- 您现在的位置：买卖IC网 > PDF目录80397 > MC68HC705P6ACP (FREESCALE SEMICONDUCTOR INC) 8-BIT, OTPROM, 2.1 MHz, MICROCONTROLLER, PDIP28 PDF资料下载
参数资料
| 型号： | MC68HC705P6ACP |
| 厂商： | FREESCALE SEMICONDUCTOR INC |
| 元件分类： | 微控制器/微处理器 |
| 英文描述： | 8-BIT, OTPROM, 2.1 MHz, MICROCONTROLLER, PDIP28 |
| 封装： | PLASTIC, DIP-28 |
| 文件页数： | 53/98页 |
| 文件大小： | 532K |
| 代理商： | MC68HC705P6ACP |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页当前第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页
MC68HC705P6A Advance Information Data Sheet, Rev. 2.1
Freescale Semiconductor
57
Chapter 10
EPROM
10.1 Introduction
The user EPROM consists of 48 bytes of user page zero EPROM from $0020 to $004F, 4608 bytes of
user EPROM from $0100 to $12FF, the two MOR reset values located at $1EFF and $1F00, and 16 bytes
of user vectors EPROM from $1FF0 to $1FFF. The bootloader ROM and vectors are located from $1F01
to $1FEF.
10.2 EPROM Erasing
NOTE
Only parts packaged in a windowed package may be erased. Others are
one-time programmable and may not be erased by UV exposure.
The MC68HC705P6A can be erased by exposure to a high-intensity ultraviolet (UV) light with a
wavelength of 2537 angstroms. The recommended dose (UV intensity multiplied by exposure time) is
15 Ws/cm2. UV lamps without shortwave filters should be used, and the EPROM device should be
positioned about one inch from the UV lamp. An erased EPROM byte will read as $00.
10.3 EPROM Programming Sequence
The bootloader software goes through a complete write cycle of the EPROM including the MOR. This is
followed by a verify cycle which continually branches in a loop if an error is found. A sample routine to
program a byte of EPROM is shown in Table 10-1.
NOTE
To avoid damage to the MCU, VDD must be applied to the MCU before VPP.
10.4 EPROM Registers
Three registers are associated with the EPROM: the EPROM programming register (EPROG) and the
two mask option registers (MOR). The EPROG register controls the actual programming of the EPROM
bytes and the MOR. The MOR registers control the six mask options found on the ROM version of this
MCU (MC68HC05P6), the EPROM security feature, and eight additional port A interrupt options.
10.5 EPROM Programming Register (EPROG)
This register is used to program the EPROM array. Only the ELAT and EPGM bits are available.
Table 10-1 shows the location of each bit in the EPROG register and the state of these bits coming out of
reset. All the bits in the EPROG register are cleared by reset.
相关PDF资料 |
PDF描述 |
|---|---|
| MC908GR60AMFU | 8-BIT, FLASH, 8 MHz, MICROCONTROLLER, PQFP64 |
| MC908GR60AVFU | 8-BIT, FLASH, 8 MHz, MICROCONTROLLER, PQFP64 |
| MC9S12DG128BCFU | 16-BIT, FLASH, 25 MHz, MICROCONTROLLER, PQFP80 |
| MPE603EFE133TX | 32-BIT, 133.33 MHz, RISC PROCESSOR, CQFP240 |
| MPE603ERX100TX | 32-BIT, 100 MHz, RISC PROCESSOR, CBGA255 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MC68HC705P6ADW | 制造商:Rochester Electronics LLC 功能描述:MCU, 176 BYTES RAM, A/D - Bulk |
| MC68HC705P6AMDW | 功能描述:IC MCU 4.6K OTP 2.1MHZ 28-SOIC RoHS:否 类别:集成电路 (IC) >> 嵌入式 - 微控制器， 系列:HC05 标准包装:250 系列:56F8xxx 核心处理器:56800E 芯体尺寸:16-位 速度:60MHz 连通性:CAN，SCI，SPI 外围设备:POR，PWM，温度传感器，WDT 输入/输出数:21 程序存储器容量:40KB（20K x 16） 程序存储器类型:闪存 EEPROM 大小:- RAM 容量:6K x 16 电压 - 电源 (Vcc/Vdd):2.25 V ~ 3.6 V 数据转换器:A/D 6x12b 振荡器型:内部 工作温度:-40°C ~ 125°C 封装/外壳:48-LQFP 包装:托盘 配用:MC56F8323EVME-ND - BOARD EVALUATION MC56F8323 |
| MC68HC705P6AMP | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| MC68HC705P6CDW | 制造商:Motorola Inc 功能描述: |
| MC68HC705P6CP | 制造商:Freescale Semiconductor 功能描述: 制造商:Motorola Inc 功能描述: |
发布紧急采购，3分钟左右您将得到回复。