参数资料
型号: MTB20N20E
厂商: MOTOROLA INC
元件分类: JFETs
英文描述: TMOS POWER FET 20 AMPERES 200 VOLTS
中文描述: 20 A, 200 V, 0.16 ohm, N-CHANNEL, Si, POWER, MOSFET
文件页数: 5/10页
文件大小: 258K
代理商: MTB20N20E
5
Motorola TMOS Power MOSFET Transistor Device Data
DRAIN–TO–SOURCE DIODE CHARACTERISTICS
0.5
0.6
0.7
0.8
0.9
1.0
0
4
12
16
20
VSD, SOURCE–TO–DRAIN VOLTAGE (VOLTS)
Figure 8. Gate–To–Source and Drain–To–Source
Voltage versus Total Charge
I
Figure 9. Resistive Switching Time
Variation versus Gate Resistance
RG, GATE RESISTANCE (OHMS)
1
10
100
1000
100
10
t
VDD = 30 V
ID = 20 A
VGS = 10 V
TJ = 25
°
C
tr
tf
td(on)
VGS = 0 V
TJ = 25
°
C
Figure 10. Diode Forward Voltage versus Current
180
V
150
120
90
60
30
0
0
10
6
2
0
QG, TOTAL GATE CHARGE (nC)
V
12
8
4
10
20
30
40
60
ID = 20 A
TJ = 25
°
C
VDS
VGS
50
Q1
Q2
Q3
QT
td(off)
8
0.85
0.75
0.65
0.55
0.95
SAFE OPERATING AREA
The Forward Biased Safe Operating Area curves define
the maximum simultaneous drain–to–source voltage and
drain current that a transistor can handle safely when it is for-
ward biased. Curves are based upon maximum peak junc-
tion temperature and a case temperature (TC) of 25
°
C. Peak
repetitive pulsed power limits are determined by using the
thermal response data in conjunction with the procedures
discussed in AN569, “Transient Thermal Resistance–Gener-
al Data and Its Use.”
Switching between the off–state and the on–state may tra-
verse any load line provided neither rated peak current (IDM)
nor rated voltage (VDSS) is exceeded and the transition time
(tr,tf) do not exceed 10
μ
s. In addition the total power aver-
aged over a complete switching cycle must not exceed
(TJ(MAX) – TC)/(R
θ
JC).
A Power MOSFET designated E–FET can be safely used
in switching circuits with unclamped inductive loads. For reli-
able operation, the stored energy from circuit inductance dis-
sipated in the transistor while in avalanche must be less than
the rated limit and adjusted for operating conditions differing
from those specified. Although industry practice is to rate in
terms of energy, avalanche energy capability is not a con-
stant. The energy rating decreases non–linearly with an in-
crease of peak current in avalanche and peak junction
temperature.
Although many E–FETs can withstand the stress of drain–
to–source avalanche at currents up to rated pulsed current
(IDM), the energy rating is specified at rated continuous cur-
rent (ID), in accordance with industry custom. The energy rat-
ing must be derated for temperature as shown in the
accompanying graph (Figure 12). Maximum energy at cur-
rents below rated continuous ID can safely be assumed to
equal the values indicated.
相关PDF资料
PDF描述
MTB2N60E TMOS POWER FET 2.0 AMPERES 600 VOLTS
MTB2P50E TMOS POWER FET 2.0 AMPERES 500 VOLTS
MTB30N06VL TMOS POWER FET 30 AMPERES 60 VOLTS
MTB30P06V TMOS POWER FET 30 AMPERES 60 VOLTS
MTB30P06 TMOS POWER FET 30 AMPERES 60 VOLTS
相关代理商/技术参数
参数描述
MTB20N20ET4 制造商:ON Semiconductor 功能描述:Trans MOSFET N-CH 200V 20A 3-Pin(2+Tab) D2PAK T/R
MTB20SA 制造商:未知厂家 制造商全称:未知厂家 功能描述:Full-Size (7.3mm or 4.7mm height)
MTB20SAM 制造商:未知厂家 制造商全称:未知厂家 功能描述:Full-Size (7.3mm or 4.7mm height)
MTB20SAV 制造商:未知厂家 制造商全称:未知厂家 功能描述:Full-Size (7.3mm or 4.7mm height)
MTB20SAVM 制造商:未知厂家 制造商全称:未知厂家 功能描述:Full-Size (7.3mm or 4.7mm height)