- 您现在的位置：买卖IC网 > PDF目录224618 > NX25P16-VSI (WINBOND ELECTRONICS CORP) 16M X 1 FLASH 2.7V PROM, PDSO8 PDF资料下载
参数资料
| 型号： | NX25P16-VSI |
| 厂商： | WINBOND ELECTRONICS CORP |
| 元件分类： | PROM |
| 英文描述： | 16M X 1 FLASH 2.7V PROM, PDSO8 |
| 封装： | 0.208 INCH, SOIC-8 |
| 文件页数： | 20/43页 |
| 文件大小： | 918K |
| 代理商： | NX25P16-VSI |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页当前第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页
W25P80 / W25P16 / W25P32
Publication Release Date: December 11, 2005
- 27 -
Revision J
9.2.15 Read Parameter Page (53h)
The Parameter Page is a 256-byte page of Flash memory that can be used for storing serial numbers,
revision information and configuration data that might typically be stored in an additional Serial
EEPROM memory. Because the Parameter Page is relatively small and separate from the array, the
erase time is significantly shorter than that of a sector erase (see tPE in AC Electrical Characteristics).
This makes it convenient for more frequent updates.
The Read Parameter Page instruction allows one or more bytes of the Parameter page to be read.
The instruction is initiated by driving the /CS pin low and then shifting the instruction code “53h”
followed by a 24-bit address (A23-A0) into the DI pin. Only the lower 8 address bits (A7-A0) are used,
the 16 upper most address bits (A23-A8) are ignored (don’t care). The code and address bits are
latched on the rising edge of the CLK pin. After the address is received, the data byte of the
addressed memory location will be shifted out on the DO pin at the falling edge of CLK with most
significant bit (MSB) first. The address is automatically incremented to the next higher address after
each byte of data is shifted out allowing for a continuous stream of data. When the end of the
Parameter page is reached the address will wrap to the beginning. The Read Parameter Page
instruction is shown in figure 18. If the Read Parameter Page instruction is issued while an Erase,
Program or Write cycle is in process (BUSY=1) the instruction is ignored and will not have any effects
on the current cycle. The Read Parameter Page instruction allows clock rates from D.C. to a
maximum of fR (see AC Electrical Characteristics).
Figure 18. Read Parameter Page Instruction Sequence Diagram
相关PDF资料 |
PDF描述 |
|---|---|
| NX3225SA-100.000M-STD-CSR-3 | QUARTZ CRYSTAL RESONATOR, 100 MHz |
| NX5A0AE01 | MALE, STRAIGHT TWO PART BOARD CONNECTOR, PRESS FIT |
| NX5B0AE01 | MALE, STRAIGHT TWO PART BOARD CONNECTOR, PRESS FIT |
| NX5C0AE01 | MALE, STRAIGHT TWO PART BOARD CONNECTOR, PRESS FIT |
| NX5G0AE01 | MALE, STRAIGHT TWO PART BOARD CONNECTOR, PRESS FIT |
相关代理商/技术参数 |
参数描述 |
|---|---|
| NX25P20 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:1M BIT 2M BIT AND 4M BIT SERIAL FLASH MEMORY WITH 10MHZ SPI |
| NX25P40 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:1M BIT 2M BIT AND 4M BIT SERIAL FLASH MEMORY WITH 10MHZ SPI |
| NX-25TA-CV1 | 制造商:HRS 制造商全称:HRS 功能描述:I/O Card Interface Connectors |
| NX-25TA-CV1(50) | 功能描述:记忆卡连接器 PC CARD FRAME KIT ACCESRY PLUG CVR RoHS:否 制造商:Yamaichi Electronics 产品:Card Connectors 卡类型:microSD 类型: 节距: 方向: 安装风格:SMD/SMT 端接类型: 排数: 触点数量: 电流额定值:0.5 A 电压额定值:50 V |
| NX-25T-BS | 制造商:Hirose 功能描述:234-0074-0-00 EACH |
发布紧急采购，3分钟左右您将得到回复。