROLLER, PDSO16
MC68HC705K1CP 8-BIT, OTPROM, MICROCONTROLLER, PDIP16
MC68HC705K1P 8-BIT, OTPROM, 2 MHz, MICROCONTROLLER, PDIP16
MC68HC705K1DW 8-BIT, OTPROM, MICROCONTROLLER, PDSO16
MC68HC705KJ1CDW 8-BIT, OTPROM, 4 MHz, MICROCONTROLLER, PDSO16
相关代理商/技术参数
参数描述
MC68HC705JP7CDW 功能描述:IC MCU 8BIT 28-SOIC RoHS:否 类别:集成电路 (IC) >> 嵌入式 - 微控制器， 系列:HC05 其它有关文件:STM32F101T8 View All Specifications 特色产品:STM32 32-bit Cortex MCUs 标准包装:490 系列:STM32 F1 核心处理器:ARM? Cortex?-M3 芯体尺寸:32-位 速度:36MHz 连通性:I²C，IrDA，LIN，SPI，UART/USART 外围设备:DMA，PDR，POR，PVD，PWM，温度传感器，WDT 输入/输出数:26 程序存储器容量:64KB（64K x 8） 程序存储器类型:闪存 EEPROM 大小:- RAM 容量:10K x 8 电压 - 电源 (Vcc/Vdd):2 V ~ 3.6 V 数据转换器:A/D 10x12b 振荡器型:内部 工作温度:-40°C ~ 85°C 封装/外壳:36-VFQFN，36-VFQFPN 包装:托盘 配用:497-10030-ND - STARTER KIT FOR STM32497-8853-ND - BOARD DEMO STM32 UNIV USB-UUSCIKSDKSTM32-PL-ND - KIT IAR KICKSTART STM32 CORTEXM3497-8512-ND - KIT STARTER FOR STM32F10XE MCU497-8505-ND - KIT STARTER FOR STM32F10XE MCU497-8304-ND - KIT STM32 MOTOR DRIVER BLDC497-6438-ND - BOARD EVALUTION FOR STM32 512K497-6289-ND - KIT PERFORMANCE STICK FOR STM32MCBSTM32UME-ND - BOARD EVAL MCBSTM32 + ULINK-MEMCBSTM32U-ND - BOARD EVAL MCBSTM32 + ULINK2更多... 其它名称:497-9032STM32F101T8U6-ND
MC68HC705JP7CP 制造商:Rochester Electronics LLC 功能描述: 制造商:Freescale Semiconductor 功能描述:
MC68HC705K1CDW 制造商:Motorola Inc 功能描述:
MC68HC705KJ1CDW 功能描述:8位微控制器 -MCU 8 Bit 4MHz RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
MC68HC705KJ1CP 功能描述:IC MCU 4MHZ 1.2K OTP 16-DIP RoHS:否 类别:集成电路 (IC) >> 嵌入式 - 微控制器， 系列:HC05 其它有关文件:STM32F101T8 View All Specifications 特色产品:STM32 32-bit Cortex MCUs 标准包装:490 系列:STM32 F1 核心处理器:ARM? Cortex?-M3 芯体尺寸:32-位 速度:36MHz 连通性:I²C，IrDA，LIN，SPI，UART/USART 外围设备:DMA，PDR，POR，PVD，PWM，温度传感器，WDT 输入/输出数:26 程序存储器容量:64KB（64K x 8） 程序存储器类型:闪存 EEPROM 大小:- RAM 容量:10K x 8 电压 - 电源 (Vcc/Vdd):2 V ~ 3.6 V 数据转换器:A/D 10x12b 振荡器型:内部 工作温度:-40°C ~ 85°C 封装/外壳:36-VFQFN，36-VFQFPN 包装:托盘 配用:497-10030-ND - STARTER KIT FOR STM32497-8853-ND - BOARD DEMO STM32 UNIV USB-UUSCIKSDKSTM32-PL-ND - KIT IAR KICKSTART STM32 CORTEXM3497-8512-ND - KIT STARTER FOR STM32F10XE MCU497-8505-ND - KIT STARTER FOR STM32F10XE MCU497-8304-ND - KIT STM32 MOTOR DRIVER BLDC497-6438-ND - BOARD EVALUTION FOR STM32 512K497-6289-ND - KIT PERFORMANCE STICK FOR STM32MCBSTM32UME-ND - BOARD EVAL MCBSTM32 + ULINK-MEMCBSTM32U-ND - BOARD EVAL MCBSTM32 + ULINK2更多... 其它名称:497-9032STM32F101T8U6-ND
发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

*型号 *数量 厂商 批号 封装
添加更多采购

我的联系方式

*
*
*