参数资料
型号: MTB30N06VL
厂商: ON SEMICONDUCTOR
元件分类: JFETs
英文描述: 30 A, 60 V, 0.05 ohm, N-CHANNEL, Si, POWER, MOSFET
封装: CASE 418B-03, D2PAK-3
文件页数: 6/10页
文件大小: 259K
代理商: MTB30N06VL
MTB30N06VL
http://onsemi.com
5
VDS
,DRAINT
OSOURCE
VOL
TAGE
(VOL
TS)
V GS
,GA
TET
OSOURCE
VOL
TAGE
(VOL
TS)
DRAINTOSOURCE DIODE CHARACTERISTICS
0.5
0.7
0.95
0.85
0.9
10
VSD, SOURCETODRAIN VOLTAGE (VOLTS)
Figure 8. GateToSource and DrainToSource
Voltage versus Total Charge
I S
,SOURCE
CURRENT
(AMPS)
Figure 9. Resistive Switching Time
Variation versus Gate Resistance
RG, GATE RESISTANCE (OHMS)
1
10
100
t,TIME
(ns)
TJ = 25°C
ID = 30 A
VDD = 30 V
VGS = 5 V
TJ = 25°C
VGS = 0 V
Figure 10. Diode Forward Voltage versus Current
0
QT, TOTAL CHARGE (nC)
510
20
25
15
TJ = 25°C
ID = 30 A
0
15
20
30
1000
100
10
1
2.5
1.5
0.5
0
5
2
1
30
27
24
15
9
3
0
tf
td(off)
td(on)
tr
VGS
Q2
5
Q3
QT
Q1
VDS
1
0.8
0.75
0.55
0.65
0.6
6
12
18
21
3
3.5
4
4.5
25
SAFE OPERATING AREA
The Forward Biased Safe Operating Area curves define
the maximum simultaneous draintosource voltage and
drain current that a transistor can handle safely when it is
forward biased. Curves are based upon maximum peak
junction temperature and a case temperature (TC) of 25°C.
Peak repetitive pulsed power limits are determined by using
the thermal response data in conjunction with the procedures
discussed
in
AN569,
“Transient
Thermal
ResistanceGeneral Data and Its Use.”
Switching between the offstate and the onstate may
traverse any load line provided neither rated peak current
(IDM) nor rated voltage (VDSS) is exceeded and the
transition time (tr,tf) do not exceed 10 μs. In addition the total
power averaged over a complete switching cycle must not
exceed (TJ(MAX) TC)/(RθJC).
A Power MOSFET designated EFET can be safely used
in switching circuits with unclamped inductive loads. For
reliable operation, the stored energy from circuit inductance
dissipated in the transistor while in avalanche must be less
than the rated limit and adjusted for operating conditions
differing from those specified. Although industry practice is
to rate in terms of energy, avalanche energy capability is not
a constant. The energy rating decreases nonlinearly with an
increase of peak current in avalanche and peak junction
temperature.
Although many EFETs can withstand the stress of
draintosource avalanche at currents up to rated pulsed
current (IDM), the energy rating is specified at rated
continuous current (ID), in accordance with industry
custom. The energy rating must be derated for temperature
as shown in the accompanying graph (Figure 12). Maximum
energy at currents below rated continuous ID can safely be
assumed to equal the values indicated.
相关PDF资料
PDF描述
MTB33N10ET4 33 A, 100 V, 0.06 ohm, N-CHANNEL, Si, POWER, MOSFET
MTB33N10E 33 A, 100 V, 0.06 ohm, N-CHANNEL, Si, POWER, MOSFET
MTB33N10ET4 33 A, 100 V, 0.06 ohm, N-CHANNEL, Si, POWER, MOSFET
MTB35N06ZL 35 A, 60 V, 0.026 ohm, N-CHANNEL, Si, POWER, MOSFET
MTB35N06ZLT4 35 A, 60 V, 0.026 ohm, N-CHANNEL, Si, POWER, MOSFET
相关代理商/技术参数
参数描述
MTB30N06VLT4 制造商:ON Semiconductor 功能描述:Trans MOSFET N-CH 60V 30A 3-Pin(2+Tab) D2PAK T/R
MTB30P06 制造商:MOTOROLA 制造商全称:Motorola, Inc 功能描述:TMOS POWER FET 30 AMPERES 60 VOLTS
MTB30P06V 制造商:ON Semiconductor 功能描述:Trans MOSFET P-CH 60V 30A 3-Pin(2+Tab) D2PAK Rail
MTB30P06VG 制造商:ON Semiconductor 功能描述:Trans MOSFET P-CH 60V 30A 3-Pin(2+Tab) D2PAK Rail
MTB30P06VT4 功能描述:MOSFET 60V 30A P-Channel RoHS:否 制造商:STMicroelectronics 晶体管极性:N-Channel 汲极/源极击穿电压:650 V 闸/源击穿电压:25 V 漏极连续电流:130 A 电阻汲极/源极 RDS(导通):0.014 Ohms 配置:Single 最大工作温度: 安装风格:Through Hole 封装 / 箱体:Max247 封装:Tube